WOOD BURNING APPLIANCE
KITS AND ACCESSORIES
750,058M
11/2000
EDGE TRIM KITS
INSTALLATION INSTRUCTIONS FOR EDGE TRIM KITS
FOR USE WITH SUPERIOR'S WOOD BURNING APPLIANCES
Step 5. 42 Models only. Install the lower mounting frame trim.
Align the two holes of the trim to the two holes of the fireplace.
SHIPPING AND PACKING LIST
Edge Trim Kit must include:
1 - RH Side Trim
Step 6. 42 Models only. Align the two end holes of the second
upper mounting frame with the holes on the lower fireplace frame
and secure with two screws.
1 - LH Side Trim
1 - Top Frame Trim
1 - Lower Mounting Frame Trim*
2 - Upper Mounting Frame Trim*
Step 7. Adjust all trim pieces and ensure that all screws have been
tightened. Reinstall louvers.
*Note: Upper and lower mounting frame trim included with
Models 42 only.
Step 8. Remove protective covering from trim pieces and wipe with a
damp cloth.
The Edge Trim Kits covered in this document are:
Step 9. Reinstall louvers.
Catalog #
91L57
91L58
91L61
91L62
Model #
ETK36-B
ETK36-P
ETK42-B
ETK42-P
FIREPLACE EDGE TRIM KIT INSTALLATION INSTRUCTIONS
Step 1. Remove fireplace grille assemblies by lifting up and out of holes
on frame. Then pull from bottom out towards you. (Figures 1 and 2 ).
Note: Lift grille near outer support rods to fully clear holes.
Step 2. There is a right hand and a left hand trim. Install side trims
carefully. Place trim on side frame and press firmly to fit around
frame (Figure 1 ).
Step 3. Install the top frame trim with two screws as shown in
Figure 2.
Note: The ends should overlap the side trim pieces a little.
Step 4. 42 Models only. Install one of the two upper mounting
frame trim pieces by aligning the three holes of the trim to the three
holes of the fireplace. Fasten with three screws.
Figure 1
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
|