Pioneer Home Theater System HTZ323DVD User Manual

Setting up your DVD/CD Receiver  
When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.  
Do not use these speakers with any other system or amplifier as this may result in damage or fire.  
Using the remote control  
Additional notes on connecting antennas  
Keep antenna cables away from other cables and the  
display unit and main set.  
To assure optimum reception, pull the FM antenna so that  
it is fully extended and not coiled or hanging at the rear of  
the unit.  
If reception with the supplied antenna is poor, see the  
Other Connections section in the main operating  
instructions for details on connecting outdoor antennas.  
Check that you have all the accessories, then put  
the batteries in the remote control.  
Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.  
The remote control can be used within a range of about 7  
meters from the remote sensor on the front panel, and  
within a 30 degree angle.  
2
1
Precautions:  
The remote control may not work if there is an obstacle  
between the remote control and the display unit, or if the  
remote control is not directed towards the remote sensor  
of the display unit at the correct angle.  
Batteries and  
remote control  
Pull off the protective  
1
shields of both AM antenna  
fig. A  
fig. B  
fig. C  
STANDBY/ON  
wires.  
CD  
FM/AM  
TUNER  
L1/L2  
LINE  
Power cord  
The remote control may not work properly if strong  
DVD  
TV  
FRONT  
SURROUND  
OPEN CLOSE  
Additional notes on speaker placement  
If your listening room is of adequate size, place the  
speakers as shown in step 3 to achieve the optimum  
surround sound effect. If you are listening in a fairly small  
room and a typical surround speaker setup is not possible,  
see Home Theater sound setup of the instruction manual  
and the speaker setup guide for information on the Front  
Surround speaker setup option.  
light such as direct sunlight or fluorescent light is shining  
onto the units remote sensor.  
0
8
3
7
1
4
¡
4
Push open the tabs, then insert  
2
3
4
The remote control may not work properly when this  
DVD MENU  
RETURN  
one wire fully into each terminal.  
TUNE+  
unit is used near devices emitting infrared rays, or when  
remote controls of other devices which use infrared rays  
are used. Also, the use of this remote control may cause  
other devices to work improperly.  
ST–  
ST+  
ENTER  
TUNE–  
MUTE  
SOUND  
6
MASTER  
VOLUME  
Video cord  
Release the tabs to secure the AM  
antenna wires.  
TV CONTROL  
CH  
INPUT  
VOL  
When the operating range of the remote becomes too  
When using the standard speaker setup as shown in step  
3, please observe the following guidelines:  
short, replace the batteries.  
OPEN  
1
Install the main front left and right speakers at an equal  
distance from the TV.  
For optimum effect, install the rear speakers slightly  
above ear level.  
Install the center speaker above or below the TV so that  
Fix the AM loop antenna to the  
attached stand.  
To fix the stand to the antenna, bend in the  
direction indicated by the arrow (fig. A) then  
clip the loop onto the stand (fig. B).  
Remote control battery caution  
Incorrect use of batteries may cause leakage or  
rupture.  
2
4
3
FM antenna  
Always be sure to follow these guidelines:  
FM  
AM  
ANTENNA  
UNBAL 75  
LOOP ANTENNA  
Always insert batteries into the battery compartment  
AM loop antenna  
the sound of the center channel is localized at the TV  
screen.  
correctly matching the positive ª and negative ·  
polarities, as shown by the display inside the  
compartment.  
Note: If you plan to mount the AM antenna  
to a wall or other surface, secure the stand  
with screws (fig. C) before clipping the loop  
to the stand. Make sure the reception is clear.  
Precautions:  
sure to secure it with tape or some other suitable means.  
Otherwise, the speaker may fall from the TV due to  
external shocks such as earthquakes, endangering those  
nearby or damaging the speaker.  
Never mix new and used batteries.  
Batteries of the same size may have different voltages,  
When installing the center speaker on top of the TV, be  
3
1
2
depending on brand. Do not mix different brands of  
batteries.  
When disposing of used batteries, please comply with  
Place the AM antenna on a flat  
surface and point in the direction  
giving the best reception.  
Don’t let it come into contact with metal  
objects and avoid placing near computers,  
television sets or other electrical appliances.  
5
6
Connect the FM wire antenna to the FM UNBAL 75antenna terminal.  
For best results, extend the FM antenna fully and fix to a wall or door  
frame. Dont drape loosely or leave coiled up.  
governmental regulations or environmental public  
instruction's rules that apply in your country or area.  
Do not connect the supplied speakers with any other  
amplifier. This may result in malfunction or fire.  
The front, center and surround speakers supplied  
In order to prevent battery leakage, remove the  
batteries when not using the remote control for an  
extended period (one month or more). If leakage occurs,  
carefully wipe away any battery fluid inside the  
with this system are magnetically shielded. However,  
placing them extremely close to a television may  
result in color distortion on the screen. If this  
happens, move the speakers a little further away and  
switch off the television for 15-30 minutes.  
Note: The signal earth (H) is designed to reduce noise that occurs when an  
antenna is connected. It is not an electrical safety earth.  
compartment, and replace the batteries with new ones.  
Do not allow books or other objects to rest on top of  
the remote control, since the buttons may be depressed,  
causing faster exhaustion of the batteries.  
The subwoofer is not magnetically shielded and so  
should not be placed near a TV or monitor.  
Since it is not magnetically shielded, do not place  
any magnetic storage media (such as floppy disks  
and tape or video cassettes) close to the subwoofer.  
Connect each speaker as shown below.  
Connect each speaker using the color-coded  
speaker cords. Match them to the colored labels  
above the speaker terminals.  
3
Color-coded wire  
(Connect to speaker)  
Connect the DVD/CD receiver to your TV, then connect the  
supplied power cord.  
4
Color-coded connector  
(Connect to rear panel)  
Surround right  
(Grey)  
Surround left  
(Blue)  
Connect one end to a video input on your TV.  
Use the supplied video cord.  
1
Twist and pull off the protective  
shields on each wire.  
1
Connect the other end to the video output of the DVD/CD receiver.  
This player is equipped with copy protection technology. Do not connect this  
player to your TV via a VCR using AV cables, as the picture from this player will not  
appear properly on your TV.  
2
Connect the wires to the  
2
IN  
IN  
OUT  
Connect the power cord to the AC inlet.  
speaker. Match the colored  
wire with the color-coded  
label (above the tabs), then  
insert the colored wire into  
the red (+) tab and the other  
wire with the black (–) tab.  
3
L
CENTER  
6
SURROUND  
6
FR6ONT  
Listening position  
SPEAKERS  
L
L
R
AUDIO  
TV  
LINE 1  
R
R
VIDEO IN  
Subwoofer (Purple)  
6
6
6
SUB  
WOOFER  
Connect the other end to the  
color-coded speaker jacks on  
the rear of the DVD/CD  
receiver (as shown at left).  
Make sure to insert completely.  
3
IN  
IN  
OUT  
1
OPTICAL IN  
AUDIO  
IN  
CE6NTER  
SURROUND  
6
L
FR6ONT  
CONTROL  
SPEAKERS  
L
FM  
LINE  
2
AM  
ANTENNA  
UNBAL 75  
LOOP ANTE
L
R
TV AUDIO LINE  
R
R
AC IN  
6
6
6
Y
B  
R  
VIDEO  
OUT  
VIDEO  
SUB  
WOOFER  
COMPONENT VIDEO OUT  
VIDEO  
OUT  
VIDEO  
Center (Green)  
Front left  
(White)  
Front right  
(Red)  
AC IN  
For the best surround sound, setup your  
speakers as above. The front left and right  
speakers should be about 1.82.7 m apart.  
To AC outlet  
These speaker terminals can be hazardous when live. When you connect or  
disconnect the speaker cables, to prevent the risk of electric shock, do not  
touch uninsulated parts before disconnecting the power cord.  
Congratulations! You're done setting up.  
Printed in  
<XRE3085-A>  
 

Paxar Printer Monarch 9876 User Manual
Peavey Home Theater System 35XO User Manual
Philips CRT Television TP3675 User Manual
Philips DVD Player DVD726v2 User Manual
Philips DVD VCR Combo DVDR3430V 05B User Manual
Philips Indoor Furnishings 232801 User Manual
Philips Indoor Furnishings P 8497 User Manual
Playskool Musical Toy Instrument 8979 User Manual
Polaroid TV DVD Combo 1513 TDXB User Manual
Presonus Audio electronic Music Mixer 1642 User Manual