zOt h e r Op e ra t io n s
To
Press
Pla yin g t ra cks in ra n d o m
o rd e r (Sh u ffle Pla y)
3-861-762-24 (1)
Usin g o t h e r fu n ct io n s
Pause (main unit
only)
^
Pla yin g t ra cks re p e a t e d ly
(Re p e a t Pla y)
To m in im ize skip p in g (ESP2)
Playing a CD right
away!
The ESP (Electronic Shock Protection)
function minimize skipping by using a buffer
memory that stores music data and plays it
back in the event of a shock.
You can play the tracks in a CD in random
order.
Resume play after
pause (main unit
only)
^
You can play tracks repeatedly in normal,
INTRO PGM, shuffle or RMS (Random Music
Sensor) play modes. Repeat all the tracks or
only one track.
PLAY
MODE
The new ESP2 (ESP Squared) system uses a
new DSP (Digital Signal Processor) which can
read and store music data more efficiently,
providing a level of continuous skip
protection not found in traditional buffer
memory units. This decreases the frequency
of sound skipping and the need to utilize the
buffer memory. Use this function when
listening in a car or while walking.*
Find the beginning
of the current track
(AMS*)
=once**
=repeatedly**
+ once**
+ repeatedly**
If you want to play a CD right now, choose to use your player on house
current. Other choices are the following three: rechargeable battery, dry
batteries (see “Power Sources” on the reverse side) and car battery.
Find the beginning
of previous tracks
(AMS)
Co m p a ct Disc
During play, press PLAY MODE repeatedly
until “SHUF” appears.
The tracks play in random order.
Co m p a ct Pla ye r
* Although ESP2 provides excellent protection
against skipping, it will not prevent skipping
while jogging or running.
Find the beginning
of the next track
(AMS)
REPEAT/
ENTER
PLAY
MODE
1
Connect
To re p e a t a ll t h e t ra cks
Press REPEAT/ ENTER during play.
The “ ” indication appears.
Find the beginning
of succeeding
tracks (AMS)
Operating Instructions
ESP
to a wall
outlet
Ab o u t a re a co d e
To cancel shuffle play, press PLAY MODE
repeatedly until the play mode indication
disappears from the display.
The area code of the player you purchased is shown on upper left of the bar
code label on the package.
For accessories supplied with your player, check the area code of your model
and refer to “Supplied accessories” toward the end of this manual.
Go forward
quickly
Hold down
+**
When using
earphones
Note
Go backwards
quickly
Hold down
=**
• During shuffle play, you cannot return to
previous tracks by pressing = .
Press ESP.
The ESP indication appears.
To cancel repeat play, press REPEAT/ ENTER
again.
*AMS = Automatic Music Sensor
**These operations are possible during both
play and pause.
AC power adaptor
To re p e a t a sin g le t ra ck
1 Press REPEAT/ ENTER while the track you
want to repeat is playing.
To re m o ve t h e CD
Remove the CD while pressing the pivot.
Pla yin g t ra cks in t h e o rd e r
yo u w a n t (RMS p la y)
The “
” indication appears.
To release the ESP function, press ESP again.
Earphones
or
DC IN 4.5 V
Notes
Headphones*
• Playing may stop when the player gets a strong
shock even with the ESP function on.
• You may hear a noise or sound skip when:
— listening to a dirty or scratched CD,
— listening to an audio test CD or,
— the player receives continuous shock.
• Sound may drop for a while if you press ESP
during play.
You can program up to 22 tracks to play in
any order you choose.
D-E400
D-E400AN
D-E401
2 Press PLAY MODE repeatedly until “1”
appears.
D-E400HR
D-E401SR
D-E405
^
PLAY
MODE
D-E403
D-E406CK
D-E406CKAN D-E409CK
To e n jo y m o re p o w e rfu l b a ss so u n d
(So u n d fu n ct io n )
You can enjoy a powerful bass-boosted
sound.
*U2 model supplied
with headphones.
2/REMOTE
REPEAT/
ENTER
To repeat another track, press = or + .
=/ +
For models supplied w ith the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
Notes on controlling the volume w ith
the remote control
Set the VOL (volume) control on the remote
control to MAX. Then adjust the volume on the
player to the level that you want to be the
maximum volume of the remote control.
To cancel repeat play, press REPEAT/ ENTER
again.
Sony Corporation 1998 Printed in Malaysia
1
2
During play, press PLAY MODE
repeatedly until “RMS*” flashes.
For models supplied w ith the remote control
• Connect the plug of the earphones/ headphones to the remote control, not to the 2/
REMOTE jack of the player.
• Connect the earphones/ headphones to the remote control firmly. A loose connection may
cause noise during playback.
INFORMATION
We lco m e !
Notes on display
SOUND
Pla yin g o n ly t h e t ra cks
yo u w a n t (INTRO PGM Pla y)
• When you press ^ or ( (when RESUME
is set to OFF), the total number of tracks in
the CD and the total playing time appear for
about 2 seconds.
• During play, the track number and the
elapsed playing time of the current track
appear.
• During pause, the elapsed playing time
flashes in the display.
• Between tracks, the time to the beginning of
the next track will appear with the “–”
indication.
Listening for many hours at maximum
volume may damage your hearing.
Flashing
Thank you for purchasing the Sony
Compact Disc Compact Player.
Before operating your player, please
read this manual and retain it for
future reference.
Press SOUND to select “MB (Mega Bass)” or
“GRV (Groove).” “GRV” is more effective.
*RMS = Random Music Sensor
Fo r t h e cu st o m e rs in t h e USA
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
You can choose and play your favorite tracks
by scanning through the beginning of each
track in a CD.
2
3
Place a CD
Press = or + to choose a track.
The track number and the playing order
appear.
Note
• If the sound is distorted when emphasizing
bass, turn down the volume.
Ab o u t t h is m a n u a l
^
PLAY
MODE
The instructions in this manual are for the
D-E400, D-E400AN, D-E400HR, D-E401,
D-E401SR, D-E403, D-E405, D-E406CK,
D-E406CKAN and D-E409CK. Before you start
reading, check your model number.
The D-E400AN is the model used for illustration
purposes.
Flashing
To lo ck t h e b u t t o n s
You can lock your player against any
accidental operations.
You can still operate the player with the
remote control.
Track number
OPEN
Notes on handling CDs
• To keep the CD clean, handle it by its edge.
Do not touch the surface.
• Do not stick paper or tape onto the CD.
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts. Do not
leave the CD in a car parked under direct
sunlight.
REPEAT/
ENTER
Playing order
+
Ow n e r’s Re co rd
3
4
5
Press REPEAT/ ENTER to program the
track.
1
During play, press PLAY MODE
repeatedly until “INTRO PGM” flashes.
The model and the serial numbers are located at
the bottom. Record these numbers in the spaces
provided below. Refer to them whenever you
call upon your Sony dealer regarding this
product.
Flashing
Repeat steps 2 and 3 to program the
remaining tracks.
Label side up
Press ^ .
1Press OPEN to open the lid.
2Fit the CD to the pivot.
Model No. __________ Serial No.__________
HOLD
“RMS” stops flashing and the tracks you
have chosen play in the order you
specified.
2
3
Press ^ to start scanning .
The player plays about the first 15
seconds of each track and “INTRO PGM”
flashes faster.
WARNING
If you press p, the program will be erased.
To prevent accidental erasure, set the
RESUME switch to ON.
Slide HOLD in the direction of the arrow.
When you press any button, “Hold” appears in
the display and you cannot operate the player.
To p re ve n t fire o r sh o ck
h a za rd , d o n o t e xp o se
t h e u n it t o ra in o r
m o ist u re .
Play
Press REPEAT/ ENTER while the track
you want is playing. To skip the track,
press + or just wait for the next track.
To cancel RMS play, press PLAY MODE until
“RMS” disappears.
To unlock, slide HOLD back.
Fo r t h e cu st o m e rs in Au st ra lia
The supply cord of the AC power adaptor cannot
be replaced; if the cord is damaged, the AC
power adaptor should be discarded.
1 Press ^.
After you have gone through the CD, “INTRO
PGM” stops flashing and the tracks you have
chosen play automatically.
To ch e ck t h e p ro g ra m
During programming:
Press REPEAT/ ENTER before step 5.
During RMS play:
Press PLAY MODE repeatedly until “RMS”
flashes, then press REPEAT/ ENTER.
Each time you press REPEAT/ ENTER, the
track number and the playing order appear in
the order you specified.
Not these ways
To a vo id e le ct rica l
sh o ck, d o n o t o p e n t h e
ca b in e t . Re fe r se rvicin g
t o q u a lifie d p e rso n n e l
o n ly.
Continue to the reverse side m
Fo r t h e cu st o m e rs n o t in Po la n d
To finish programming before going through
the whole CD, press ^. The selected tracks
will be played.
The
mark on the unit is valid only for
products marketed in Poland.
If you press p, the program will be erased.
To prevent accidental erasure, set the
RESUME switch to ON.
Fo r t h e cu st o m e rs n o t in Eu ro p e
The CE mark on the unit is valid
only for products marketed in the
European Union.
CAUTION
Note
The use of optical instruments with this product
will increase eye hazard.
2 Adjust the volume.
• If you program another track after the 22nd
track, the first track programed is cleared and
the new track is programed instead.
To cancel INTRO PGM play, press PLAY
MODE repeatedly until the play mode
indication disappears from the display.
Fo r t h e cu st o m e rs n o t in Ru ssia
To stop play, press p.
The
mark on the unit and package is valid
only for products marketed in Russia.
|