SmartPOE/802M
8 Port 10/100 Managed PoE Switch
with 2 Gigabit Combo
Features
Feeds PoE to up to Eight devices!
• System Interface/Performance
– RJ-45 port support Auto MDI/MDI-X Function
– Embedded 8-port PoE inject function
– Store-and-Forward Switching Architecture
– Back-plane (Switching Fabric): 5.6Gbps
– 1Mbits Packet Buffer
– v8K MAC Address Table
• Spanning Tree
– Supports IEEE802.1d Spanning Tree
– Supports IEEE802.1w Rapid Spanning Tree
8 Port 10/100 Managed PoE
Switch with 2 Gigabit Combo
• VLAN
POE-63208T
– Port Based VLAN
– Supports 802.1 Q Tag VLAN
– GVRP
• X-ring
– X-ring, Dual Homing, and Couple Ring Topology
– Provides redundant backup feature and the recovery time
below 300ms
802.3af
Compliant
PART NUMBER
DESCRIPTION
• Port Trunk with LACP
• QoS (Quality of Service)
POE-63208T
8 Port 10/100 Managed PoE
Switch with 2 Gigabit Combo
– Support IEEE 802.1p Class of Service,
– Per port provides 4 priority queues
– Port Base,Tag Base and Type of Service Priority
• Bandwidth Control
The SmartPoE/802M is a multi-port switch that can be used to build
high-performance switched workgroup networks.This switch is a store-
and-forward device that offers low latency for high-speed networking
and features a “store-and-forward “switching scheme.This allows the
switch to auto-learn and store source addresses in an 8K-entry MAC
address table.The SmartPoE/802M is targeted at workgroup,
department or backbone computing environments.The SmartPoE/802M
has eight auto-sensing 10/100Base-TX RJ-45 ports and all ports support
the PoE injector function.The switch as two auto-detected Gigabit
Combo ports for higher connection speed.
– Ingress Packet Filter and Egress Rate Limit
– Broadcast/Multicast Packet Filter Control
• Port Mirror: Monitor traffic in switched networks
– TX Packet only, RX Packet only, Both of TX and RX Packet
• System Event Log
– System Log Server/Client
– SMTP e-mail Alert
• Security
– Port Security : MAC address entries/filter
– IP Security : IP address security management to prevent
unauthorized intruder.
– Login Security: IEEE802.1X/RADIUS
• SNMP Trap
– Device cold start, Authentication failure, X-ring topology
changed, Port Link up/Link down, PoE port events
• IGMP with Query mode for Multi Media Application
• TFTP Firmware Update and System Configure Restore
and Backup
SEE BACK FOR FULL SPECIFICATIONS
908 Canada Court
City of Industry, CA 91748 U.S.A.
Phone: 626.964.7873 or 800.346.6668
Fax: 626.964.7880
Specifications subject to change witAhlol ruigthtns roesteircveed..
©UNICOM 2007. UNICOM is a trademark of UNICOM Electric, Inc.
121807
Printed in U.S.A.
UNILT121107
|