Dell Replacement Power Supply
300 Watt ATX12V 2.01 Dell Replacement Power Supply
350 Watt ATX12V 2.01 Dell Replacement Power Supply
400 Watt ATX12V 2.01 Dell Replacement Power Supply
ATXPW300DELL
ATXPW350DELL
ATXPW400DELL
Instruction Manual
Actual product may vary from photo
Instruction Manual
Table of Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Compatibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
i
Instruction Manual
Introduction
Thank you for your purchase of a StarTech.com ATX 12V Dell replacement Power
Supply. Designed for extra-long life in personal and industrial computers, this Power
Supply is a suitable replacement for compatible Dell computers (Please see compatibility
chart on Page 2), and features an 8cm fan to provide quiet operation and superior
performance.
Features
• 100, 000 hour MTBF
• ATX 2.01 compliant
• Dual 12V power rails to deliver stable power to demanding devices
• 20/24 pin split ATX style motherboard connector for compatibility with existing
standards
• 8cm fan provides quiet, efficient airflow for increased reliability
• Premium EMI/RFI power filtration provides low noise and ripple for stable power
delivery to all system components
• SATA hard drive connectors
• PCI Express connector (ATXPW400DELL)
• Compatible with many Dell™ Dimension®, Optiplex® and other Dell™ systems.
Please see specific Dell PC compatibility for each power supply, listed on page 2.
Contents
This package should contain:
• 1 x Power supply
• 1 x Standard power cable
• 1 x Instruction manual
1
Instruction Manual
Compatibility
Please note:
ATXPW300DELL provides a Dell specific proprietary connector, and should not be used
with any PCs other than those included in the following list of compatible systems.
ATXPW300DELL
Series
Compatible Models
2100, 4100, B1000R, L Series, V350,
V400, XPS B Series, XPS Dxxx, XPS
Mxxx, XPS P133c MT, XPS Pro 180n,
XPS Rxxx, XPS Txxx
Dell™ Dimension®
G1, GX1, GX110, GX115, GX300,
Gxa, Gxi
Dell™ Optiplex®
Dell™ Power Edge®
2100, 2200
Dell™ Precision Workstation® 210, 400
ATXPW350DELL and ATXPW400DELL should not be used with any PCs other than
those included in the following list of compatible systems.
ATXPW350DELL
Series
Compatible Models
3000 / 3100 / 4600 / 4700 / 8400 /
9100 / E310 / E510
Dell™ Dimension®
Dell™ Optiplex®
GX280
SC420
Dell™ Power Edge®
Dell™ Precision Workstation® 370
ATXPW400DELL
Series
Compatible Models
1100, 2200, 2300, 2350, 2400, 4300,
4400, 4500, 4550, 8200, 8250, 8300,
B100
Dell™ Dimension®
170L, GX60, GX150, GX240, GX260,
GX270
Dell™ Optiplex®
Dell™ Power Edge®
400SC, 600SC
Dell™ Precision Workstation® Model 340
Dell™ Smart Step®
100D, 150D
2
Instruction Manual
Installation
CAUTION: Computers contain sensitive electronic components that are
easily damaged by static electricity and excessive shock. When handling
the power supply and other components, ensure you are properly
grounded using an anti-static mat or similar device. If anti-static equipment
is not available, ground yourself by touching the exterior of the computer
case or another large metal surface before handling any peripherals.
1. Installation of a power supply requires some mechanical skill and requires that you
open your computer case to disconnect and reconnect wires. If you are unfamiliar with
this kind of work, consider bringing your computer and new StarTech.com power
supply to your local computer store for help.
2. Check the red switch on the rear of the power supply, next to the power cord plug. Be
sure it is set to the correct voltage for your country. In North America, it should read
"115". In Europe and Australia it should read "230". To change the switch, use a
screwdriver in the notch of the switch and slide it to the opposite side. If you are
unsure of the voltage used in your country, contact your electricity provider before
proceeding.
3. If you are replacing an old power supply in your computer, ensure the computer is
shut down and disconnect the power cord from the back of the old supply.
4. Open your computer case. In most designs, the case is opened by removing two or
three screws at the rear of the case and then sliding the covering panel backward until
it comes free. If your case is a tower style, ensure that you remove the panel that will
expose the top of the computer's motherboard. This is generally the left-side panel.
There are many different case designs, however, so if you are unsure of how to open
your particular case, consult the user manual for your case or contact your local
computer store for help.
5. With the computer case open, review the connectors being used from your old power
supply. If you are building a new computer, review the connectors that you will need to
use. Check the type of connector on your motherboard and use either the 24 or 20 pin
ATX power connector on the power supply as appropriate.
6. Disconnect the old power supply connections from inside your computer. Hard disk
drive, CD drive and floppy disk drive connectors disconnect by pulling on the
connector. The motherboard connector(s) have a clip that must be pressed while
pulling on the connector to release them. A rocking motion while pulling will aid in
getting the connectors loose. Never pull on the wires of a connector to unplug it.
7. Check that all the wires from your old power supply are free. Remove the four screws
on the rear of your old power supply to free it from the computer case. Support the
power supply with one hand if it could fall while removing the last screw. (Such as in a
tower style case.) Remove the power supply by sliding it back and then out through
the side of your case.
8. Install your new power supply by positioning it through the side or top of your case
(depending on your case style) and then back onto the power supply mounts. Check
that the orientation with the screw holes in your case is correct; all four holes must be
aligned. Support the power supply with one hand while threading a mounting screw
3
Instruction Manual
through the back of the case and into the power supply. The screw should thread
smoothly and should not require effort. Do not force it or you could damage the
mounting holes. If the screw won't thread smoothly, remove it and check to ensure the
mounting holes are correctly lined up. Repeat for the remaining three screws. Do not
fully tighten any of the screws until they all have been threaded into their mounting
holes. (Note: Consider Startech part SCREWTHUMB screws for easier installation.)
9. Tie unused wires away from fans and other moving parts.
10. Replace the case cover and secure it. You may wish to not replace the screws until
after you have checked that all connections are working.
11. Start your computer. You should hear its fans and devices immediately begin to run.
If you do not, toggle the rear switch on the power supply to off, disconnect the power
cord, open the case and check that all connectors are well seated and secure.
12. When you have confirmed all connections are working, replace the screws in your
case.
13. Power supplies contain electrical and electronic components and should be disposed
of properly. If you are replacing a power supply, please follow your city’s rules for
proper disposal of electrical equipment.
4
Instruction Manual
Specifications
L x W x H: 140 x 150 x 86mm
Dimensions/Weight
ATXPW300DELL: 1.86kg (4.1lbs)
ATXPW350DELL: 1.9 kg (4.2lbs)
ATXPW400DELL:: 2.15kg (4.74lbs)
ATXPW300DELL: 115V (8A) or 230V (4A), 50-60Hz (Manual Switching)
ATXPW350DELL: 115V (8A) or 230V (4A), 50-60Hz (Manual Switching)
ATXPW400DELL: 115V (10A) or 230V (5.5A), 50-60Hz (Manual Switching)
ATXPW300DELL: 300W
AC Input Voltage
Output Power (max.)
Fan
ATXPW350DELL: 350W
ATXPW400DELL: 400W
8cm, sleeve
ATXPW300DELL: FCC, TUV, UL, CSA
ATXPW350DELL: FCC, TUV, UL, CSA
ATXPW400DELL: FCC, TUV, UL, CSA
Regulatory Approvals
ATXPW300DELL:
ATXPW350DELL:
ATXPW400DELL:
4 x LP4
3 X LP4 Female
4 x LP4
1 x SP4 Floppy Drive 1 X SP4 Female
2 x SP4 Floppy Drive
4 x SATA
2 x SATA
2 X SATA Power Female
Connectors
1 x AUX 6pin
1 x ATX 20/24pin
1 x 6-pin Auxiliary
Connector
1 x PCI Express 6pin
1 x ATX 20/24pin
1 X P4 ATX Male 12V Plug P4 (ATX12V) 4pin
1 x ATX 20/24pin
AC Input
Voltage Current Frequency
115V~
230V~
8A
4A
ATXPW300DELL
50-60Hz
115V~
230V
8A
4A
ATXPW350DELL
ATXPW400DELL
50-60Hz
50-60Hz
115V~
230V~ 5.5A
10A
ATXPW300DELL
+5VSB
+3.3V +5V +12V1 +12V2 -12V
PS-ON POK COM
DC
Output
20A
20A
8A
14A
0.8A
2.0A Remote P. G Return
120W
264W
Max.
300
9.6W 10W
-
-
-
280.4W
ATXPW350DELL
+5VSB
+3.3V +5V +12V1 +12V2 -12V
PS-ON POK COM
DC
Output
22A
21A
10A
15A
0.8A
2.5A Remote P. G Return
130W
300W
Max.
350
9.6W 12.5W
-
-
-
327.9W
ATXPW400DELL
+5VSB
+3.3V +5V +12V1 +12V2 -12V
PS-ON POK COM
DC
Output
30A
28A
14A
15A
1A
2.5A Remote P. G Return
140W
348W
Max.
400
12W 12.5W
-
-
-
375.5W
5
Instruction Manual
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to provide
industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
Warranty Information
This product is backed by a two-year warranty. In addition, StarTech.com warrants its
products against defects in materials and workmanship for the periods noted, following
the initial date of purchase. During this period, the products may be returned for repair, or
replacement with equivalent products at our discretion. The warranty covers parts and
labor costs only. StarTech.com does not warrant its products from defects or damages
arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
officers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product.
Some states do not allow the exclusion or limitation of incidental or consequential
damages. If such laws apply, the limitations or exclusions contained in this statement
may not apply to you.
6
About StarTech.com
StarTech.com is “The Professionals’ Source for Hard-to-Find Computer
Parts”. Since 1985, we have been providing IT professionals with the
quality products they need to complete their solutions. We offer an
unmatched selection of computer parts, cables, server management
solutions and A/V products and serve a worldwide market through our
locations in the United States, Canada, the United Kingdom and Taiwan.
and to access exclusive interactive tools such as the Parts Finder and the
KVM Reference Guide. StarTech.com makes it easy to complete almost
any IT solution. Find out for yourself why our products lead the industry in
performance, support, and value.
Revised: 16 August 2007 (Rev. A)
|