Bass Speaker System User’s Information
Advice
NOTE:
•
The battery may be run down, preventing the bass system from functioning properly, if you set the speaker
volume too loud for an extended period of time when the engine is at a stop or idling.
•
Never disassemble or modified the speakers or the bass and unit. If there is a problem such as; no sound or an
unusual smell, stop using the bass system immediately and have it inspected and/or repaired by an authorized
Honda dealer. Failure to follow is advise can cause fire or permanent damage.
•
•
Keep the speakers and the bass system dry.
The 5A fuse is applied for this bass system. Use a fuse of the specified capacity for replacement whenever the
fuse is replaced. If the fuse blows immediately after replacing, contact an authorized Honda dealer.
•
•
Lower the volume to a proper level to hear emergency vehicles and other sounds outside the vehicle. Missing the
outside sounds or traffic signals may endanger not only you but also others.
To take the fullest advantage from the speaker and audio unit, maintain an adequate temperature in the cabin.
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
3
Sound Quality Adjustment
The sound quality of this bass system is factory set for the best sound quality adjustment function. However, you can
adjust the sound quality to your preference using the sound quality adjustment function on the audio unit.
•
Note that the sound quality can change depending on the EQ (equalizer) and/or DSP (digital signal processor)
you have set if the audio unit is equipped with these functions. Adjust the sound quality in accordance with your
EQ or DSP.
•
The sound can distort depending on the adjustment position. Adjust the sound quality to a position that does not
cause sound distortion. Operating the audio unit without correcting sound distortion can cause the audio unit to
malfunction.
4
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
For Further Sound Quality/Volume Adjustment
The initial setting is specified in the Installation
Instructions.
Check the minimum and maximum adjustment positions before
adjusting the sound quality/volume.
Turning the adjustment point with force can damage it.
•
•
Use a small phillips screwdriver to adjust.
Check the minimum and maximum adjustment
BASS UNIT
positions before adjusting the sound quality/volume.
•
The sound can distort depending on the adjustment
position. Adjust the sound quality to a position that
does not cause sound distortion.
Note that the initial setting
position differs depending
on a vehicle and audio unit.
5601012T
Frequency bandwidth adjustment
(HIGH CUT)
• Turning the adjustment point
clockwise broadens the
Volume adjustment (GAIN)
• Turning the adjustment
point clockwise increases
the volume.
frequency bandwidth to the
baritone range.
• Turning the adjustment point
counterclockwise to the minimum
position narrows the frequency
bandwidth to the bass range.
• Turning the adjustment
point counterclockwise
decreases the volume.
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
5
Troubleshooting
Symptom
Probable Cause
Remedy
Weak or no sound from the
speakers.
• The volume is set to
minimum level.
• Raise the volume.
• The fader/balance level are • Adjust the fader/balance
not set properly or not set
at the center.
level.
Sounds distort.
• Excessively high sound
volume.
• Lower the sound volume to
an appropriate volume.
• Inappropriately set sound
quality.
• Adjust sound quality on the
audio system side and
GAIN, HIGH CUT on the
bass unit side.
6
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
08B54-SNA-1000-81
© 2005 American Honda Motor Co., Inc - All Rights Reserved. PrintedinJapan
|