NAVIGATING THE SOLO2™ LCD SCREEN
QUICK REFERENCE GUIDE
NOTE: This guide is meant to be used only as a brief, general
reference. For complete operating instructions, always refer
to the Operator’s Manual.
Turning Concentrator On/Off
NOTE: For this procedure, refer to FIGURE 1.1.
1. To turn the SOLO2 concentrator on, press and hold the
On/Off button until the three warning lights display
and the unit beeps.
2. To turn the SOLO2 concentrator off, press and hold the
On/Off button
.
NOTE: GREEN light will flash and you will hear the machine stop
running.
On/Off
Button
Mode/Return/
Highlight Button
Menu Screens Navigation
NOTE: For this procedure, refer to FIGURE 1.1.
1. After turning on unit, press and hold the Mode/Return/
Highlight Button
to scroll through the three SOLO2
concentrator menu screens.
NOTE: Screens will continue scrolling until the Mode/Return/
Highlight Button is released.
Normal Operating/Standby Screen
The Normal Operating/Standby screen shows either battery
strength gauge, fan operating, external power on and battery
charging icons, when applicable, or the current/last mode of
operation and output flow level selected.
SOLO2™ Quick Reference Guide
1
2. To save changes made on the LCD Adjust screen:
A. Press and hold the Mode/Return/Highlight Button
until a different screen appears.
Mode & Flow Adjust Screen
The Mode & Flow Adjust screen allows user to change the
current mode of operation and output flow (FIGURE 1.3).
NOTE: To adjust either the mode or flow, the Mode & Flow Adjust
screen must be displayed. If the battery level screen is displayed,
press the Mode/Return/Highlight
, Up/Increase
, or
Down/Decrease button for approximately two seconds (screen
should change to Mode & Flow Adjust).
NOTE: Any changes to the setting will not take effect until after the
screen flashes three times.
Up/Increase
Button
Mode/Return/
Down/Decrease
Highlight Button
Button
Changing Mode
NOTE: For this procedure, refer to FIGURE 1.3.
1. With the Mode & Flow screen displayed, press and hold
the Mode/Return/Highlight Button
for one second.
2. Wait until the Mode & Flow screen flashes three times.
SOLO2™ Quick Reference Guide
3
Adjusting Flow
NOTE: For this procedure, refer to FIGURE 1.3.
1. With the Mode & Flow screen displayed, press and hold
the Up/Increase Button
or Down/Decrease Button
until desired setting is achieved.
2. Wait until the Mode & Flow screen flashes three times.
Invacare Corporation
USA
© 2010 Invacare Corporation. All rights
reserved. Republication, duplication or
modification in whole or in part is
prohibited without prior written
permission from Invacare. Trademarks are
identified by ™ and ®. All trademarks are
owned by or licensed to Invacare
Corporation or its subsidiaries unless
otherwise noted.
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
Technical Services
800-832-4707
Part No 1163220
Rev B - 01/10
|