Model EP035/EP035T2
THREE (3) YEAR LIMITED WARRANTY
EURO-PRO CORPORATION warrants this product to be free from defects in material
and workmanship for a period of three (3) years from the date of the original purchase.
This warranty applies only to normal domestic household use.
Should your appliance fail to operate properly while in use under normal household
conditions within the three (3) year warranty period, return the complete appliance and
accessories, freight prepaid to Euro-Pro Corporation at the address given below.
Turbo Hand Vac with
TAPCLEAN® HEPA Dust Cup Filter
In US:
EURO-PRO Corporation, 178 West Service Rd., Champlain, N.Y. 12919
In Canada:
EURO-PRO Corporation, 4400 Bois Franc, St. Laurent, Quebec, H4S 1A7
If the appliance is found by EURO-PRO to be defective in material or workmanship,
EURO-PRO will repair or replace it free of charge. Proof of purchase date and $ 9.95 to
cover the cost of return shipping and handling must be included. *
Non-durable parts including, without limitation, dust cup filters, filters, brushes and
electrical parts which normally require replacement are specifically excluded from
warranty.
OWNER’S MANUAL
Models EP035/EP035T2
120V., 60Hz., 6.67 Amps
The liability of EURO-PRO Corporation is limited solely to the cost of the repair or
replacement of the unit at our option. This warranty does not cover normal wear of parts
and does not apply to any unit that has been tampered with or used for commercial
purposes. This limited warranty does not cover damage caused by misuse, abuse,
negligent handling or damage due to faulty packaging or mishandling in transit. This
warranty does not cover damage or defects caused by or resulting from damages from
shipping or repairs, service or alterations to the product or any of its parts, which have
been performed by a repair person not authorized by EURO-PRO.
This warranty is extended to the original purchaser of the unit and excludes all other
legal and/or conventional warranties. The responsibility of EURO-PRO Corporation if
any, is limited to the specific obligations expressly assumed by it under the terms of the
limited warranty. In no event is EURO-PRO Corporation liable for incidental or
consequential damages of any nature whatsoever. Some states do not permit the
exclusion or limitation of incidental or consequential damages, so the above may not
apply to you.
This warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
*Important: Carefully pack item to avoid damage in shipping. Be sure to include
proof of purchase date and to attach tag to item before packing with your name,
complete address and phone number with a note giving purchase information,
model number and what you believe is the problem with item. We recommend you
insure the package (as damage in shipping is not covered by your warranty). Mark
the outside of your package “ATTENTION CUSTOMER SERVICE”. We are
constantly striving to improve our products, therefore the specifications
contained herein are subject to change without notice.
For information or assistance:
USA: EURO-PRO Corporation
178 West Service Rd.
Canada: EURO-PRO Corporation
4400 Bois Franc
Champlain, NY 12919
St. Laurent, QC H4S 1A7
Printed in China
7
OPERATING INSTRUCTIONS cont.
Cleaning & Changing the
GETTING TO KNOW YOUR SHARK HAND VACUUM
HEPA Dust Cup Filter
Warning: Always unplug the unit from
electrical outlet before opening the Dust
Cup (container).
Debris
Screen
HEPA Filter
Fig. 3
Important: Do NOT use the HEPA filter
cartridge without the debris screen in
place.
5. Vigorously “TapClean”
the HEPA Dust Cup
Filter on a hard
surface until no more
dust is observed
falling out from
between the pleats of
the filter. (fig. 4)
Fig. 4
Warning: After each Use - Always
remove the Filter Debris Screen from the
HEPA Dust Cup Filter, then vigorously
“TapClean” HEPA Filter until no more
dust can be removed.
IMPORTANT, Please Note : The
6. “TapClean” the Debris
Screen or rinse under
a faucet until clean.
(fig. 5) Remember that
the Debris Screen
must be completely
dry before reinstalling
in the vacuum.
“TapClean” HEPA Dust Cup Filter &
Debris Screen will stop most of the tiniest
dust particles and airborne allergens from
re-entering the air you breathe. In fact it
stops 99.97% of all particles as small as
0.3 microns - many times smaller than a
human hair!!! Because of this incredible
filtration performance, the HEPA Dust Cup
Filter will quickly accumulate, inside the
white filter folds, many fine dust particles
that are difficult to see but which will
eventually block or reduce your suction
power - if not cleaned properly. Clean the
HEPA Filter and Debris Screen after each
use as described in this section.
Fig. 5
Debris
Screen
7. Replace the Debris Screen on the
HEPA Dust Cup Filter and reinstall
filter assembly in the vacuum. (not
shown)
PLEASE NOTE: The white pleated
filter material in the HEPA Dust Cup
Filter will discolor over time -This is
NORMAL and will NOT affect the
performance of the filter. If the HEPA
Dust Cup Filter
is properly
"TapCleaned”
after each use
and suction
Debris Screen
HEPA Filter
1. To open the Dust Cup (container),
push button and detach the Dust
Cup (container ). (Fig. 1)
2. Pull out the HEPA Dust Cup Filter.
(Fig. 2)
Fig. A
Wash once a
month or when
suction
appears
11
5
does not return
to 100%, then
11
reduced.
6. Suction Hole
7. Shoulder Strap
1. Dust Cup Release Button
2. On/Off Power Switch
3. Handle
we suggest that
the HEPA filter
be “TapCleaned”
vigorously until no
more dust can be removed, then
rinsed under the faucet and allowed to
dry for 24 hours before refitting into
the vacuum. (Fig. A) Wash once a
month or when suction appears
reduced.
Warning: Allow 24
Fig. 1
Fig.2
hours for drying before
8. Pet Hair Removal Attachment
9. Cleaning Brush
replacing in unit.
3. Empty the dust from the Dust Cup
(container).
4. Separate the debris screen from the
HEPA filter cartridge by grasping the
debris screen with one hand and the
filter frame with the other and pull
apart. (fig. 3)
4. Intelli-Sense Filter MonitorTM
5. Dust Cup (Container)
10. Flexible Hose
11. Hepa Filter Assembly
Technical Specifications
Voltage:
Power:
120V., 60Hz.
6.67 Amps, 800 Watts
CAUTION: The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
2
5
PRECAUTIONARY MEASURES
OPERATING INSTRUCTIONS
Warning: Always unplug from electrical
4. To use the flexible hose, push
the end of the hose into the
suction hole, then attach the
desired brush to the other end
of the flexible hose, as shown
below.
Important: If the suction opening in the unit or the hose become blocked, switch off
the vacuum cleaner and remove the blocking substance before you start
the unit again.
outlet before opening the dust cup
(container).
Note: HEPA dust cup filter must be used
when operating the hand vacuum.
5. When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
1. Do not operate the vacuum
cleaner to close too heaters,
or radiators.
Using The Unit As A Hand
Vacuum
1. To open the dust
cup (container),
push button and
pull out the dust
cup. Verify that the
HEPA dust cup
filter is inside, then attach the
dust cup (container) to the
hand vacuum.
How To Operate Your
Hand Vacuum
1. Hold the hand vacuum firmly in your
hand by the Handle.
6. Do not pick up anything that is
burning or smoking such as
2. Push the On/Off Power Switch to “On”
position.
cigarettes, matches or hot ashes.
2. Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
3. Start vacuuming.
7. Do not use without HEPA dust cup
filter in place.
CAUTION: The Hand Vacuum is a
very powerful unit. Make sure that you
hold it firmly, otherwise it can slip out of
your hand and cause injury.
2. To use the Hand Vacuum with the
shoulder strap, attach it to the unit as
shown below.
8. Before you start vacuuming,
make sure to remove large or
sharp objects that might
NOTE: When the Intelli-Sense Filter
MonitorTM lights up, it means that the
dust cup is full or filter needs cleaning.
You must empty the dust from the dust
cup and clean the HEPA dust cup filter
right away. (See illustration below.)
damage the vacuum.
3. Do not vacuum any liquids.
4. Keep hair, loose clothing, fingers,
feet and all parts of body away from
openings.
3. To attach the oval brush or the pet
hair removal attachment to the
Hand Vacuum, push attachment
into the suction hole,
as shown
Important: This unit is equipped with a
motor protective thermostat. If for some
reason the vacuum cleaner should
overheat, the thermostat will automatically
turn the unit off. Should this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
below.
• Check the source of overheating
problem. (i.e. clogged hose or
filter)
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
NOTE: The pet hair removal
attachment is for use on upholstery,
drapes and other fabric surfaces to
remove lint, pet hair, etc. THE PET
HAIR REMOVAL ATTACHMENT IS
NOT INTENDED TO BE USED AS A
PET GROOMING DEVICE.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact EURO-PRO at
1-800-798-7398.
3
4
|