VEC1197_Manual_042506.qxp 4/27/06 9:52 AM Page 4
VEC1197
Sport Lantern
USER’S MANUAL
& WARRANTY INFORMATION
IMPORTANT SAFETY INFORMATION, SAVE THESE INSTRUCTIONS
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.
4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312
Toll Free: (866) 584-5504
www.vectormfg.com
VEC1197_Manual_042506.qxp 4/27/06 9:52 AM Page iv
INTRODUCTION
Thank you for purchasing the VEC1197 Sport Lantern. Please read this guide
carefully before use to ensure optimum performance and to avoid damage to the unit.
FEATURES
• Powerful fluorescent lantern
• Ultra bright 6 LED Auxiliary Light
• Powered by nine (9) “C” dry cell batteries (not included)
• Fold-away Handle/Hanging Hook
• Protective cage
Control and Function Guide
FOLD-AWAY HANDLE/
HANGING HOOK
COMPACT
FLUORESCENT
BULB
6 LED AUXILIARY
LIGHT
(BASE OF LANTERN)
PROTECTIVE
CAGE
AUXILIARY LIGHT
ON/OFF PUSHBUTTON
LANTERN ON/OFF
SWITCH
REMOVABLE
DRY CELL
BATTERY PACK
POWER SUPPLY
The unit is powered by 9 “C” dry cell batteries (not supplied).
Turn the knob (counterclockwise) on the front of the Removable Dry Cell Battery Pack
to open, then insert the batteries prior to use.
Note: Manufacturer strongly recommends using alkaline dry cell batteries in this unit.
CAUTIONS
• When replacing the “C” dry cell batteries: DO NOT mix old and new batteries.
DO NOT mix alkaline, standard (carbon-zinc) and rechargeable (nickel cadmium)
batteries. Always insert batteries correctly with regard to polarity (+ and –), marked
on the battery and the equipment. Remove dead batteries immediately and dispose
of per local codes
• DO NOT dispose of batteries in fire, as this may result in an explosion.
• Keep batteries out of the reach of children.
1
VEC1197_Manual_042506.qxp 4/27/06 9:52 AM Page 2
OPERATING THE LANTERN
CAUTIONS
NEVER grasp the glass bulb directly. It can shatter.
DO NOT TWIST to remove the bulb; it pulls straight out of the socket.
The Lantern is controlled by the Lantern ON/OFF Switch on the front of the unit (see
the “Control and Function Guide” on page 1).
Optional Removable Rechargeable Battery Pack
OPERATING THE 6 LED AUXILIARY LIGHT
The 6 LED Auxiliary Light in the lantern base is controlled by the LED Light ON/OFF
Pushbutton on the front of the unit. (See the “Control and Function Guide” on page 1.)
(Not Supplied)
A Removable, Rechargeable Battery Pack (VEC1198BAT) that installs
directly into the unit’s Battery Compartment (in place of the Dry Cell Battery Pack) is
available for purchase separately. Contact Vector Customer Service toll-free, at (866)
584-5504 to order this part.
CARE AND MAINTENANCE
Cleaning
Over time, dust or fingerprints may accummulate on the Lantern glass. Clean with a
soft, clean, oil-free cloth moistened with household window cleaner. Do not use
alcohol based cleaners on plastic surfaces. This will eventually cause surface clouding.
Note: Never submerge this unit in water or any other liquid.
Replacement Parts
Check unit periodically and discontinue use if parts or accessories are found to be
damaged or defective. To replace worn or defective parts, contact Vector Customer
Service toll-free at (866) 584-5504.
Bulb Replacement
1. Unscrew the top of the Lantern (screws are on the underside of the top lip of the
Lantern). Refer to Figure 1 below.
2. Remove the bulb assembly. Refer to Figure 2 below.
3. Locate the metal spring in the top of the lamp. Refer to Figure 3 below.
4. Grasp the metal spring and the lamp base to remove the bulb. Refer to Figure 4
below.
5. Replace the bulb with a new 9 watt CFL bulb and re-assemble.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
WARNINGS
DO NOT operate any of the unit’s features unless the unit is fully
assembled.
NEVER attempt to operate the Lantern without both the bulb and
housing in place; and only replace the bulb with a new 9 watt CFL
bulb.
2
3
|