CN753W05EM1 V.qxd
9/13/05 16:30 Page 1
SERVICE INSTRUCTIONS
1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void the Warranty.
2. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where you
purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed Warranty.
3. If you have any questions or comments regarding this unit’s operation or believe any repair is necessary, please write to our
Adjustable Can
Opener
RIVAL
c/o JCS/THG, LLC
CONSUMER SERVICE DEPARTMENT
13120 JURUPA AVENUE
FONTANA, CA 92337
ONE (1) YEAR LIMITED WARRANTY
SAVE THIS WARRANTY INFORMATION
CN753-W
A. This Warranty applies only to the original purchaser of this product.
B. This Warranty applies ONLY to repair or replacement of any supplied or manufactured parts of this product that,
upon inspection by JCS/THG, LLC authorized personnel, is shown to have failed in normal use due to defects in
material or workmanship. JCS/THG, LLC will determine whether to repair or replace the unit. This Warranty does
not apply to installation expenses.
C. Operating this unit under conditions other than those recommended or at voltages other than the voltage
indicated on the unit, or attempting to service or modify the unit, will render this WARRANTY VOID.
D. Unless otherwise proscribed by law, JCS/THG, LLC shall not be liable for any personal injury, property or any
incidental or consequential damage of any kind resulting from malfunctions, defects, misuse, improper installation
or alteration of this product.
E. All parts of this product are guaranteed for a period of 1 year as follows:
1. Within the first 30 days from date of purchase, the store from which you purchased your product should
replace this product if it is defective in material or workmanship (provided the store has in-stock
replacement.). If you intend to assert any claim in connection with the product, please follow the instructions
in paragraph F.
2. Within the first twelve months from date of purchase, JCS/THG, LLC will repair or replace the product if it is
defective in material or workmanship, subject to the conditions in paragraph G.
F. If you have any other problem or claim in connection with this product, please write to our Consumer Service
Department.
G. IMPORTANT RETURN INSTRUCTIONS. Your Warranty depends on your following these instructions if you are
returning the unit to JCS/THG, LLC:
1. Carefully pack the item in its original carton or other suitable box to avoid damage in shipping.
2. Before packing your unit for return, be sure to enclose:
a) Your name, full address with zip code and telephone number,
b) A dated sales receipt or PROOF OF PURCHASE,
c) A check for return prepaid shipping and handling, and
d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to
the unit before the box is sealed.)
3. JCS/THG, LLC recommends you ship the package U.P.S ground service for tracking purposes.
4. All shipping charges must be prepaid by you.
5. Mark the outside of your package:
RIVAL
c/o JCS/THG, LLC
13120 JURUPA AVENUE
FONTANA, CA 92337
Owner’s Guide
READ AND SAVE THESE INSTRUCTIONS
This Warranty gives you specific legal rights, and you may have other rights may vary by jurisdiction. The provisions of this
Warranty are in addition to, and not a modification of, or subtraction from, the statutory warranties and other rights and
remedies contained in any applicable legislation. To the extent that any provision of this Warranty is inconsistent with any
applicable law, such provision shall be deemed voided or amended, as necessary, to comply with such law.
©2005 JCS/THG, LLC
Rival® and The Rival Logo® are trademarks of JCS/THG, LLC.
Printed in China
CN753W/9100140000052
CN753W05EM1
CN753W05EM1 V.qxd
9/13/05 16:30 Page 5
ADJUSTABLE FEATURE
HOW TO SHARPEN KNIVES
DO NOT ATTEMPT TO SHARPEN HOLLOW GROUND BLADES OR
THOSE WITH SERRATED EDGES.
1. Be sure knife is clean and free of grease.
2. Place heel of knife into the guide slot located on
the back of the can opener. Lightly draw the
blade towards you, applying a slight downward
pressure. Repeat this procedure four to five times
to put on a "factory sharp" edge.
1. To open a tall can, place right hand on the top left side of the unit.
Push the button on side of the can opener as
shown, The can opener will pop-up automatically
to its full height. Note: Be sure unit locks in place
with a "click.".
2. After opening can, hold button in and push
down on top of the unit until it locks in place for
a compact look.
HOW TO OPEN CANS
HOW TO CLEAN BLADE ASSEMBLY
1. Plug cord into 120 volt, AC outlet.
NEVER SUBMERGE CAN OPENER IN WATER.
2. Raise piercing lever enough to wedge can between cutting blade and
1. Unplug cord. Lift piercing lever to vertical position as shown below.
Hold appliance and ease cutting assembly out of case. Wash in hot,
soapy water. Rinse and dry. Do not wash in automatic dishwasher.
2. To replace blade assembly, hold piercing lever in vertical position.
Insert shaft into key hole. Push in piercing lever
all the way. Rotate piercing lever clockwise until
it is horizontal. If lever is properly engaged, it
cannot be removed from can opener when in
horizontal position.
feed gear as shown below.
3. Press lever down all the way to pierce lid and start cutting action.
"Power pierce" feature: When you press down on the lever, motor will
start rotating can for easier piercing.
4. Let go of lever and can opener will continue
cutting and will stop automatically when can
has been opened. (It is normal for motor to
occasionally continue cutting action for a few
seconds after lid has been severed).
HINT: Cutting mechanism may collect food or
paper from can labels, and should be washed
frequently.
5. To remove can, grasp it firmly and raise lever.
Slide lid from magnet.
TO OPEN EXTRA TALL CANS
1. If there is a dent in the rim of the can, open other end.
2. To open cans over 2 lbs., hold top of can opener to stabilize it.
3. Unit will not open rimless cans.
-4-
-5-
CN753W05EM1 V.qxd
9/13/05 16:30 Page 7
NOTE
NOTE
-6-
-7-
|