Planning Information
Model I663418(R) Pro Island Hood
Hand finished crafts-
manship
Classic stainless
steel finish
Decorative rail
(optional)
Backdraft damper
Model I663418
Stainless steel
baffle filters
Model I663418R
Rail Option
Welded seams
and hemmed edges
Recessed easy
access controls
Halogen lighting
Infinite speed
blower control
Model I663418R shown with standard classic stainless steel decorative
rails, platinum rails available as a sales accessory
A
Wolf Pro island hood —the final touch to complete
Wolf Pro island hoods are available in
the classic stainless steel finish. Rail
option hoods (R) come with classic stain-
less steel decorative rails and stand-offs
for both sides of the hood. Optional
platinum rails match dual fuel range
bezels. Pro island hoods are sold as a
shell only; internal, in-line and remote
blower options are available.
your stage featuring professional cooking equipment.
This premier ventilation system complements your
cooking appliance of choice, guaranteeing you’ll look
the part, no matter what new cooking challenges you
take on.
This 66" (1676) wide island hood is 34" (864) deep and
available in the classic stainless steel finish. You also
have the option of decorative rails. While classic stain-
less steel rails are standard on the (R) model, platinum
rails are also available to match the bezels of our dual
fuel ranges and sealed burner rangetops.
The Pro island hoods are recommended for use with all
Wolf cooking appliances.
Dimensions in parentheses are in
millimeters unless otherwise specified.
1
9/06
Planning Information
Model I663418(R) Pro Island Hood
B L O W E R O P T I O N S
S P E C I F I C A T I O N S
Overall Width of Hood
Overall Height of Hood
1200 CFM Internal Blower
1100 CFM In-Line Blower
1200 CFM Remote Blower
1500 CFM Remote Blower
Refer to the Pro Ventilation
804703
808332
801642
804701
66" (1676)
18" (457)
Overall Depth of Hood – I663418
I663418R (including rails)
34" (864)
38" (965)
Duct Size
10" (254) Round
Vertical
Recommendations chart at the end
of this section.
Discharge
Electrical Supply Requirements
110/120 V AC, 60 Hz
15 amp dedicated circuit
A C C E S S O R I E S
Shipping Weight (shell only)
168 lbs (76 kg)
Platinum decorative rails and
stand-offs for both sides of the
hood
Specifications are subject to change without notice.
6" (152) and 12" (305) duct
covers
Contact your Wolf dealer for additional
information on accessories.
Dimensions in parentheses are in
millimeters unless otherwise specified.
3
Planning Information
Model I663418(R) Pro Island Hood
I N S T A L L A T I O N S P E C I F I C A T I O N S
LOCATION OF ELECTRICAL SUPPLY
CENTERED THROUGH TOP OF HOOD
18" (457)
HEIGHT
OF HOOD
66" (1676)
WIDTH OF HOOD
34" (864)
DEPTH OF HOOD
30" TO 36"
(762–914)
30" TO 36"
(762–914)
TO COUNTERTOP
TO COUNTERTOP
D I M E N S I O N S
Overall Width of Hood
66" (1676)
Overall Height of Hood
18" (457)
34" (864)
Overall Depth of Hood (excluding rails)
Countertop to Bottom of Hood
Location of Electrical
30" (762) to 36" (914)
Centered through top of hood
See Installation Instructions shipped with unit for detailed specifications.
Dimensions in parentheses are in
millimeters unless otherwise specified.
4
Planning Information
Model I663418(R) Pro Island Hood
I N S T A L L A T I O N N O T E S
Refer to the illustrations and specifications
for overall dimensions and installation specifics.
Pro island hoods require a separate,
grounded 110/120 V AC, 60 Hz power supply.
The service should have its own 15 amp circuit
breaker. Placement of the electrical supply is
not critical, as long as you provide a minimum
of 6" (152) of 120 V AC, 60 Hz power cable.
Location of electrical is centered through the
top of the hood as shown in the Installation
illustration on page 4.
Wolf Pro island hoods are recommended for
use with any Wolf cooking appliance. The hood
must overlap the cooking surface by a minimum
of 3" (76) on either side.
Installation of all Pro island hoods should be
30" (762) to 36" (914) from the bottom of the
hood to the countertop. Follow the dimensions
shown in the Installation illustration.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
Wolf Pro island hoods are shipped without a
blower assembly. Internal, in-line and remote
blower assemblies are available. Blower options
also vary with the volume of air that needs to
be moved and the length of the duct run. Refer
to the charts at the end of this section for Pro
ventilation recommendations and blower
options.
Refer to the installation instructions shipped
with each Wolf product for detailed specifica-
tions. This information can also be found on
our website, wolfappliance.com.
IMPORTANT NOTE: Install this ventilation hood
only with a Wolf blower.
Dimensions in parentheses are in
millimeters unless otherwise specified.
5
Planning Information
Model I663418(R) Pro Island Hood
D U C T I N G C O N S I D E R A T I O N S
Pro island hoods are shipped without the blower
assembly. Internal, in-line or remote blower
assemblies are available.
IMPORTANT NOTE: Install these ventilation
hoods only with a Wolf blower.
Refer to the Pro ventilation charts at the end of
this section for recommendations and blower
options.
Wolf Pro island hoods have a vertical discharge
location as shown in the illustration below.
Ducting considerations for
Pro island hoods.
DUCTWORK INSTALLATION
THROUGH ROOF
ROOF CAP OR REMOTE BLOWER
10" ROUND DUCT
TRANSITION
141/8"W x 9"D TO 10" ROUND
11"H (INCLUDING FLANGES)
SOFIT, CABINET OR
DUCT COVER
VERTICAL
DISCHARGE
18" (457)
HEIGHT OF HOOD
ISLAND HOOD
34" (864)
DEPTH OF HOOD
30" TO 36"
(762–914)
COUNTERTOP
TO BOTTOM OF
VENTILATION HOOD
36" (914)
STANDARD
FLOOR TO
COUNTERTOP
HEIGHT
VERTICAL DISCHARGE ONLY FOR ISLAND HOODS.
Dimensions in parentheses are in
millimeters unless otherwise specified.
6
Planning Information
Wolf Ventilation Recommendations
W O L F B L O W E R A S S E M B L I E S
A ventilation system must include a blower
assembly. With a few exceptions where internal
blowers are included, Wolf ventilation hoods and
downdrafts are shipped without the blower
assembly. An internal, in-line or remote blower
assembly must be selected to accommodate the
cooking appliance, CFM requirements and home-
owner preferences. Internal, in-line and remote
blower assemblies are available as sales acces-
sories through your Wolf dealer.
IMPORTANT NOTE: Use only a Wolf blower
with all Wolf ventilation products.
Internal blowers are mounted inside the hood
canopy or downdraft blower box. In-line blowers
are mounted in between the hood and the
exterior of the home. Remote blowers can be
mounted on the roof or in some cases, on an
exterior wall. Refer to the illustrations below for
dimensions of Wolf in-line and remote blowers.
Ventilation recommendation charts on the
Wolf internal, in-line and remote blowers are for
use with Wolf cooktop hoods, downdraft
systems and Pro ventilation hoods and hood
liners.
following pages provide minimum CFM recom-
mendations according to the cooking appliance
and ventilation system used and blower options
for each specific ventilation hood or downdraft.
7
24 /8"
3
24 /8"
(632)
(619)
3
11 /4"
(298)
18"
12"
(457)
1
(305)
18 /2"
(470)
1
4 /2"
(114)
8"
(203)
1
21 /2"
1
(546)
22"
12 /4"
(311)
18"
(559)
(457)
In-line BLOWER-60IL
In-line BLOWER-110IL
18" (457)
21" (533)
3
20 /4"
10"
10"
(527)
(254)
(254)
1
1
28 /4"
29 /2"
1
29 /2"
(749)
(718)
(749)
10" (254)
Diameter
10" (254)
Diameter
10" (254)
Diameter
1
3
15 /2"
(394)
3
14 /4"
(375)
14 /4"
(375)
1
1
29 /2"
1
29 /2"
24 /2"
(749)
(749)
(622)
1
3
14"
10 /8"
10 /8"
(356)
(257)
(264)
3
4
/4"
3
(121)
24 /4"
(629)
1
7
1
7
22"
25"
/4"
/4"
(559)
(635)
(184)
(184)
Remote BLOWER-60REM and
BLOWER-90REM
Remote BLOWER-120REM
Remote BLOWER-150REM
Dimensions may vary by 1/8" (3).
Dimensions in parentheses are in
millimeters unless otherwise specified.
7
Planning Information
Wolf Ventilation Recommendations
P R O V E N T I L A T I O N C F M R E C O M M E N D AT I O N S
Pro Island Hoods
I363418
I423418
600
I543418
I663418
DF304 / R304 / SRT304
DF366 / R366 / SRT366 / RT366
DF364 / R364 / SRT364 / RT364
RT362
600
900
900
900
R488 / RT488
1100
1100
900
DF486 / R486 / SRT486 / RT486
DF484 / R484 / SRT484 / RT484
R482 / RT482
900
DF606 / R606
1500
1500
DF604 / R604
Model numbers for dual fuel ranges, gas ranges, sealed burner rangetops and gas rangetops indicate width and number of surface
burners. Features such as a charbroiler, griddle and/or French Top will vary.
CFM recommendations are based on total Btu/hr output. Wolf recommends 1 CFM per 100 Btu/hr (.03 kW). Additional CFM may be
required for long duct runs.
P R O V E N T I L A T I O N B L O W E R O P T I O N S
Pro Island Hoods
Blower Description
1200 CFM Internal
1100 CFM In-Line
900 CFM Remote
1200 CFM Remote
1500 CFM Remote
Blower Number
Island Hood Models
All Island Hoods
IBLOWER-120INT (804703)
BLOWER-110IL (808332)
BLOWER-90REM (801641)
BLOWER-120REM (801642)
BLOWER-150REM (804701)
All Island Hoods
I363418 / I423418 / I543418
All Island Hoods
All Island Hoods
Vertical discharge with 10" (254) round duct.
Island hood models without decorative rails listed; blower options are the same for (R) models. Transition with backdraft damper
included with island hoods. Blower configurations are for reference only. Refer to minimum CFM recommendations for your specific
cooking product. Always consult a qualified HVAC Engineer for specific applications
Dimensions in parentheses are in
millimeters unless otherwise specified.
8
|