OPERATING INSTRUCTIONS
45 SECONDS ANTI-SHOCK
PORTABLE CD PLAYER
WARNING: TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
USING ON RECHARGEABLE
BATTERIES C
USING ON DRY CELL
BATTERIES A
Open the battery compartment and insert two LR6
(size AA) alkaline batteries with the and marks
correctly aligned.Not included.
Be sure to use size AA Ni-Cd 1.2V rechargeable
batteries.which are commercially available.
Not included.
Be sure to read the instructions of the purchased
rechargeable batteries before use
Battery replacement
Before charging the batteries, close the disc
compartment, you cannot charge the batteries
while it is opened
Only for thespecial rechargeable batteries
which expose part onthe polarity.
The battery indicatorin the display
the remaining power of the batteries. Replace the
batteries when lights.If the unit remains in use
after lights. the operation will stop.
according
to
1. Insert therechargeable batteries with the and
marks correctly aligned.
2. Whenrechargepleaseswitch therechargebutton
to"on",afterrecharging or in other condition switch
to"off ",otherwise theCDplayer will bedamaged
If the cover of the battery compartment
comes off B
Note on dry cell batteries
Do not mix the different types of batteries, or an
old battery with a new one
To prevent the risk of electrolyte leakage or
explosions, never recharge the batteries, apply
heat to them, or take them apart, must set
recharge
button to "OFF".
When not using the batteries, remove them to
prevent needless battery wear
If liquid leaks from the batteries,wipe thoroughly
to remove
3. Connect the AC adaptor.
Not included.
1
2
to DC 4.5 V jack
to a wall outlet
4. Press STOP to start charging.
After charging, disconnect the AC adaptor.
Time to recharge the batteries
Recharge the batteries when
lights,If the unit
remainsinuseafter
will stop.
lights,the current operation
ATTENTION
The rechargeablebatteries are recyclable,At the end
of their useful life, it may be illegal to dispose the
batteries into the municipal waste stream under
various state and local laws. Check with your local
solid waste officials in your area for details about
recycling options or proper disposal.
A
Ni-Cd
Cd
C
B
ON OFF
CHARGE
2
DC 4.5V
1
BEFORE PLAYBACK
D
HOLD switch
D
Release theHOLD switchtoOFF positionbefore playback.
When not using the unit, set the HOLD switch to the
ON position, Accidentally pressed button will not
function. If buttons are pressed when the HOLD
switch is set to theON position."HOLD"will light on
the display.
Turning on and off
D
Turning the power on
Press
playback starts.
PLAY/PAUSE. Power is turned on and
E
F
Turning off the power
If no new operations are done within 30 seconds
from the end of last operation, the power is turned
off automatically. (Auto power off function) you can
turn off the power before it is automatically turned
off by pressing STOP
BASS
Standby mode
D
When an operationfinishes,the unit goes into standby
mode until the auto power off function automatically
turns off the power.
To enter standby mode, press
PLAY/PAUSE to
start playback, then press STOP
Adjusting the sound
E
Volume
Turn the VOLUME control to adjust the volume.
X-BASS E
G
Switch on the X-BASS for extra bass emphasized.
Inserting a disc F
1. Push the OPEN switchto open the disc compartment
2. Place a disc in the center with the label side facing up.
3. Close the disc compartment.
To remove the disc
G
Pick up the disc, holding its edge, while pressing
the pivot gently.
PLAYBACK H
MODE KEY:
NORMAL
Connect thesupplied headphone tothePHONE jack.
1. Release HOLD to OFF position.
2. Place a disc.
REPEAT ONE
SHUFF
REPEAT ONE: "
REPEAT ALL
INTRO
1"light on display
3. Press
PLAY/PAUSE
Playback starts from the first track.
BASIC OPERATION
To stop:
To pause:
and will repeat the track you selected
Press STOP
Press
PLAY/PAUSE
REPEAT ALL: "
ALL" light on display
and will repeat entire tracks
At stop mode,press until "INTRO"
lights on display and will play the first
10 seconds of each track
To resume, press it again.
To search for the
INTRO:
SHUFF:
beginning of a track: Press
or
or
desired
To locate a
passage:
Keep
Pressed.
"SHUFF" light on display
Plays every tracks in random order
Release thebutton until the
start of desired passage.
ANTI SHOCK: light on display until
Press again then change to normal play
if no disc then"No Disc"is displayed.
No Disc:
H
PROGRAM:
1. At STOPmode,
"PROG 00"start flashing.
3
Press PROGRAM key,Then
1
2. Press skip /searched
track No.
or
key to search the
3. When desired track is display, press PROGRAM
key to register, Then track No. display to "00" again.
4. Repeat 2-3 (up to 20 tracks) after register 20 tracks.
display shows the first registered track.
2
2
1
5. Registered tracks can be check by press PROGRAM
key, And it can be changed by repeat 2-3.
6. Press play key, then PROG stops flashing and starts
playing.
7. Open the door or power off to clean programing
3
CONNECTION TO AN
MAINTENANCE
To clean the lens
J
I
EXTERNAL UNIT
If the lens become dirty, the player will skip or not
play, If this occurs, clean the lens in the following.
manner, To remove dust or dust particles,first use a
camera lens blower/brush 1 to blow a few times to
Usea commercially available connectioncord which
has a 3.5mm stereo plug at oneendand two phono
plugsattheotherend.
Connect thestereoplugtotheLINEOUT jack
of theunit and connect thephono plugsto theanalog
input(AUX)terminalsoftheexternalunit.
2
loosen particles, then gently brush the lens clean
finish by blowing the lens again.
Note
NOTE
Take care not to get too much solution on the swab.
which could flow into the unit and cause damage.
Pressing too strongly with the swab could scratch
or break the lens.
Turn off the powerof bothunits beforeconnection.
DONOTconnect tothe PHONO(magneticpickup)
inputsofanamplifier.
Volumeand bass boost on this unit have no effect
on the line output.
To clean the discs
K
Before playing, wipe the disc from the center out
with a cleaning cloth, After playing, store the disc
in its case.
I
1
J
LINE OUT
LINE IN
CD IN
AUX
2
K
SPECIFICATIONS
Tracking system
Laser pickup
D/A conversion
1-beam laser
Semiconductor laser
8-times oversampling digital fillter
+1- bit DAC
Frequency response
Outputs
20-20,000 Hz
PHONES: stereo jack (3.5mm)
[20mW+20mW, 32 ohms at 1
kHz]
Input
DC 4.5V for external power from
AC adaptor: Not included.
DC 3V from Alkaline batteries
(2 x AA or LR6): Not included.
DC 2.4V from the rechargeable
batteries: Not included.
142 x 29(H) mm
Power
Dimensions
Weight
9
1
(
5 /16x1 /8 inches)
210 grams (9.8 oz.) without
batteries
Supplied accessory
Stereo headphones (1)
The specifications and external appearance of this
unit are subjected to change without notice.
SUBJECT TO MODIFICATION WITHOUT NOTICE!
|