ADDONICS TECHNOLOGIES
Model: AD2CFEXC34
Installation Guide
4. This will open up the JMB36X RAID Configurer.
Rebuild Remove
CF slot 2 (CF2)
/ Slave
Power &
drive activity
LED
Create Create
Show
RAID RAID
RAID RAID from Disk
Existing Disk
CF slot 1 (CF1) /
Master
Recommendations on using the AD2CFEXC34
Install the JMB36X RAID Configurer in Windows to create raid
volumes. The JMB36X RAID Configurer will not run when no
devices are attached to the controller.
Supports the following configuration settings
RAID 1 (Mirrored)
BigDrive (JBOD)
individual drive mode
5. Click on the icon to open the wizard for each function.
1. JMB36X RAID Configurer Installation
Note:
To create raid volumes and monitor the status of your
raid set, you need to install the JMB36X RAID
Configurer. Install the utility from the CD that came with
your package.
To Verify Driver Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Look for the following:
a. Turn computer ON. Insert Driver Disk into CDROM.
b. The Addonics Technologies Driver Disk window pops
up.
c. Select Browse CD. Click Driver Download under
ExpressCard / CardBus Adapters. Select
AD2CFEXC34. Extract the files into your system.
d. Install JMB36X RAID Configurer by clicking the
Setup.exe. Follow the instructions.
Windows® 2000/XP/2003:
Double click SCSI and RAID Controller:
-JMicron JMB36X Controller should be displayed
Windows® Vista: Double click Storage controllers:
-JMicron JMB36X Controller should be displayed
e. After software installation, reboot the system.
2. Insert the CF cards into the CF card slots of the
AD2CFEXC34.
3. In Windows, to open the JMB36X RAID Configurer, click on
the system tray the JMicron Icon.
TECHNICAL SUPPORT
Email:
Internet:
Technical Support (8:30 am to 6:00 pm PST)
Phone:
Email:
408 453-6212
|