AVIC X-Series Firmware Update Instructions
INSTRUCTIONS FOR DOWNLOADING FIRMWARE UPDATE
FOR AVIC-X910BT, AVIC-X710BT, AVIC-X9115BT and AVIC-
X7115BT
**After you download the firmware update files onto your computer, you will need to
transfer the files to an SD card (512MB or larger) in order to install them on your
navigation system.
Important
Please print or save these Instructions before downloading and installing the firmware update
-- it is very important that you complete all steps correctly and in the order described below.
Failure to do so could cause data stored onto your navigation system to be permanently lost.
WARNING! This firmware update applies only to models sold in the U.S.
If you have any difficulty carrying out these instructions, please contact the Pioneer Customer
Service Center at 1-800-421-1404. Pioneer service representatives are available Monday
through Friday, 10:00 a.m. to 7:30 p.m. (Eastern Time).
Before Downloading the Firmware Update
Please check your system version number by doing the following to determine whether your
system has already been updated with the new firmware update:
1. Press the "Menu" button
2. Touch the "Settings" tab;
3. Touch the “System Settings” tab;
4. Touch the “Service Information” tab;
5. The "Map version" number and the "Version" number are both displayed -- please look at the
"Version" number, which is displayed on the lower line; and
6. If the "Version" number is "3.010100" or an earlier/smaller number, please install the new
firmware update. If the "Version" number is "3.020100" or a later/larger number, the system
has already been updated with the new firmware.
Downloading the Firmware Update & Transfer to an SD Card
Step 1
1-1. Download the system firmware update Zipfile onto your computer by clicking here. The
location where you save the downloaded Zipfile should be accessible and easily remembered.
1-2. After you have downloaded the Zipfile, locate it on your computer and double click to
decompress it.*
Once the Zipfile is decompressed, locate and open the folder named "X-Series Firmware
Update".
Once the folder "X-Series Firmware Update" has been opened, locate within it the sub-
folders named "LPUE080".
*If you do not have a decompression utility on your computer, you can download WinZip
1-3. Transfer the "LPUE080" folder onto the top layer (folder) of your SD card. **
**You must use a SD card that is 512MB or larger and formatted with a FAT16 or FAT32
file system.
"Boot Up Screen"
Step 5
Turn off your vehicle and turn on again, and wait for your system to boot up.
Confirming that the Firmware Update was Successfully Installed
Step 6
Please follow the steps below to confirm the update process was successful:
6-1. Confirm your System Firmware Version
•
•
•
•
•
Press the "Menu" button
Select the "Settings" tab
Select "System Settings"
Select "Service Information"
Confirm that your system correctly displays the following information:
Version: 3.020100
Your navigation system is now ready for use.
Post-Update procedures
Step 7
7-1. Calibrate the Screen
Press the "Menu" button and touch the "Settings" tab. Select "System Settings", and touch
the "Screen Calibration" button.
Proceed with the guidance shown on the display and tap the screen to align the calibration.
Questions
If you have any questions, please contact the Pioneer Customer Service Center at 1-800-421-
1404. Pioneer service representatives are available Monday through Friday, 10:00 a.m. to
7:30 p.m. (Eastern Time).
|