Tekkeon Bluetooth Headset ET1000 User Manual

ET1000  
U S E R G U I D E  
EZTALKER by Tekkeon is a sleek cord-free headset that enables  
comfortable handsfree communication with your mobile phone. EZTALKER  
1000 works with your Bluetooth-ready mobile phone to provide clear,  
high-quality communication.  
Charging EZTALKER  
Before using ezTalker, you must charge the headset for approximately  
two hours. When fully charged, the battery provides up to four hours of  
talk time and up to 168 hours of standby time.  
While using your EZTALKER headset, you can store your mobile phone in  
your pocket, backpack, or briefcasejust about anywhere in close  
proximity that is convenient for you.  
To Charge the Headset  
1. Insert ezTalker into the charging cradle as  
shown.  
2. Plug the charger into the charging jack on  
the right side of the charging cradle.  
Unpacking EZTALKER  
Your ezTalker package includes  
the following:  
3. Plug the charger into a wall outlet. While the  
headset is charging, the amber LED on the  
headset will remain on. When the headset is  
fully charged, the amber LED will turn off.  
Figure 1.  
ezTalker inserted into  
charging cradle  
!
ezTalker Headset  
!
"Charging cradle with belt clip  
Charger  
"
4. Unplug the charger cable from the wall outlet and the charging  
cradle.  
%ezEarhook  
%
ezFit Ring  
BATTERY INDICATION: When the battery is low (less than 10% of  
capacity), the amber LED will flash and you’ll hear a double beep every  
32 seconds.  
'Comfort Pad  
(User guide (not shown)  
'
Getting to Know EZTALKER  
Pairing EZTALKER to Your Mobile Phone  
Pairing is the process of linking the headset with your Bluetooth mobile  
phone. Before using ezTalker with your mobile phone you must pair the  
devices. After this process is complete, you can use the headset only  
with its paired mobile phone. To use ezTalker with a different mobile  
phone, you must repeat the pairing process with the new mobile phone.  
In this case, the headset will no longer work with the original mobile  
phone.  
TALK Button  
Used for turning headset on/off,  
pairing, and making/receiving calls  
Amber and Blue LEDs  
Provides visual indication of headset  
status: power on/off, pairing mode,  
muting mode, charging mode, and low  
battery  
BEFORE YOU PAIR THE HEADSET, ENSURE THAT THE BATTERY IS FULLY CHARGED, AND  
REVIEW THE INSTRUCTIONS IN YOUR MOBILE PHONE USER GUIDE FOR PAIRING YOUR  
MOBILE PHONE TO A BLUETOOTH HEADSET.  
Volume Control  
Used to adjust the speaker volume  
and to mute the microphone  
To Pair the Devices  
1. Turn on the mobile phone and place it within 10 feet of the headset.  
Microphone  
Speaker  
2. Initiate the Bluetooth device-pairing (discovery) feature on the  
mobile phone. Refer to the mobile phone user guide for  
instructions on initiating this feature.  
3. With the headset turned off, press and hold the TALK button  
approximately five seconds, until the blue and amber LEDs flash  
alternately or until you hear the PAIRING tone.  
4. Release the TALK button. The headset is now in Pairing Mode.  
Getting Started  
Before using ezTalker, you must:  
5. Follow the mobile phone prompts, and when prompted for the  
passkey (also called passcode or BT PIN), enter 0000 (the ezTalker  
passkey). When pairing is complete, the headset will be placed in  
Standby Mode, ready to make and receive calls, the amber LED  
will turn off, and the blue LED will flash at two-second intervals.  
Charge ezTalker  
Pair ezTalker to your mobile phone  
Fit ezTalker to your ear  
Power ezTalker  
Directions for each of these activities are provided in the following four  
sections. Once these steps are completed, you will be ready to use  
ezTalker!  
1
 
U S E R G U I D E  
Transferring Calls  
Visual And Audible Indicators  
You can transfer calls from your mobile phone to your headset.  
Two LEDs (blue and amber) indicate the status of the headset, while  
tones heard through the headset provide an audible indication of a  
requested action. Following are descriptions of visual and audible  
indicators provided by your ezTalker headset.  
To Transfer Calls from Your Mobile Phone To The Headset  
1. With the call connected to your mobile phone, press the TALK button  
on your headset.  
Visual Indicators  
LED Status  
Indicates  
Adjusting the Volume  
Blue LED flashes at two-  
second intervals  
Blue and amber LEDs flash  
alternately  
Headset is in standby mode,  
ready to make and receive calls  
Headset is in Pairing Mode  
To Increase the Volume  
1. Press and release the top of the VOLUME  
Amber LED flashes  
Both LEDs are off  
Battery is low  
Headset is off  
Figure 5.  
Volume buttons  
button + to increase the volume one level.  
Repeat until you have reached the desired  
Audible Indicators  
Tone  
Series of tones, increasing in Headset has been turned on.  
pitch  
Series of tones, decreasing  
in pitch  
One long beep and one short Battery is low  
beep every 32 seconds  
Double chime  
level.  
Indicates  
To Decrease the Volume  
1. Press and release the bottom of the VOLUME button - to decrease  
the volume one level. Repeat until you have reached the desired  
level.  
Headset is about to turn off.  
Headset has been put into  
Muting EZTALKER  
You can mute and un-mute the microphone temporarily so that you  
cannot be heard by the connected party.  
Pairing Mode.  
Beeps every four seconds  
Headset is muted.  
To Mute the Headset  
Troubleshooting  
If your headset is not communicating with your mobile phone, ensure  
that the headset is on and charged, and that you have paired the  
headset with your mobile phone.  
1. Press and hold either VOLUME button (+/-) for three seconds. While  
the headset is muted, you will hear a beep every four seconds.  
To Un-Mute the Headset  
1. When the microphone is muted, press and hold either VOLUME  
button (+/-) for three seconds.  
If you encounter poor reception via the headset, verify that you have  
good reception on your mobile phone or move closer to your mobile  
phone. If the reception is still poor, try moving the mobile phone away  
from your body, or to the same side of your body as your headset.  
Storing EZTALKER  
When you’re not using ezTalker, you can store it in the charging cradle.  
If you are in a noisy environment and your mobile phone does not  
accept voice commands, dial the number from the mobile phone keypad  
as the loud background noise may interfere with voice commands.  
3
 
U S E R G U I D E  
FCC Statement for Class B Digital Devices  
Limited Warranty  
This equipment has been tested and found to comply with the limits for a Class B  
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful interference in a residential  
installation. This equipment generates, uses, and can radiate radio frequency  
energy and, if not installed and used in accordance with the instructions, may  
cause harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation. If this  
equipment does cause harmful interference to radio or television reception,  
which can be determined by turning the equipment off and on, the user is  
encouraged to try and correct the interference by one or more of the following  
measures:  
The product enclosed herein is warranted to be free of operational defects for a  
period of one year from the date of purchase. In the event of a defect in operation  
during the warranty period Tekkeon, Inc. will replace the defective product when  
the owner returns all product contents. The limited warranty will be considered  
void if the unit is tampered with, subject to misuse, negligence or accidental  
damage, has been improperly serviced, or if the security seal is removed. This  
warranty is limited to replacement only and shall not cover any other damages. Any  
product returned to Tekkeon, Inc. with no fault found will be returned to the owner  
at the owner’s expense.  
To obtain warranty coverage, please complete and submit the enclosed EzTalker  
registration card.  
Reorient or locate the receiving antenna.  
Disclaimer of Warranties  
Increase the separation between the equipment and receiver.  
Any user of this product does so at the user’s own risk. To the maximum extent  
permitted by applicable law, Tekkeon, Inc. and its suppliers provide the hardware  
and any support services related thereto “as is” and with all faults; and hereby  
disclaim all warranties and conditions, whether express, implied or statutory,  
including, but not limited to implied warranties of merchantability, fitness for a  
particular purpose, non-infringement, lack of negligence or correspondence to  
description, except for those warranties specifically and expressly provided in the  
Limited Warranty.  
Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
This Class B digital apparatus complies with Canadian ICES-003.  
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du  
Canada.  
With respect to the use of this product, in no event shall the company be liable for  
any loss of profit or any other commercial damage, including but not limited to  
special, incidental, consequential and other damages.  
"Operation is subject to the following two conditions: (1) this device may not  
cause interference, and (2) this device must accept any interference, including  
interference that may cause undesired operation of the device."  
Customer Service Information  
Customer service for EzTalker is available at:  
Tekkeon, Inc.  
c/o ezTalker  
3002 Dow Avenue, #218  
Tustin, CA 92780  
888-787-5888 / 714-832-1266  
Tekkeon, Inc. must issue a Return Merchandise Authorization (RMA) number for all  
exchanges or refunds.  
© 2003 Tekkeon, Inc.  
Revision B5  
All Rights Reserved  
4
 

Technicolor Thomson Stereo System CS606 User Manual
Telex Stereo System 841 40 User Manual
Thule Automobile Accessories Kit 202 User Manual
Toshiba Portable Generator VF S11 User Manual
Triarch Indoor Furnishings 75257 14 User Manual
U Line Refrigerator 2275ZWCOL User Manual
Vanguard Heating Gas Heater VMH3000TPSA User Manual
Viking Range CRVDD330R User Manual
Waterpik Technologies Speaker B002BSH2DM User Manual
Weber Gas Grill 55549 User Manual