■ Use this shaver only for its intended use as
described in this manual. Do not use attach-
ments not recommended by the manufacturer.
IMPORTANT SAFETY
INSTRUCTIONS
®
■ Keep the cord away from heated surfaces.
■ Never operate this shaver if it has a damaged
cord or if it is not working properly, if it has
been dropped or damaged, or dropped into
water. Return the shaver to a service
center for examination and repair.
■ Never drop or insert any object into any
opening.
■ Do not use outdoors or operate where aerosol
(spray) products are being used or where
oxygen is being administered.
When using an electric shaver, basic precautions
should always be observed, including the following.
Read all instructions before using this shaver.
How to get a great shave
from your Remington®
MicroScreen® 3 Shaver
Thank you for buying this premium
shaver from Remington®.
DANGER
To reduce the risk of electric shock:
Inside you'll find tips on using and
caring for your shaver to get the
best shave possible.
■ Do not reach for a shaver that has fallen into
water. Unplug immediately.
■ Do not use while bathing or in a shower.
■ Do not place or store shaver where it can fall or
be pulled into a tub or sink. Do not place in or
drop into water or other liquid.
■ Except when charging, always unplug this
shaver from the electrical outlet immediately
after using.
■ Do not use this shaver with a damaged or bro-
ken cutter or head, as facial injury may occur.
■ Always attach plug to shaver, then to outlet.
To disconnect, turn all controls to “Off,” then
remove plug from outlet, then detach power
cord from the shaver for storage.
■ Always store your shaver and cord in a
moisture-free area. Make sure your cord is
disconnected from the shaver.
■ Unplug this shaver before cleaning.
■ “Household Use Only”.
WARNING
To reduce the risk of burns, fire, electric shock, or
injury to persons:
■ A shaver should never be left unattended when
plugged in, except when charging your
rechargeable shaver.
■ Close supervision is necessary when this
shaver is used by, on, or near children
or invalids.
SAVE THESE
INSTRUCTIONS
Charging: GREEN LED appears when shaver is plugged in and
charging.
■ Every six months, lubricate the trimmer
teeth by applying a drop of light machine oil
one-third and two-thirds of the way along
the blade. Using your finger tip, spread the
oil along the teeth, and run the trimmer for
a few seconds.
Cordless: When the shaver is operating from the battery in a fully charged
state, the LED will appear GREEN. The LED will gradually change to
AMBER as the battery is depleted. When approximately two shaves
remain, the LED will change from AMBER to RED.
Removing the Headguard
Before operating your MicroScreen®
3 Shaver, remove the headguard,
which protects the foils and cutter
assembly. It is important to remove
the headguard correctly to avoid
damaging the clips that hold it
firmly to the shaver.
Troubleshooting
■ If your TA-4570/5570 shaver battery is completely discharged or the
shaver has not been used for an extended period of time, the shaver
may not start when operated using the cord. If this condition occurs,
charge the shaver for approximately five minutes before shaving.
Replacing Foils and Cutters
Because they are subject to daily use, the cutters and foils of
your Remington® MicroScreen® 3 Shaver will wear and eventually
require replacement to maintain a close, comfortable shave.
Depending on your shaving technique and habits, the foils will
usually last six months; the cutters, one year. Some signs that
your foils and cutters need replacing are:
■ Press lightly on the top of
the headguard.
■
Your TA-4570/5570 cord/cordless shaver should not be used
■ Lift the lower rear edge.
■ Pull the headguard away from the shaver.
strictly as a cord-operated shaver, as continued cord only use will
result in reduction of battery life.
■ In order to preserve the life of the batteries, they should be fully
discharged every six months and then fully charged for 24 hours.
Cordless Operation
■ Irritation. As foils get worn, you may notice your skin feeling
more sensitive after a shave, particularly when you apply after-
shave.
■ Pulling. As cutters wear, your shave may not feel as close,
and you may feel your shaver is pulling at your whiskers.
■ Wear-through. You may notice that the cutters have worn
through the foil.
The TA-3070/4570/5570 shavers are designed for
cordless operation and can be recharged easily. For
cordless operation, just press the locking bar in the
center of the On/Off button and push the button
toward the head of the shaver.
Dual Voltage
®
You can take your MicroScreen 3 shaver with you when you travel
®
just about anywhere in the world. your MicroScreen 3 shaver
features worldwide automatic dual voltage conversion providing AC
current between 100-240 volts, 50-60 Hz. Just plug it in to the local
outlet (you may need an adapter plug) and use as usual. Your shaver
will convert automatically to the local current requirements.
Charging
Prior to using your shaver for the first time, put it
on charge for 24 hours. To charge your shaver:
To prevent inadvertent damage to the Foils and Cutter
Assembly, do not attempt to remove them unless you
are replacing them. To remove the old foil and cutters follow
the instructions that come with the foil and cutter replacement
package. It's always a good idea to replace the foils when you
replace the Cutter Assembly.
■
■
Slide the On/Off button to the “Off” position.
Connect the cord to the shaver and then to the
The following procedures should
be followed for battery removal:
■ Make sure your shaver is unplugged from
any outlets,so you don't risk an electrical
shock.
electric outlet. The charging indicator light will glow
green, indicating your shaver is charging.
■
The TA-4570 charging indicator will begin to
flash slowly as the shaver reaches full charge.
Your shaver cannot be overcharged, so you can
leave it plugged in and charging between shaves.
Use only the cord supplied with shaver. The TA-
■ Remove the head assembly by gently lifting
the assembly away from the shaver.
To Replace a Cutter
Assembly That is Removed
Unintentionally:
■ Hold the assembly in the middle
of the "T."
■ Gently place the forked legs into
the opening at the top of the oscilla-
tor tips.
■
■ Using a small Phillips head screwdriver, remove the four screws
from the upper and lower back of the shaver.
■
3070 is designed for cordless operation only. Plug-
ging in the cord will not provide the power to shave.
■ Pull or gently pry the shaver halves apart,exposing the battery.
■ Lift the rubber Side Panels from their cradles and put
them aside.
The TA-4570/5570 on the other hand, comes with a
special feature that allows you to shave while your
shaver is being recharged. Just follow the steps
above to plug in the cord. Turn on the shaver by
pressing on the locking bar and sliding the On/Off
button upward. Your shaver will not recharge while
you are shaving, so after shaving, leave it plugged in
so it can be recharged.
■ Hold each battery in place and very carefully slide the clips
from the terminals on each battery.
■ Lift or pry the battery out of the shaver.
■ Do not push downward on the ends of the cutters, as you
may bend the cutter, reducing its ability to operate smoothly.
■ Do not remove cutters from the plastic pieces to which they
are attached, as you may damage the assembly.
CAUTION:THESE NICKEL-CADMIUM BATTERIES MUST BE RECY-
CLED OR DISPOSED IN ACCORDANCE WITH STATE AND LOCAL
REGULATIONS.Do not burn or mutilate,as they may burst or
release toxic materials.Do not short-circuit,as it may cause burns.
■
The TA-4570/5570 will provide a week’s worth of
shaving after a one hour charge or a single shave after
five minutes of charging.
Battery Removal
Remington® Money-Back Offer
®
The EPA certified RBRC Battery Recycling Seal on the nickel-cadmium
(Ni-Cd) battery indicates Remington is voluntarily participating in an
industry program to collect and recycle these batteries at the end of their
useful life, when taken out of service in the United States or Canada. The
You have just bought one of the finest
shavers available today. If for any reason
within 30 days from when you purchased
®
®
®
RBRC program provides a convenient alternative to placing used Ni-
Cd batteries into the trash or the municipal waste stream, which may be
illegal in your area. Please call 1-800-8-BATTERY for information on
Ni-Cd battery recycling and disposal bans/restriction in your area.
Remington involvement in this program is part of our commitment to
preserving our environment and conserving our natural resources.”
your Remington MicroScreen 3 Shaver,
you are not satisfied with your shaver and
would like a refund, just return your
shaver, together with the sales receipt,
to the retailer from whom you purchased
it. Remington will reimburse all retailers
who accept shavers within 30 days of
purchase. If you have any questions
regarding this money-back guarantee,
please call 1-800-736-4648.
™
Full One-Year Warranty
Remington warrants that your product, except as noted below, is,on
date of purchase, free from defect in material and workmanship.
Remington will correct any such defect without charge if you return
the complete product either in person or by mail, postage paid, to a
Remington Company-owned Service Center or Authorized Service
Dealer within one year after date of purchase.
Do not return the product to the retailer from whom the product
was purchased.
Re m in g to n M ic r o Sc r e e n ® 3 M o d e ls
W h ic h m o d e l is yo u r s ?
This warranty does not cover damage by accident, misuse,abuse or
by affixing an unauthorized accessory or alteration to the product, or
by connection of the product to any but the specific current and volt-
age indicated in an accompanying instruction booklet, or by any
other conditions beyond our control. REMINGTON SHALL NOT BE
RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL
DAMAGES.
Cordless, rechargeable operation with
TA-3070
charging indicator light. Dual voltage
105-130 volts, AC 60 Hz, 105-240
volts, AC 50 Hz.
IN ADDITION,THIS WARRANTY DOES NOT COVER THE FLEXIBLE
SCREENASSEMBLY ON OUR FOIL TYPE SHAVERS.
Cord and cordless, rechargeable
TA-4570
ALL IMPLIED WARRANTIES INCLUDING BUTNOT LIMITEDTO IMPLIED
WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN
DURATION TO ONE YEAR FROM DATE OF ORIGINAL PURCHASE.
operation with charging indicator
light and quick 5 minute and 1-hour
charging. Dual voltage 100-240 volts,
AC 50-60 Hz.
This warranty gives you specific legal rights, and you may also have
other rights that vary from state to state. Some states do not allow
the exclusion limitation of incidental or consequential damages or
limitations on how long an implied warranty lasts, so that the above
limitations and exclusions may not apply to you.
Cord and cordless, rechargeable
TA-5570
operation with ColorView™ Power
indicator. Quick 5 minute and one-
hour charging features. Dual voltage
100-240 volts, AC 50-60 Hz.
No responsibility,obligation,or liability is assumed for the installation
or maintenance of this product.
Warranty service must be performed by a Remington Company-
owned Service Center or Authorized Service Dealer and damage or
loss of any kind resulting from servicing by any other person is not
covered under warranty. Enclosed is a listing of Company-owned
Service Centers. Authorized Service Center Dealers may be found
in the yellow pages of your directory. If you wish, you may mail
the product, postpaid,to Remington Products Company L.L.C., 60
Main Street, Bridgeport,CT 06604 Attention:Service Department.
U.S. Warranty Service
In the United States, service is provided
by our Company-owned Service Centers
and over 300 Authorized Service Dealers.
The addresses of our Company-owned
Service Centers are enclosed. For the
address of your nearest Authorized Service
Dealer, please consult the Yellow Pages
under “Shaver - Electric - Repair.” If you
wish, you may mail the product, postpaid,
to Remington Products Company L.L.C.,
60 Main Street, Bridgeport, CT 06604,
Attention: Service Department.
International Warranty Service
Service under the Remington warranty can
be obtained outside the United States by
Remington-Authorized Distributors and
Service Dealers. Please consult your local
telephone directory for the nearest location.
For questions or comments, please write:
Remington Products Company, L.L.C.
P.O. Box 1536,
Horsham,PA 19044-6536
Attention:Consumer Affairs
Questions or Comments: Please call 1-800-736-4648.
Remington,MicroScreen and
ShaverSaver are trademarks of
Remington Corporation,L.L.C.
P R O D U C T S C O M PA N Y, L . L . C .
© 1998 RPC, L.L.C.Rev 8/98
Part No.12640
60 Main Street Bridgeport, CT 06604
|