Burley Hitch
Alt Adapter
The Burley Hitch Alt Adapter enables use of the standard hitch on bicycle
frames whose dropouts prevent normal installation of the hitch. The Adapter
replaces your non-drive (left) side axle nut and allows the hitch to be installed
without interfering with the dropout.
Burley offers the Alt Adapter in several configurations; check with your
authorized Burley dealer to ensure that you choose the proper configuration
for your bicycle.
Warning! Burley has engineered its hitches and adapters exclusively for use
with Burley trailers. Use of any Burley hitch or adapter on a non-Burley
trailer may result in an accident and serious injury or death.
Quick Release Adapter Installation
Open QR lever on your rear wheel and remove the adjusting nut from the
opposite side (retain cone spring). In order to use the QR Adapter, your QR
lever must be on the drive (right) side of your rear wheel. If necessary, pull
the QR lever and skewer out of the hub and reinsert from the right side of the
rear wheel.
Install the cone springs and thread on the Adapter as shown. Adjust the QR
clamping force by turning the Adapter while holding the QR lever in the open
position. Close the QR lever to secure the rear wheel. When properly
adjusted, the QR lever will leave a clear imprint on the palm of your hand. If
you have any
Cone
spring
Cone
spring
questions
about using
your QR axle,
please consult
your bicycle
manual or
Burley dealer.
Install the standard hitch (included with your Burley trailer) onto the Adapter
and secure with the provided nut. Tighten to 20 N·m (15 ft·lb). It may be
necessary to grip the knurled portion of the Adapter with pliers while
tightening the nut.
Refer to your Burley trailer manual for information on using your Burley hitch.
|