Riva Freestanding Bench
Installation Instructions
Product Codes: RVACB45B (For use with RVF40C)
RVACB100B (For use with RVF40C, RVF66 & RVF76)
RVACB120B (For use with RVF40C, RVF66 & RVF76)
IMPORTANT
Please read these instructions carefully and in conjunction with the appropriate Riva instructions.
Care must be taken when handling the stove to avoid injury or damage to the stove.
PM205 ENG Issue 2 (August 2007)
ASSEMBLY INSTRUCTIONS
5
8
PR7572
8.
Remove back cover plate from the stove.
PR7569
5.
Slide The bench over the coach bolts and
9
tighten. Position drilling template as you would the
stove.
6
PR7573
PR7570
9.
10
Lift off stove cover plate.
6.
Mark drilling points with a centre punch.
7
Felt pads
PR7574
10. Firstly remove all internal parts from the
PR7571
stove and remove the door. Tip the stove onto its
front on a soft surface that will not damage the
paintwork. Apply felt pads to each corner of the
base.
7.
sides.
Drill four Ø8mm holes. Straight through both
3
ASSEMBLY INSTRUCTIONS
11
14
PR7575
PR7578
11. Position the stove onto the bench.
14. Replace the top cover plate.
15
12
M6 nut
M6 washer
M6 X 90mm coach bolt
PR7579
PR7576
15. Re-attach the back cover plate, internal parts
12 Remove ash pan and insert the two coach
bolts in the front holes, fixing with the nuts and
washers provided.
and door.
16
13
PR7577
13. Repeat step 12 with the rear holes.
PR7580
Stovax Ltd, Falcon Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7LF
|