Radio Shack Two Way Radio FRS 106 User Guide

21-1806.fm Page 1 Thursday, August 5, 1999 2:35 PM  
Owner’s Manual  
Cat. No. 21-1806  
SPECIFICATIONS  
Channels ................................................................. 14  
Quiet Codes ..........................Standard CTCSS Tones  
Output Power .........................................500 mW ERP  
Battery Life:  
(Alkaline) ................................... 30 Hours (2300 mAh)  
(NiCd)............................................ 8 Hours (600 mAh)  
Frequencies:  
Frequency  
(MHz)  
Frequency  
(MHz)  
Channel  
Channel  
1
2
3
4
5
6
7
462.5625  
462.5875  
462.6125  
462.6375  
462.6625  
462.6875  
462.7125  
8
9
467.5625  
467.5875  
467.6125  
467.6375  
467.6625  
467.6875  
467.7125  
10  
11  
12  
13  
14  
FRS-106  
n No License Required!  
Specifications are typical; individual units might vary.  
Specifications are subject to change and improvement  
without notice.  
n Flip-Phone Styling for Discreet Use  
n Clear Communications  
Up to Several Miles  
RadioShack Limited Warranty  
n Automatic Power Save  
n Automatic Squelch  
n Quiet Channel Feature  
n Audible Page  
This product is warranted against defects for 90 days from  
date of purchase from RadioShack company-owned stores  
and authorized RadioShack franchisees and dealers.  
Within this period, we will repair it without charge for parts  
and labor. Simply bring your RadioShack sales slip as  
proof of purchase date to any RadioShack store. Warranty  
does not cover transportation costs. Nor does it cover a  
product subjected to misuse or accidental damage.  
EXCEPT AS PROVIDED HEREIN, RadioShack MAKES  
NO EXPRESS WARRANTIES AND ANY IMPLIED WAR-  
RANTIES ARE LIMITED IN DURATION TO THE DURA-  
TION OF THE WRITTEN LIMITED WARRANTIES  
CONTAINED HEREIN. Some states do not permit limita-  
tion or exclusion of implied warranties; therefore, the afore-  
said limitation(s) or exclusion(s) may not apply to the  
purchaser.  
RadioShack welcomes you to the next genera-  
tion of personal communication the Family  
Radio Service (FRS). FRS is a new license-  
free, two-way, short-range voice radio service  
that lets families and groups keep in touch with  
each other on specific reserved channels.  
This warranty gives you specific legal rights and you may also have  
other rights which vary from state to state.  
We Service What We Sell  
10/95  
RadioShack  
A Division of Tandy Corporation  
Fort Worth, Texas 76102  
10A6  
Printed in Thailand  
 
21-1806.fm Page 3 Thursday, August 5, 1999 2:35 PM  
USING THE QUIET FEATURE  
INSTALLING BATTERIES  
The quiet feature lets you talk and listen to peo-  
ple who are using other radios set to the same  
channel and quiet code. This is like having a  
sub-channel within a channel, giving you great-  
er communication flexibility. When you set a qui-  
et code (38 to choose from) and turn on this  
feature, you can communicate with anyone who  
has a radio set to the same channel and code.  
Your radio uses four AA batteries for power.  
You can use alkaline or rechargeable batteries.  
(If you use rechargeable batteries, you must  
charge them before you can use them in the ra-  
dio).  
Caution:  
Do not mix old and new batteries, dif-  
ferent types of batteries (standard, alkaline, or  
rechargeable), or rechargeable batteries of dif-  
ferent capacities.  
1. Select a channel to add a code to.  
2. Hold down FUNC, then press STORE.  
*
Be sure the radio is off, then remove the battery  
compartment as shown below. Slide the battery  
holder in either direction and install the batteries  
as indicated by the polarity symbols (+ and –)  
inside the compartment.  
TONE TX /RX  
QUIET  
,
, and  
appear on the display. The code number  
appears instead of if the channel is  
already programmed with a code.  
TX /RX  
*
means transmit/receive  
3. Repeatedly press CHANNEL or  
until  
you see the code number you want to  
select.  
4. Hold down FUNC, then press STORE or  
PTT to store the code.  
(illus - show batteries being  
installed in battery pack. Show  
battery pack being removed from  
radio (arrow pointing to removal latch).  
Also show polarities on batteries/pack  
and directions of travel of battery  
retainer slide)  
Now, select a channel where you stored a code  
QUIET  
to use the quiet code.  
appears on the  
display. Press QUIET until QUIET disappears  
to disable the quiet code on the selected chan-  
nel. Press QUIET again to re-enable it.  
To clear a quiet code from a channel, repeat  
Steps 1–4, pressing CHANNEL  
3 until appears.  
or  
in Step  
To set one code for the transmit side of a chan-  
nel and a different code for the receive side, re-  
peat Steps 1–3 (select the receive code in Step  
Slide the battery holder to the center of the bat-  
tery compartment, then snap the battery com-  
partment onto the radio.  
3) then press STORE. TONE  
ap-  
ap-  
or  
/RX  
TONE TX  
pears. Press STORE again.  
pears. Then repeatedly press CHANNEL  
to select the transmit code, hold down FUNC,  
then press STORE.  
6
3
 
21-1806.fm Page 4 Thursday, August 5, 1999 2:35 PM  
USING THE RADIO  
To hear everything happening on a channel, including  
weak transmissions and radios set to a different quiet  
BUSY  
code, hold down M (monitor).  
appears on the  
To talk  
, hold down PTT  
display. Release M to turn auto-squelch back on.  
(push to talk) and speak  
into the microphone.  
appears on the dis-  
Speaker  
TX  
play. When you finish  
speaking, release PTT.  
Display  
See “Using the  
Quiet Feature” on  
Page 6.  
You can cause a paging tone to sound  
on all radios tuned to the same channel  
(and quiet code, if used). To send a  
page, hold down CALL (for up to 10 sec-  
onds).  
flashes on the display.  
TX  
(illus -  
show  
radio  
To control the volume  
To select a channel  
To turn the radio  
To light the display  
turned  
slightly  
sideways  
to show M  
and PTT  
keys)  
Used as a flip phone, the volume  
is automatically reduced  
on and off  
, hold  
this down for about  
1 second.  
You can lock most of the  
radio’s keys so they don’t  
work until you unlock  
them, to avoid acciden-  
tally changing the radio’s  
settings. To lock and  
Used as a 2-way radio, you hear  
full volume  
unlock the front panel  
keys (except ON/OFF,  
VOLUME  
/
, and  
. LOCK  
Microphone  
Important:  
Do not hold the radio’s  
), press  
speaker against your ear with this key  
cover closed. The radio is automati-  
cally set to a high volume when the key  
cover is closed.  
appears on the display  
when the keys are  
locked.  
4
5
 

PYLE Audio TV Mount PSW449T User Guide
QVS TV Converter Box IC 485S User Guide
Radio Shack Cordless Telephone 43 5862 User Guide
Radio Shack Scanner PRO 2056 User Guide
RCA TV Receiver HD52W68 User Guide
Remotec Universal Remote 1279041 User Guide
Saeco Coffee Makers Espresso Maker RI9737 User Guide
Sakar Digital Camera 93045 User Guide
Samsung Cell Phone SPH M930 User Guide
Samsung Printer ML 1610 User Guide