Commercial Gas Water Heater
I
Meets ASHRAE 90.1b-1992, and C.E.C. and New York Codes for
thermal efficiency and standby loss.
I
Glass-Lined Tank – Exclusive corrosion protection with glass-lining.
Multiple anodes provide corrosion protection.
I
Power Gas Burner – Electronic flame monitoring with direct spark
ignition. For added safety, all units are equipped with redundant gas
valves. Power gas burner requires 120 volt 60Hz service. A
NEGATIVE DRAFT is required in the vent piping. This is not a forced
draft burner.
I
Fully Automatic Controls – Safety shut off, high temperature limit
control, dual thermostat (adjustable 120°F thru 180°F) for accurate
temperature control. Maximum inlet gas pressure 14˝ W.C.
I
Foam Insulation – Saves fuel, helps reduce standby heat loss.
I
Jacket – made of heavy gauge steel with baked enamel finish over
bonderized undercoat.
I
Fully Certified by U.L.
I
ASME Construction – Available on GPG81 140, GPG81 199, GPG81
270 & GPG81 370. When specifying ASME construction, add the letter
“A” at the end of the model number. 160 psi working pressure.
I
A.G.A./ASME Rated Temperature & Pressure Relief Valve –
Factory installed.
I
Barometric Draft Damper – To ensure proper draft for maximum
efficiency.
I
Easy Cleaning – Handhole cleanout(s) allows easy cleaning.
I
Professional Startup Service – Furnished to assure most efficient
combustion and safe initial operation.
CAUTION: Unit must be installed on non-combustible surface.
Limited Warranty:
Other Features:
– Two layers of high temperature ceramic fiber insulation in
combustion chamber
I
Limited Warranty Outline
– If the tank should leak any time during the first three years, under the
terms of the warranty, State Water Heaters will furnish a replacement
heater; installation, labor, handling and local delivery extra.
– NOTE: This Outline Is NOT A Warranty. For complete information,
consult the written warranty or State Water Heaters.
– Flame inspection port opening
– Mounted on rugged channel iron skids
– Multiple anodes for protection.
Options:
– Illinois School Code on GPG81 199 to GPG81 370
– National Board Registration (ASME models only)
– Low water cutoff
– 5 or 10 year extended limited warranty.
– ASME (ON SELECTED MODELS)
The
Expert’s
™
WATER HEATERS
Choice
|