Battery installation and charging
Turn the answering system
on or off
Make, answer and end a call
Make a call
Install the battery as shown below. After
installing the battery, you might be able to make
and receive short calls. For best performance,
charge the handset battery for at least 16 hours
before use.
The answering system must be turned on to
answer and record messages.
1. Press
/FLASH or
.
You hear a dial tone.
2. Dial the number.
When the answering system is turned on, the
ANS ON/OFF light on the telephone base will be
on and ANS ON will display on the handset.
Quick start guide
Make a predial call
1. Dial the number.
for models CS6228-3/CS6228-5/
CS6228-6/CS6229/CS6229-2/CS6229-3/
CS6229-4/CS6229-5
1
2
To turn on or off with
the telephone base:
• Press ANS ON/OFF
to turn the answering
system on or off. If the
answering system is
turned on, it announces,
“Calls will be answered.”
If the answering system is
turned off, it announces,
“Calls will not be answered.”
Plug the battery securely
into the plug inside
If the battery
2. Press
/FLASH or
.
compartment cover is on
the handset, press the
indentation and slide the
cover to remove.
the handset battery
compartment, matching
the color-coded label.
Answer a call
Install the telephone base and
charger(s)
Install the telephone base and charger(s) as
shown below.
Press
/FLASH,
or any
of the dialing keys (0-9, #, *).
End a call
Telephone
base power
adapter
Press OFF/CLEAR or put the handset in the
Telephone
wall jack
telephone base or charger.
To turn on or off with a handset:
Charger adapter
If you have DSL
high speed Internet
service, a DSL
filter (not included)
is required.
1. Press MENU/SELECT to show the menu
when the handset is not in use.
2. Press MENU/SELECT to select
4
3
>
ANS. SYSTEM.
Place the battery with
the label THIS SIDE
UP facing up and the
Align the cover flat
against the battery
compartment, then slide
>
3. Press or to select ANS SYS SETUP,
then press MENU/SELECT.
Electrical outlet
not controlled by
a wall switch
4. Press MENU/SELECT to select
wires inside the battery it towards the center of
Telephone
line cord
>
compartment.
the handset until it clicks
into place.
ANSWER ON/OFF.
5. Press or to choose ON or OFF, then
press MENU/SELECT.
Charger
Telephone base
5
Charge the handset by
placing it in the telephone
base or charger. The
CHARGE light
CHARGE light is on when
the handset charges.
1. Use only the power adapter(s) and
battery(ies) supplied with your VTech
telephone.
2. For complete feature instructions, please
refer to your user’s manual.
|