63-973.fm Page 1 Friday, January 7, 2000 7:45 AM
Cat. No. 63-973
OWNER’S MANUAL
Please read before using this equipment.
Radio-Controlled Clock
with Thermometer
63-973.fm Page 3 Friday, January 7, 2000 7:45 AM
PREPARATION
Notes:
• When BATT flashes on the display,
INSTALLING BATTERIES
Your clock requires two AA batteries
(not supplied) for power. For the best
operation and longest life, We recom-
mend RadioShack alkaline batteries.
replace the batteries with fresh
ones.
• If the clock does not operate after
you install the batteries, remove
them and wait about five seconds
until the display clears. Then rein-
stall the batteries.
Cautions:
• Use only fresh batteries of the
required size and type.
As soon as you install the batteries, all
display segments briefly appear. Then
AM 12:00 and the seconds display ap-
pear. 1M1D appears, indicating January
1, and the clock displays the current in-
door temperature. To change the dis-
play language, see “Manually Setting
the Time, Date, and Language” on
Page 6.
• Do not mix old and new batteries,
different types of batteries (stan-
dard, alkaline, or rechargeable), or
rechargeable batteries of different
capacities.
1. Pull the tab on the battery compart-
ment cover at the back of the clock
to remove the cover.
For about 2 minutes after you install the
batteries, the clock scans for the radio
signal while flashes.
2. Place the batteries in the compart-
ment as indicated by the polarity
symbols (+ and –) marked inside.
3. Replace the cover.
3
63-973.fm Page 4 Friday, January 7, 2000 7:45 AM
The clock also automatically shows a
time zone to the left of the time. While
the clock is scanning for a signal, you
can set it (if necessary) to show your
time zone. To change the time zone, re-
peatedly press ZONE until the desired
time zone (PACIFIC, MOUNTAIN,
CENTRAL, or EAST) appears.
Mounting the Clock on a Wall
To mount the clock on a wall, you need
1
a /8-inch (3-mm) screw (not supplied)
with a head that fits into the keyhole slot
on the back of the clock.
1. Drill a hole in the wall at the desired
mounting location.
Note: You must reset the time zone
each time you install batteries.
2. Thread a screw into the wall until the
head extends about 1/4 inch from the
wall.
3. Position the keyhole slot over the
screw and slide the thermometer
down to secure it.
MOUNTING
You can place the clock on a flat surface
using the built-in stand, or mount it on a
wall using a screw (not supplied).
Keyhole Slot
Selecting a Location
Choose an indoor location:
• where the clock will not be in direct
sunlight
• away from heat or cold sources
such as stoves, heating and air con-
ditioning vents, and radiators
SETTING THE TIME
• not near a TV, high power cable, or
metal table (because these could
interfere with radio signal reception)
Automatic Time/Date Setting
The clock checks the radio signal six
times a day, at about 2:00 AM, 3:00 AM,
4:00 AM, 9:00 AM, 3:00 PM, and 9:00
PM (as shown on the clock). When the
clock receives a good signal, it automat-
ically sets the time and date.
Using the Stand
To set the clock on
a flat surface, pull
the built-in stand
away from the back
of the clock.
4
63-973.fm Page 5 Friday, January 7, 2000 7:45 AM
Checking the Signal Status
The clock displays these symbols to indicate the current or last status of radio signal
reception.
The clock received a radio signal strong enough to set the date
and time within the last 96 hours.
The clock has not received a radio signal strong enough to set the
date and time within the last 96 hours. Reposition the clock before
2, 3, 4, or 9 AM, or 3 or 9 PM, or set the date and time manually.
The displayed time has been manually set.
No indicator
Automatic time setting is turned off. Remove and replace the bat-
teries, or use a pointed object (such as a straightened paper clip)
to press RESET.
The clock is receiving the radio signal and the time/date will be set
shortly.
The clock is receiving a signal, but reception is not strong enough
to set the clock. Reposition or rotate the antenna bar before the
antenna symbol stops blinking (about 2 minutes).
Notes:
• On very cloudy and stormy days, the signal might not be strong enough to reset
the clock.
• If the clock does not receive a strong signal within about 2 minutes, it stops scan-
ning and looks for a signal again at the next preprogrammed time (see “Turning
Off Automatic Time Setting” on Page 6).
5
63-973.fm Page 6 Friday, January 7, 2000 7:45 AM
Turning Off Automatic Time
Setting
ZONE
ALARM
CLOCK
8
If you move to an area where the time-
setting signal is unavailable, you can
turn off automatic time setting. Hold
down ZONE for about 3 seconds until
disappears.
ON/OFF
Manually Setting the Time,
Date, and Language
6. Press CLOCK. The year digits flash.
When you turn off automatic time setting
or if the clock does not receive a good
radio signal, you can set the time and
date manually.
7. Repeatedly press 8 to advance
the year setting.
8. Press CLOCK. The month digits
flash.
Important: Good radio signal reception
overrides the manual setting. If you do
not want this to happen, turn off auto-
matic time setting. (See “Turning Off Au-
tomatic Time Setting.”)
9. Repeatedly press 8 to advance
the month digits.
10. Press CLOCK. The date digits flash.
11. Repeatedly press 8 to advance
the date digits.
Note: If you do not press a button for
about 2 minutes, the clock returns to the
current time display.
12. Press CLOCK. A letter representing
the language used for the day of the
week flashes.
1. Repeatedly press ZONE to select
13. Repeatedly press 8 to select the
desired language (E = English, F =
French, S = Spanish).
the desired time zone.
2. Hold down CLOCK until the hour dig-
its flash.
14. Press CLOCK to store the setting.
The time, month, and date appear.
3. Repeatedly press (or hold down) 8
to advance the hour digits.
Note: AM appears for an AM time
and PM appears for a PM time.
4. Press CLOCK. The minute digits
flash.
5. Repeatedly press 8 to advance
the minute digits.
6
63-973.fm Page 7 Friday, January 7, 2000 7:45 AM
OPERATION
To switch between the seconds display
and the day of the week, press CLOCK.
Turning the Alarm On/Off
To turn on the alarm, press
ON/OFF
To switch between viewing the month/
date and the alarm time, press ALARM
(see “Using the Alarm”).
so
appears.
At the set alarm time,
flashes on the
display and the alarm sounds one soft
beep every 2 seconds. To silence the
To view the time in another time zone,
press ZONE until the desired time zone
appears.
alarm, press ALARM.
remains on the
display and the alarm sounds at the set
alarm time the next day.
If you do not silence the alarm, after 20
seconds, two quick beeps sound every 2
seconds and the volume increases
slightly. After 20 more seconds, three
quick beeps sound every 2 seconds and
the volume increases to its maximum
level. After another 20 seconds, the
beeping becomes continuous (about
four beeps per second) for about 1
minute.
USING THE ALARM
Setting the Alarm Time
1. Hold down ALARM until the alarm
hour digits flash.
2. Repeatedly press (or hold down) 8
to advance the hour digits.
Notes:
• AM appears for an AM time and
After 2 minutes, the alarm turns off auto-
matically. The first time this happens,
the snooze feature activates and
continues to flash. In about 8 minutes,
the alarm sounds again. If the alarm
turns off automatically a second time,
remains on the display and the alarm
will sound again at the set alarm time
the next day.
PM appears for a PM time
•
appears as soon as you press
8.
3. Press ALARM. The minute digits
flash.
4. Repeatedly press 8 to advance
the minute digits.
5. Press ALARM to store the setting.
To turn off the alarm, press
so disappears.
ON/OFF
The alarm time remains displayed.
Notes:
• To switch between viewing the
alarm time and the month/date,
press ALARM.
• The alarm time does not need to be
displayed for the alarm to sound.
7
63-973.fm Page 8 Friday, January 7, 2000 7:45 AM
USING SNOOZE
When the alarm sounds, you can press
((SNOOZE)) to silence the alarm for
about 8 minutes.
flashes on the dis-
play. After 8 minutes, the alarm sounds
again. You can use the snooze feature
repeatedly for up to 24 hours.
((SNOOZE))
8
63-973.fm Page 9 Friday, January 7, 2000 7:45 AM
CARE AND MAINTENANCE
Your
is an example of su-
RadioShack Radio Controlled Clock with Thermometer
perior design and craftsmanship. The following suggestions will help you care for
your clock so you can enjoy it for years.
Keep the clock dry. If it gets wet, wipe it dry immediately. Liquids might
contain minerals that can corrode the electronic circuits.
Use and store the clock only in normal temperature environments.
Temperature extremes can shorten the life of electronic devices, dam-
age batteries, and distort or melt plastic parts.
Keep the clock away from dust and dirt, which can cause premature
wear of parts.
Handle the clock gently and carefully. Dropping it can damage circuit
boards and cases and can cause the clock to work improperly.
Use only fresh batteries of the required size and recommended type.
Batteries can leak chemicals that damage your clock’s electronic parts.
Wipe the clock with a damp cloth occasionally to keep it looking new.
Do not use harsh chemicals, cleaning solvents, or strong detergents to
clean the clock.
Modifying or tampering with the clock’s internal components can cause a malfunc-
tion and might invalidate its warranty. If your clock is not performing as it should,
take it to your local RadioShack store for assistance.
9
63-973.fm Page 10 Friday, January 7, 2000 7:45 AM
RESETTING THE CLOCK
If the clock stops operating or locks up,
you can reset it.
Press RESET with a pointed object, such
as a straightened paper clip.
RESET
All display segments briefly appear, then
the clock starts scanning for the radio
signal.
10
63-973.fm Page 11 Friday, January 7, 2000 7:45 AM
SPECIFICATIONS
Battery ................................................................................................. 2 AA Batteries
Snooze .............................................................................................. About 8 Minutes
Dimensions (HWD) .............................................................. 95/8 × 87/16 × 115/16 Inches
(247 × 214 × 36 mm)
Weight (without batteries) ............................................................................... 22.5 oz
(640 g)
Specifications are typical; individual units might vary. Specifications are subject to
change and improvement without notice.
11
63-973.fm Page 12 Friday, January 7, 2000 7:45 AM
Limited One-Year Warranty
This product is warranted by RadioShack against manufacturing defects in material and workman-
ship under normal use for one (1) year from the date of purchase from RadioShack company-owned
stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, Ra-
dioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING
THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED
IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED
HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RE-
SPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY
LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFOR-
MANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, IN-
CLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS
OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDEN-
TAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limita-
tion of incidental or consequential damages, so the above limitations or exclusions may not apply to
you.
In the event of a product defect during the warranty period, take the product and the RadioShack
sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, un-
less otherwise provided by law: (a) correct the defect by product repair without charge for parts and
labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase
price. All replaced parts and products, and products on which a refund is made, become the prop-
erty of RadioShack. New or reconditioned parts and products may be used in the performance of
warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the
expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse,
accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or
maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as
fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs
of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
We Service What We Sell
12/99
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
01A00
Printed in Hong Kong
|