Rosewill Work Light RSL 113 User Guide

PIR Solar Spotlight/  
PIR Solaire Lumière  
RSL-113  
User Manual  
 
PIR Solar Spotlight/PIR Solaire Lumière RSL-113  
1 PIR Solar Spotlight parts  
battery back cover  
plug  
solar light  
head  
screw  
solar panel  
on/off switch  
socket  
solar light body  
screw*6  
bulged tube*6  
PIR sensor  
panel base  
2 Battery Charge  
In normal condition, the batteries inside the PIR Solar Spotlight are fully charged. You can  
use the light directly. If not, please fully charge the batteries before using: turn the switch  
“on” for sunny daytime and turn it “off” when darkness comes. Repeating for 2 days (about  
16 hours), the batteries would be fully charged.  
3 PIR Solar Spotlight Body Installation  
Install On the Wall  
1.loose the screws and remove the battery 2.drill 4 holes on the wall based on the  
back cover from the light  
four tubes in the battery back cover, insert  
the bulged tubes in the holes, and fix the  
battery back cover with screws.  
3.slip the PIR Solar Spotlight body up to 4.adjust the angle of light head & PIR  
down until the hasp inside is connected, fix sensor  
the body with screws.  
3
 
PIR Solar Spotlight/PIR Solaire Lumière RSL-113  
Install On the Pillar or Fence  
1.Insert the L-clip into the hole on the  
PIR Solar Spotlight body.  
2.Twist the butterfly nut to a proper position  
to fix the light on the pillar or fence.  
Remarks for Installation  
* The thickness of the fence or pillar is better to be more than 3.5cm  
* Do not install the light where people can be easily to be hurt in case of drop.  
* Install the light in horizontal level.  
4 Solar Panel Installation  
Install On the Pillar or Fence  
1.Take the solar panel and panel base.  
2.Drill two holes on the wall based in the  
holes in the panel base, then insert in the  
panel base, then insert the bulged tubes  
into the holes. Finally fix the panel base on  
the wall by screws.  
2.Twist the solar panel on the panel base.  
4
 
PIR Solar Spotlight/PIR Solaire Lumière RSL-113  
Install On the Pillar or Fence  
*Make sure the solar panel is installed where direct sunlight is sufficient.  
Make sure the panel is  
Be away from shadow of  
Be away from place where  
other night lights existing.  
45°from the horizontal level. trees or buildings.  
This angle can be adjusted.  
WARNING:  
please regularly check the panel and light after installation, to avoid any  
npredictable fire or electronic shock!  
5 Complete The Installation  
6 PIR Sensor Sense Range  
1.insert the wire plug into the socket on the  
bottom of the PIR Solar Spotlight body.  
2.turn the switch “on” after completing  
installation.  
Please check the following data for the  
sense range.  
Remarks: This sense range will verify with  
different environment, like temperature,  
place, climate etc.  
5
 
PIR Solar Spotlight/PIR Solaire Lumière RSL-113  
7 Replace the parts  
1. LED can’t be replaced  
2. Battery replacement  
* Turn the switch “off”  
* See 3. PIR Solar Spotlight body installation  
* Replace the batteries with 3pcs 1.2V AA  
1300mAh Ni-MH rechargeable batteries  
8 Problem Solving  
*Make sure the switch is “on”.  
*Make sure the panel is not broken.  
*Make sure the panel is installed in places free from shadow  
*Make sure the panel is not polluted by dirt. If have, please clean it with water by soft  
cloth. Do not use solvents. Take extreme care not to scratch the clear cover.  
9 Safety Guide  
*The PIR Solar Spotlight is waterproof on normal conditions, but please make sure it is  
not always exposed to a lot of water, or installed in some moist places, like bathroom.  
*Make sure hands are not wet when replacing the batteries.  
*Make sure not to reconstruct the PIR Solar Spotlight by yourself, to avoid any possible  
malfunction, fire or electronic shock.  
*Make sure the PIR Solar Spotlight is not installed where the temperature is too high.  
*Please notice that the Ni-MH batteries recharging capacity might decline under extreme  
low temperature.  
*The LED inside can not be replaced.  
10 Technical Data  
LED  
Battery  
2pc 1watt power LED (2 heads)  
3pcs 1300mAh Ni-MH batteries  
PIR sensor  
Sensor  
Sense  
About 6m*90°  
Light duration per sense  
Material  
25~35 seconds  
Plastic  
Wire length  
About 5m  
6
 
PIR Solar Spotlight/PIR Solaire Lumière RSL-113  
Thank you for purchasing a quality Rosewill Product.  
information and future support for your product.  
7
 

RCA DVD Recorder DRC8000N User Guide
Rockford Fosgate Stereo Amplifier 100X2 User Guide
Roland Electronic Keyboard SH 101 User Guide
Roland Musical Instrument SPD S User Guide
Rubbermaid Outdoor Storage 5H80 User Guide
Samsung Cell Phone GH68 05054A User Guide
Samsung CRT Television CL 29A5P, CL 29A5W, CL 29A6P, CL 29A6W, CL 29A7P, CL 29A7W, CL 29M6P, CL 29M6W, CL 34M9P User Guide
Samsung Refrigerator RB215LABP User Guide
Sanyo DVR VA SW8000 User Guide
SECO LARM USA Telephone E 920A User Guide