Enclosure Overview
Screw 1
Switch
Screw 2
Addonics
T E C H N O L O G I E S
Power
Connector
Fan
eSATA Port
Removing the front panel
Z USB3.0 / eSATA Combo Drive Enclosure
for SATA or IDE Hard drive or Optical drive
You can remove the front panel of the enclosure to
access the drive drawer of the optical drive.
Model: ZESSIU3CS
Step 1
User’s Guide
Loosen the two screws from the rear panel. Pull out the interior tray from the
enclosure.
Step 2
FCC Warning Statement
A. Installing a 3.5” SATA hard drive
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
SATA hard
drive
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Slide in the 3.5”
SATA hard drive
and secure on the
tray using screws.
Consult a certified television or radio technician
TECHNICAL SUPPORT
Phone:
Hours:
Email:
408-453-6212
8:30 am - 6:00 pm PST
|