Targus Universal Remote AMP05US User Manual

Voice Recording  
Presenter  
with  
Laser Pointer  
USER GUIDE  
specifications subject to change without notice.  
© 2006 Targus Group International, Inc. and Targus, Inc.  
AMP05US/ 410-0705-001A  
30  
 
AVOID EXPOSURE--HAZARDOUS ELECTROMAGNETIC RADIATION EMITTED FROM THIS  
APERTURE.  
LASER RADIATION. DO NOT STARE INTO THE BEAM OR VIEW DIRECTLY WITH OPTICAL  
INSTRUMENTS. CLASS 2 LASER PRODUCT.  
NEVER POINT  
A
LASER BEAM INTO  
A
PERSON’S EYES OR VIEW  
A
LASER BEAM  
DIRECTLY, AS PROLONGED EXPOSURE CAN BE HAZARDOUS TO THE EYES.  
MOMENTARY EXPOSURE FROM A LASER POINTER, SUCH AS AN INADVERTENT SWEEP  
OF THE LIGHT ACROSS A PERSON'S EYES, MAY CAUSE TEMPORARY FLASH BLINDNESS  
SIMILAR TO THE EFFECT OF A CAMERA FLASH BULB. ALTHOUGH THIS CONDITION IS  
TEMPORARY, IT CAN BECOME MORE DANGEROUS IF THE EXPOSED PERSON IS  
ENGAGED IN A VISION-CRITICAL ACTIVITY SUCH AS DRIVING.  
CAUTION: ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE  
PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO  
OPERATE THE EQUIPMENT.  
THIS DEVICE AND ITS ANTENNA(S) MUST NOT BE CO-LOCATED OR OPERATING IN  
CONJUNCTION WITH ANY OTHER ANTENNA OR TRANSMITTER.  
YOUR DEVICE CONTAINS A LOW POWER TRANSMITTER. WHEN DEVICE IS TRANSMITTED  
IT SENDS OUT RADIO FREQUENCY (RF) SIGNAL.  
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV  
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.  
SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE  
EQUIPMENT.  
 
2
TARGUS VOICE RECORDING  
PRESENTER WITH LASER  
POINTER  
Introduction  
Congratulations on your purchase of the Targus Voice Recording  
presenter with Laser Pointer. This user’s guide describes how to  
connect the presenter to your computer and its functions. This  
2.4GHz presenter can work up to 50 ft (15m) of operating range and  
provides total control of your PowerPoint presentations with laser  
pointer, volume control, scroller wheel, dark screen button and  
application switch. This presenter is also a voice recorder and has a  
bulit-in SD card reader. Presentations, photos and music files can be  
stored and transferred from a SD memory card to and from your  
notebook.  
List of contents  
• Voice Recording presenter with laser pointer  
USB Receiver (stored inside the presenter)  
2 x AAA batteries  
USB data cable  
Carrying case  
User Guide  
System Requirements  
Hardware  
PC with an Intel® Pentium® processor or equivalent  
USB 1.1 or 2.0 interface  
SD memory card of 256MB minimum is recommended  
(Maximum 1 G SD memory card)  
Operating System  
Windows® 2000/XP  
Windows Vista™  
 
3
Targus Voice Recording presenter with Laser Pointer  
Using the presenter  
F
A
G
H
I
B
C
D
J
K
L
E
M
M
O
P
Q1 / Q2  
R
N
L. Bulit-in SD Card Reader  
M. Connection Button  
N. USB Receiver  
A. Application Switch  
B. Next Page  
C. Laser Button  
D. Microphone (recording)  
E. Laser Pointer  
O. Battery Compartment  
P. USB (mini-B) Cable Connector  
Q1. Voice Recording Button  
Q2. LED indicator: Memory - full  
R. Scroller Wheel  
F. Targus Logo  
Laser pointer indicator light: when light is on  
Battery-low warning light: when LED flashes  
G. Dark Screen / Resume  
H. Slide Show / Esc  
I. Power Switch:  
Presenter <--> Card Reader / Off  
J. Previous Page  
K. Volume Control  
 
4
Targus Voice Recording presenter with Laser Pointer  
Installing the Batteries  
• Before you start, please install the 2 AAA batteries (supplied).  
• Open the battery cover located on the back of the presenter and  
insert the batteries according to the correct polarities.  
• Replace the battery compartment cover.  
Note: It’s not recommended to use rechargeable batteries. For best  
performance use Alkaline batteries.  
Connecting the Receiver  
To connect the receiver to your computer, plug the USB receiver into  
an available USB port on your computer.  
Your computer’s operating system identifies the receiver as a “USB  
Human Interface Device” and begins installing the default driver.  
Follow any on-screen procedures to complete the default driver  
installation.  
Note: This presenter is a plug-n-play device. It should be operating  
once the USB receiver is connected and recognized by the computer.  
Battery Compartment  
 
5
Targus Voice Recording presenter with Laser Pointer  
To Reconnect the Device and the Receiver  
1. Position the Power Switch to “Presenter” mode to turn on the presenter.  
This presenter is a plug and play device and should work once the USB  
receiver is connected to and recognised by the computer. If the device is  
not working or you have recently replaced the batteries, you can try to  
reset the ID code between the receiver and the remote. To do this, do the  
following:  
2. Once the computer has recognised the device. Press the  
connection button on the receiver.  
3. After the connection button is pressed on the receiver, press the  
connection button on the back side of the presenter.  
The devices are paired and ready to use.  
Using the Presenter as a SD memory card reader  
(Type-A) USB tip  
(Type-B) USB tip  
USB data transfer cable  
1. Position the Power switch to “Card Reader / Off” position.  
2. Connect the presenter with the computer using the USB data  
transfer cable provided. Please make sure the mini USB  
connector (Type-B) is connected to the presenter’s USB port and  
the large USB connector (Type-A) is connected to the computer’s  
USB port.  
3. Insert the SD memory card into the presenter’s card slot until it is  
fully inserted.  
The computer will detect the memory card and once detected, the  
memory card is ready for access.  
Note: Please remember to turn the power off (to Card Reader / Off mode) before  
connecting the data cable to the PC for card reader function. For best  
performance please use SD card with minimum of 128MB storage space. Try to  
avoid using mini SD card with adapter. Avoid having a large amount of data  
stored in the SD card. It will delay the loading time for the presenter.  
 
6
Targus Voice Recording presenter with Laser Pointer  
Using the Voice recording function  
This presenter is equipped with a voice recording function. The  
recorded data is stored into the SD memory card.  
1. Turn on the device. Press once and release the “voice record button”  
to start recording. The LED beneath the button will glow red when  
recording is in progress.  
2. Press once and release the “voice record button” to end recording.  
Note: Please note that it will take some time for the card reader to finish process  
voice recording after turning off the recording function. The more data is stored in  
the memory card the longer it will take for the red light to turn off. This is not a  
defect; this is the way card reader operates.Please make sure the record indicator  
LED is off.  
3. Always speak into the microphone positioned above the laser button.  
When the SD card is full, the LED under the recording button will flash twice  
per second and the recording will stop functioning. If the presenter is low in  
battery, the LED under the Targus logo will flash continuously until the power  
is completely out.This is an indication that there’s only enough power for  
approximately 30 minutes (depending on the usage) -- you should replace  
the batteries now.  
To save or download the voice data into the computer  
1. Turn the power off by position the Power Switch to  
“Card Reader / Off” position.  
2. Connect the presenter to the computer using the USB cable  
provided.  
3. Once the computer has recognised the device, you can access the  
SD card by double clicking “My Computer”. There will be a new  
storage device drive showing in this window.  
4. The saved voice data files can be located in “D:\record”  
NOTE: Harddisk drive location may vary depending on number of  
drives installed in the computer.  
 
7
Targus Voice Recording presenter with Laser Pointer  
The voice data files are saved as .WAV format.You can copy the files  
to your computer or delete the files in the SD card.  
To retrieve or playback voice data file from the computer  
Once you have located the voice data file, the recorded data can be  
playback with audio programs that supports .WAV file format. (ie.  
Windows Media Player)  
Safety Measures  
To avoid possible eye damage, never point the presenter’s laser at  
people, especially their faces, or look directly into the presenter’s  
laser beam.  
• Avoid pointing the presenter’s laser beam at a mirror or other highly  
reflective surface.  
• Keep the presenter away from young children.  
• Never view the presenter’s laser beam using telescopic devices, such  
as a microscope or binoculars.  
• Any attempt to disassemble, adjust or repair the presenter may result  
in exposure to laser light or other safety hazards.  
• This is a Class II Laser Product.  
Troubleshooting  
What do I do if the response time of the presenter is slow or  
intermittently stops working?  
• Make sure that the presenter is within 50ft (15 m) of its receiver.  
• Increase the distance between the presenter’s receiver and the base  
units of other wireless devices.  
Turn off any wireless devices and their base units that are near the  
presenter’s receiver.  
• Replace the battery.  
What do I do if voice recording stop functioning?  
• Check the SD card memory status; when the card is full the voice  
recording function will stop working.  
 
8
Targus Voice Recording presenter with Laser Pointer  
Technical Support  
For technical questions, please visit:  
US  
Australia  
Telephone: 1800-641-645  
New Zealand Telephone: 0800-633-222  
Product Registration  
Targus recommends that you register your Targus accessory  
shortly after purchasing it. Go to:  
provide your full name, email address, phone number, and  
company information (if applicable).  
Warranty  
Targus warrants this product to be free from defects in materi-  
als and workmanship for one year. If your Targus accessory is  
found to be defective within that time, we will promptly repair  
or replace it.This warranty does not cover accidental damage,  
wear and tear, or consequential or incidental loss. Under no  
conditions is Targus liable for loss of, or damage to a devices  
nor loss of, or damage to, programs, records, or data; nor any  
consequential or incidental damages, even if Targus has been  
informed of their possibility. This warranty does not affect your  
statutory rights.  
Regulatory Compliance  
This device complies with Part 15 of the FCC Rules. Opera-  
tion is subject to the following two conditions: (1) This device  
may not cause harmful interference, and (2) This device must  
accept any interference received, including interference that  
may cause undesired operation.  
 
9
Targus Voice Recording presenter with Laser Pointer  
FCC Statement  
Tested to Comply  
This equipment has been tested and found to comply with the limits of  
a Class B digital device, pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates,  
uses, and can radiate radio frequency energy and if not installed and  
used in accordance with the instructions, may cause harmful interfer-  
ence to radio communications. However, there is no guarantee that  
interference will not occur in a particular installation. If this equipment  
does cause harmful interference to radio or television reception, which  
can be determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of the  
following measures:  
Reorient or relocate the receiving antenna;  
Increase the separation between the equipment and receiver;  
Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected;  
Consult the dealer or an experienced radio/TV technician for help.  
Changes or modifications not authorized by the party responsible for  
compliance could void the user’s authority to operate this product.  
FCC Radiation Exposure Statement  
This equipment complies with FCC RF radiation exposure limits set  
forth for an uncontrolled environment. This equipment should be  
installed and operated with a minimum distance of 20 centimeters  
between the radiator and your body.  
Declaration of Conformity  
Hereby, Targus, declares that this device is in compliance with the  
essential requirements and other relevant provisions of Directive  
1999/5/EC.  
Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks  
of Microsoft Corporation in the United States and/or other countries. All trademarks  
and registered trademarks are the properties of their respective owners. All rights  
reserved.  
 
10  

Tasco Digital Camera 119213C User Manual
Teac Radio GR 7i User Manual
The Singing Machine Karaoke Machine cd+g and mp3 g karaoke system with synchronizing disco lights User Manual
Toastmaster Coffeemaker RHCMRET User Manual
Toastmaster Waffle Iron TWB4BELCAN User Manual
Toshiba IP Phone iES16 User Manual
Toshiba Marine Radio A10 User Manual
Triarch Indoor Furnishings 29583 User Manual
True Fitness Bicycle CS8 User Manual
Victor Calculator 1205 2 User Manual