Quantum Computer Drive Fireball ST User Guide

Fireball ST  
Mounting Guidelines  
3.5 inch Form Factor Drive Mounting  
Mounting Screw Tap Locations  
The mounting holes on Quantum 3.5-inch form factor hard disk drives allow the drive to be mounted in any  
orientation. The figure provided identifies the location of the three mounting holes found on each side of the drive  
and the four mounting holes found on the PCB side of the drive. Dimensions given are in inches and millimeters.  
Mounting Screw Clearance  
Please note that the printed-circuit board assembly (PCBA) is very close to the mounting holes. For mounting #6-  
32 UNC screws are recommended. Mounting screws should be no longer than 0.25 inches (6.35 mm) and  
maximum torque applied to the screws must not exceed 8 inch-pounds. Clearance from the drive to any other  
surface (except mounting surfaces) must be a minimum of 0.05 inches (1.25 mm).  
1 of 1  
 

Rangemaster Ventilation Hood RM50000 Series User Guide
Reebok Fitness Treadmill RBTL13990 User Guide
Reebok Watch W 113 User Guide
Roland Musical Instrument RD 300SX User Guide
Rosewill Switch RC 407 User Guide
Rotel Stereo Amplifier RB 1552 User Guide
Rowenta Electric Shaver 037116 20 04 RF3210 9210 User Guide
Saitek Switch Hi Speed USB 20 Hub User Guide
Samsung Microwave Oven DE7711 User Guide
Sanyo Flat Panel Television DP32649 User Guide