Quick start guide
E5812B/E5813B/E5814B/
E1812B/E1813B/E1814B
5.8 GHz cordless telephone/
answering system with
caller ID/call waiting
Telephone base installation
1. Plug the small end of the larger
power adapter into the power jack at
the bottom of the telephone base.
2. Plug the end of the telephone line
cord into the telephone jack at the
bottom of the telephone base.
3. Route cords through
slots.
DSL filter
(Optional for DSL users, see
number four in the note
section, below.)
4. Plug the large end of
the larger power adapter
into an electrical outlet
not controlled by a wall
switch.
Telephone line cord
5. Plug the other end of the telephone
line cord into a telephone jack.
8. You may be able to
make or receive short
calls. For best perform-
ance, place the handset
in the telephone base
to charge for at least 16
hours before first use.
6. Plug the small end of
the smaller power adapter
into the jack on the under-
side of the charger, then
route the cord through the
slot as shown.
7. Plug the large
end of the smaller
power adapter into
an electrical outlet
not controlled by a
wall switch.
NOTES:
1. Use only the power adapter supplied with this product or equivalent. To order a replace-
or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
Quick reference guide
Cordless handset
DIR /VOLUME+
CID/-VOLUME
While in a menu, press to scoll up.
When in idle mode, press to dis-
play directory entries. While enter-
ing names, press to advance the
cursor. During a call, press DIR to
increase listening volume.
While in a menu, press to scoll
down. When in idle mode, press
to display call summary entries.
While entering names or num-
bers, press to move the cursor to
the left. During a call, press CID
to decrease listening volume.
OFF/CLEAR
PHONE/FLASH
During a call, press to hang up.
While using menus, press to
cancel an operation, or exit the
menu.
Press to make or answer a call.
During a call, press to receive
an incoming call if call waiting is
activated.
CHAN/DELETE
MENU/SEL/TRANSFER
When on a call, press CHAN/DELETE
to scan for a clearer channel when
there is static or interference on
the line. When in caller ID mode,
press to delete the displayed call-
er ID entry, or press and hold to
delete all caller ID entries.
Press to display a menu or to con-
firm a command. During a call,
press to transfer a call between
handsets.
MUTE
While on a call, press to mute
microphone. Press again to resume.
SPEAKER
REDIAL/PAUSE
Press to activate handset speak-
erphone. Press again to resume
normal handset use.
While in idle mode, press to display
last number called. While dialing or
entering numbers to the directory,
press to insert a four-second dial-
ing pause.
Feature menu
DIRECTORY
Feature menu
Using menus
DIRECTORY
SPEED DIAL
RINGER
DATE/TIME
DIAL MODE
LANGUAGE
Press CID or DIR
menu items.
to scroll through
Press MENU/SEL to select or modify a
highlighted item.
Press
OFF/CLEAR to cancel an oper-
ation, or exit the menu display.
NOTE: For more information, please refer to the user's manual.
Quick reference guide
Telephone base
CHARGE/IN USE
•
•
Flashes when one of the
handsets is in use.
Flashes when the answer-
ing system is answering an
incoming call.
HANDSET LOCATOR
•
•
Flashes quickly while an
incoming call is ringing.
Press to make the handsets
beep when there is no hand-
set on the telephone base.
On steady when the hand-
set is properly positioned to
charge in the telephone base.
SETUP
ANNC.
Press to review or change
answering system options.
Press to review or record
announcement; press
again to quit.
MESSAGE COUNTER
Number of messages (or
during playback, message
number currently playing).
RECORD
Press to record a memo
or after pressing ANNC.
to record an outgoing
announcement.
CLOCK
Press to review or set clock.
DELETE
Press to delete message
currently playing; press and
hold to delete all old mes-
sages.
ANSWER ON
Press to turn answering
system on or off.
REPEAT
VOLUME
Press to repeat message;
press twice to play previous
message.
Press to adjust playback
volume.
SKIP
PLAY/STOP
Press to skip message.
Press to start or stop mes-
sage playback.
NOTE: For more information, please refer to the user's manual.
© 2007 Advanced American Telephones. All rights reserved.
AT&T and the AT&T logo are trademarks of AT&T Knowledge Ventures,
licensed to Advanced American Telephones. Printed in China. Issue 5 AT&T 06/07.
96-006296-030-100
|