DECT1820
EXTRA HANDSET
OWNER'S
MANUAL
OWNER'S MANUAL
Installing Your Expansion Handset
Follow these three easy steps to get your new handset ready to
use:
1 Connect the charger.
2 Install the batteries and charge your new handset for 15-20
hours.
3 Register your new handset to the main base.
Step 1:Connect the Charger
1
Connect the AC adapter to the DC IN
jack and to a standard 240V AC wall
outlet.
2
Set the charger on a desk or tabletop.
• Use only the supplied AC
adapter. Do not use other
AC adapter.
• Place the charger close to the AC outlet so that you can
unplug the AC adapter easily.
[2]
Step 2:Install the Batteries and charge your new
handset for 15-20 hours
1 Remove the battery compartment cover. Press down on the
semi-circle indent and slide the cover off.
2 Charge the battery for 15-20 hours before using. To charge the
batteries, place the handset on the charger.
While charging, the symbol scrolls and when the battery is fully
charged, all the bars of the battery symbol will be filled when the
phone is off the cradle.
If the symbol does not appear, reposition the handset in the
charger, ensuring that the charging points contact.
•Use only the Uniden batteries supplied with your phone.
•Recharge your handset on a regular basis by returning
the handset to the charger after each phone call.
Step 3:Register the Handset
YOU NEED TO REGISTER THE DECT1820 TO THE MAIN BASE
BEFORE USE!
For Main Base Models DECT1825, DECT1825+1, DECT1855 and
DECT1855+1, When you register a new handset to your base, you
will be asked to enter the base PIN code.
The pre-set PIN code is 0000. If you wish you can change this
code, see owner's manual for detailed instruction.
Before registering, make sure that you have the base and handset
in front of you. Also, make sure all handsets and the base are in
standby mode.
[3]
On the DECT1820 handset you want to register:
1. Press
menu/ok
to access the main menu.
2. Press up or down key until "Add.Settings" is displayed and
press
menu/ok
.
Press up or down key to display "Register" and press menu/ok
.Press up or down key to select your base number and press
menu/ok
.
On your original base:
Press and hold find handset for approx. 3 seconds until you hear
the registration tone. You are now in ‘registration mode’.
If the base already has the maximum number of handsets (6)
registered to it you will need to de-register one of the existing
handsets before you can register the new handset.
See section below for de-registering handsets.
On the DECT1820 handset:
Enter the base PIN code. Pre-set base PIN code is 0000. You will
hear a confirmation tone when registration is complete.
When in standby mode, the new handset number will be displayed.
The handset will automatically be allocated with the next available
handset number.
If registration is unsuccessful, the display will show Not
Registered and you will need to follow the registration
procedure again.
[4]
If you have more than one handset registered to your base you can
de-register a handset or the bases registered to use. Before de-
registering, make sure all handsets and the base are in standby
mode.
menu/ok
1 Press
to access the main menu.
2 Press up or down key until Add. Settings is displayed and
press
menu/ok
.
menu/ok
3 Press up or down key to display Deregister and press
.
4 Press up or down key to select Handset or Base and pressmenu/ok
.
5 Press up or down key to display the handset or base you want
to de-register and press
menu/ok
.
menu/ok
6 Press up or down key to select Yes and press
.
If the handset has been registered to the base successfully, you
will hear a confirmation tone.
end
7 Press
to exit and return to standby.
• Your phone is GAP compatible, which means you can
register your DECT1820 handset to other DECT
(Digitally enhanced cordless telephone) GAP
compatible bases.
• To Register your handset to another manufacturer's
base. Follow the procedure for registering shown in the
other manufacturer's user guide.
• You can register a DECT1820 handset to up to 4 bases,
e.g. one at work and one at home, and switch between
them.
[5]
Using Your Expansion Handset
Now that your new handset is registered, it can perform all the
same functions as the handsets originally included with your phone.
With your new handset, you can
•
•
Transfer calls between handsets
Use two handsets as 2-way radios in DirectLink (Walkie-Talkie)
mode
•
•
Hold conference calls
Access the integrated answering device or voice mail using
Handset
See the owner's manual that came with your main base for
complete instructions on operating your new expanded phone.
[6]
Battery Information
Low battery alert
If the symbol is displayed on the handset, "Charge Battery"
appears and you hear the low battery tone, you will need to
recharge your handset. We recommend that you place the handset
back on the charger between use to ensure that it is always fully
charged.
Cleaning the battery charging contacts
To maintain a good charge, clean the
charging contacts on the
handset once a month. Dampen a cloth
with plain water. Gently rub
the damp cloth over the charging contacts
until all visible dirt is
removed. Dry the contacts thoroughly
before returning the handset
to the cradle.
Caution: Do not use paint thinner,
benzene, alcohol, or other chemical
products. Doing so may discolor the
surface of the telephone and damage the
finish.
[7]
Quick Guide
Function
Button press
talk
Make a call
, enter number.
talk
Preparatory call
Enter number,
.
Adjust earpiece volume During a call,
or
.
rdl
End a call
Receive a call
Redial
end
talk
Phone rings,
.
talk
rdl
rdl then
or
to display number,
Privacy
During a call,menu/ok and select Mute,
repeat the same step to select
"Un Mute" to resume a call
[8]
menu/ok
Store phonebook
number
thenmenu/ok, select New Entry,
,enter
name,menu/ok , enter number, menu/ok
.
Select Tone,menu/ok , then select Save,menu/ok
.
talk
Dial phonebook number
Handset ringer melody
then
or
,
.
rdl
menu/ok
menu/ok
then
or
to Audio Settings
menu/ok
rdl
rdl
Press
Press
or
or
to Ringer Type
then
to select External,
rdl
Internal, Paging, Alarm, or
Appointmentmenu/ok
.
Press
or
to select the melody,menu/ok
.
rdl
int'com
Make internal call
then
or
to select internal
rdl
handset number,menu/ok or
.
talk
[9]
Warranty
UNIDEN DECT1820 Cordless Phone
Limited One Year Warranty
Note:
Please keep your sales docket as it provides evidence of warranty.
Warrantor: Uniden Australia Pty Limited ABN 58 001 865 498
Uniden New Zealand Limited
Warranty only available in original country of purchase
Elements of Warranty: Uniden warrants to the original retail owner for the duration of
this warranty, its DECT1820 Cordless Phone (hereinafter referred to as the Product) to
be free from defects in materials and craftsmanship with only the limitations or
exclusions set out below.
Warranty Duration: This warranty to the original retail owner only, shall terminate and
be of no further effect ONE (1) Year after the date of original retail sale. This warranty
will be deemed invalid if the product is; (A) Damaged or not maintained as reasonable
and necessary, (B) Modified, altered or used as part of any conversion kits,
subassemblies, or any configurations not sold by Uniden, (C) Improperly installed, (D)
Repaired by someone other than an authorised Uniden Repair Agent for a defect or
malfunction covered by this warranty, (E) Used in conjunction with any equipment or
parts or as part of a system not manufactured by Uniden, (F) Installed, programmed or
serviced by anyone other than an authorised Uniden Repair Agent, or (G) Where the
Serial Number label of the product has been removed or damaged beyond recognition.
Parts Covered: This warranty covers for 1 year, the Handset and Charger Unit only.
Accessories: Batteries, AC adaptor etc are covered for 90 days.
Statement of Remedy: In the event that the product does not conform to this warranty
at any time while this warranty is in effect, the warrantor at its discretion, will repair the
defect or replace the product and return it to you without charge for parts and service.
THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT
OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. THIS
GUARANTEE IS IN ADDITION TO AND DOES NOT AFFECT YOUR RIGHTS UNDER
THE CONSUMER GUARANTEES ACT.
Procedure for obtaining performance or warranty: In the event that the Product
does not conform to this warranty, the Product should be shipped or delivered, freight
prepaid, with evidence of original purchase, (eg. a copy of the sales docket), to the
warrantor at:
UNIDEN AUSTRALIA PTY LTD
Service Division
UNIDEN NEW ZEALAND LTD
Service Division
345 Princes Highway,
Rockdale, NSW 2216
Fax (02) 9599 3278
150 Harris Road, East Tamaki,
Auckland
Fax (09) 274 4253
Customers in other states should ship or deliver the Product freight pre-paid to the
nearest Uniden Authorised Repair Centre. (Contact Uniden for the Warranty Agent
nearest you.)
[10]
© 2005 Uniden Australia Pty Limited/Uniden New Zealand Limited
Printed in China UUZZ01429ZZ(0)
|