Sony Headphones XBA2 User Manual

How to use  
Using the supplied cord adjuster (see fig. )  
You can adjust the cord length by winding the cord on the cord adjuster.  
(The cord can be wound to the cord adjuster up to 50 cm (19 3/4 in). If you wind more,  
the cord comes off from the cord adjuster easily.)  
Stereo Headphones  
1
Wind the cord.  
Push cord into slot hole to secure in place.  
Operating Instructions  
2
Manual de instrucciones  
Note  
Do not wind the plug or split section of the cord, as it will strain the cord and may cause a wire break.  
Wearing the headphones (see fig. )  
1
Determine right and left headphone and hold them as in the illustration.  
There is a tactile dot on the unit marked to distinguish the left side.  
4-299-290-11(1)  
2
3
Fit the headphones into your ears snugly, as in the illustration.  
Adjust the headphone to fit snugly in your ear.  
©2011 Sony Corporation  
Printed in Thailand  
Installing the earbuds correctly (see fig. )  
If the earbuds do not fit your ears correctly, low-bass sound may not be heard. To enjoy  
better sound quality, change the earbuds to another size or type, or adjust the earbuds  
position to sit on your ears comfortably and fit your ears snugly. If the earbuds do not fit  
your ears, try another size or type. Confirm the size of the earbuds by checking the color  
inside (see fig. -for hybrid silicone rubber earbuds and -for noise isolation  
earbuds).  
XBA-2  
When you change the earbuds, install them firmly on the headphones to prevent the  
earbud from detaching and remaining in your ear.  
About hybrid silicone rubber earbuds (see fig. -)  
Earbud sizes (inside color)  
Small  
SS  
Large  
S
M
(Green)  
L
(Red)  
(Orange)  
(Light blue)  
To clean the hybrid silicone rubber earbuds  
Remove the earbuds from the headphones, and wash them with a mild detergent  
solution.  
2
1
About noise isolation earbuds (see fig. -)  
Supplied noise isolation earbuds provides a snug fit for effective attenuation of ambient  
noise.  
Earbud sizes (inside color)  
Small  
S
Large  
M
(Green)  
L
(Orange)  
(Light blue)  
Notes  
1
2
3
Prolonged use of the noise isolation earbuds may strain your ears due to their snug fit. If you have  
Earbud  
experience discomfort or pain in your ears, discontinue use.  
The pressure-relieving urethane cushion is extremely soft. Therefore, do not pinch or pull the  
urethane cushion. If the urethane cushion is broken or detached from the earbuds, it will not take its  
correct position and the earbuds will lose their noise isolation function.  
The pressure-relieving urethane cushion may deteriorate due to long-term storage or use. If the  
pressure-relieving power is lost and the urethane cushion becomes hard, the earbuds may lose their  
noise isolation function.  
Do not wash the noise isolation earbuds. Keep them dry, and avoid accumulation of water in the  
pressure-relieving urethane-cushions. Not doing so may cause early deterioration.  
Tactile dot  
To detach an earbud (see fig. -)  
While holding the headphone, twist the parts inside of the earbud and pull the earbud off.  
Tip  
If the earbud slips and cannot be detached, wrap it in a dry soft cloth.  
To attach an earbud (see fig. -)  
Push the parts inside of the earbud into the headphone until the projecting part of the  
headphone is fully covered.  
Sectional View  
Colored parts  
Removing the headphones  
After use, remove the headphones slowly.  
Pressure-relieving  
urethane cushion  
Note  
Headphones are designed to fit closely in your ears. If the headphones are pressed hard while in use or  
taken off too quickly, they may cause injury.  
Wearing headphones may produce a diaphragm click sound. This is not a malfunction.  
Specifications  
Type:  
Closed, Dual Balanced Armature  
Dual Balanced Armature  
100 mW (IEC*)  
Driver unit:  
Power handling capacity:  
Impedance:  
Sensitivity:  
Frequency response:  
Cord:  
12 Ω at 1 kHz  
108 dB**  
4 Hz – 25,000 Hz  
1.2 m (47 1/4 in), OFC litz cord neck-chain  
Gold-plated L-shaped stereo mini plug  
Approx. 6 g (0.21 oz) (without cord)  
Plug:  
Mass:  
Supplied accessories  
Hybrid silicone rubber earbuds: SS (red) (2), S (orange) (2), M (green) (attached to the  
unit at the factory) (2), L (light blue) (2) / Noise isolation earbuds: S (orange) (2), M  
(green) (2), L (light blue) (2) / Cord adjuster (winds cord up to 50 cm (19 3/4 in)) (1) /  
Carrying case (1) / Operating Instructions (1)  
* IEC = International Electrotechnical Commission  
**150 mV input  
Design and specifications are subject to change without notice.  
Precautions  
Please keep your headphones clean at all times especially inside the rubber earbud.  
(see fig. )  
If any dust or ear wax is inside the earbud, you may experience some listening  
difficulties.  
English  
Stereo headphones  
Listening with headphones at high volume may affect your hearing. For traffic safety,  
do not use while driving or cycling.  
Handle the driver units carefully.  
Do not put weight or pressure on the headphones as it may cause the headphones to  
deform during long storage.  
Features  
Newly developed Dual Balanced Armature driver unit  
Newly developed micro-size driver unit (full-range + woofer) reproduces smooth and  
clear vocal, with rich and powerful bass.  
The earbuds may deteriorate due to long-term storage or use.  
Install the earbuds firmly onto the headphones. If an earbud accidentally detaches and  
is left in your ear, it may cause injury.  
Newly developed Double Layered Housing  
Magnesium inner housing holds the driver units rigidly for smooth sound response.  
Special ABS plastic outer housing prevents unwanted vibration for clear mid-high  
range.  
Store the earbuds where children cannot reach in order to prevent from accidental  
ingestion or choking.  
Do not leave the stereo headphones in a location subject to direct sunlight, heat or  
moisture.  
Noise-blocking design  
Noise-blocking design attenuates ambient noise and sound leakage.  
Note on static electricity  
Super-small body  
In particularly dry air conditions, mild tingling may be felt on your ears. This is a result  
of static electricity accumulated in the body, and not a malfunction of the headphones.  
The effect can be minimized by wearing clothes made from natural materials.  
Balanced Armature driver unit allows for a super small body, and ultimate wearing  
comfort.  
Earbuds  
4 sizes of hybrid silicone rubber earbuds (SS, S, M, L), for secure fit and long-term  
Optional replacement earbuds can be ordered from your nearest authorized Sony  
wearing comfort.  
3 sizes of noise isolation earbuds (S, M, L), for effective attenuation of ambient noise.  
 

Shop Vac Vacuum Cleaner 86L650 User Manual
Snapper Blower SLB8621C User Manual
Solid State Logic Computer Hardware AR B7041 User Manual
Sony Camcorder 4264385111 User Manual
Sony Car Stereo System MDX 66XLP User Manual
Sony CD Player CDX 535RF User Manual
Sony PDAs Smartphones PEG N710C User Manual
Sony Projection Television 2 691 651 132 User Manual
Sunbeam Major Appliances Microwave Oven SNM1501RAB User Manual
Sylvania Flat Panel Television SRT4127FA User Manual