English
Connections
Specifications
Speaker System
• Before connecting, turn off the amplifier or receiver to
avoid damaging the speaker system.
• This speaker system is driven best by an amplifier or
receiver rated as per the wattage indicated in the
specification section.
A low-powered amplifier or receiver could result in
signal clipping, which could result in tweeter burn-out.
Therefore, it is recommended to use an amplifier or
receiver with sufficient power rating.
SS-B3000
Speaker system
Speaker units
3-way, magnetically shielded
Woofer: 20 cm (8 in.) , cone type
Midrange: 8 cm (3 1/4 in.), cone type
Tweeter: 2.5 cm (1 in.) , balanced dome
type
Bass reflex
8 ohms
SS-B3000/B1000
2-899-024-11(2)
Enclosure type
Rated impedance
Power handling capacity
Maximum input power: 120 watts
Note
Avoid driving the speaker system continuously with a
wattage exceeding the maximum input power of each
speaker.
Sensitivity level
Frequency range
Dimensions (w/h/d) Approx. 240 × 530 × 263 mm
(9 1/2 × 20 7/8 × 10 3/8 in.) including
front grille
88 dB (1 W, 1 m)
50 Hz - 50,000 Hz
(2)
Owner’s Record
The model and serial numbers are located on the rear of the unit. Record the
serial number in the space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.
Precautions
Mass
Supplied accessory
Approx. 6.5 kg (14 lb 6 oz)
Speaker cord (2)
• Do not attempt to open the enclosure or remove
speaker units. There are no user-serviceable parts
inside.
• Keep recorded tapes, watches, and personal credit
cards using magnetic coding away from the speaker
system.
• Periodically wipe the cabinet with a soft cloth. Do not
use any type of scouring powder, abrasive pad or
solvent.
Model No.
Serial No.
SS-B1000
Speaker system
Speaker units
2-way, magnetically shielded
Woofer: 13 cm (5 1/8 in.) , cone type
Tweeter: 2.5 cm (1 in.) , balanced dome
type
Bass reflex
8 ohms
Standard Connection
Enclosure type
Rated impedance
• Be sure to install the grill net in the correct direction.
Power handling capacity
Maximum input power: 120 watts
Speaker Placement
Sensitivity level
Frequency range
87 dB (1 W, 1 m)
80 Hz - 50,000 Hz
Please note that room acoustics can often produce large
difference in the sound for small changes in speaker
placement.
Dimensions (w/h/d) Approx. 170 × 255 × 186 mm
(6 3/4 × 10 × 7 3/8 in.) including front
grille
• Set up your speaker system on a hard, flat place.
• Place the speaker system against a hard wall with its
back about 10 cm (4 in.) away from a wall. The
proportion of bass increases as you move a speaker
close to intersecting room surfaces (wall and wall, etc.).
• Place the right and left speakers in a similar acoustic
environment.
+
–
Mass
Supplied accessory
Approx. 2.9 kg (6 lb 7 oz)
Speaker cord (2)
Design and specifications are subject to change without
notice.
Right
Left
• It is recommended that the speaker/listener
relationship be an equilateral triangle.
Amplifier
SPEAKER
2007 Sony Corporation Printed in Malaysia
|