1 Important
Hearing safety
Listen at a moderate volume.
•
•
•
•
•
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Do not block any ventilation openings.
Install in accordance with the
•
Using headphones at a high volume can
impair your hearing.This product can
produce sounds in decibel ranges that may
cause hearing loss for a normal person,
even for exposure less than a minute.The
higher decibel ranges are offered for those
that may have already experienced some
hearing loss.
manufacturer's instructions.
•
•
Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the apparatus.
Only use attachments/accessories specified
by the manufacturer.
•
Sound can be deceiving. Over time your
hearing 'comfort level' adapts to higher
volumes of sound. So after prolonged
listening, what sounds 'normal' can actually
be loud and harmful to your hearing.To
guard against this, set your volume to a safe
level before your hearing adapts and leave
it there.
•
•
To establish a safe volume level:
Unplug this apparatus during lightning
storms or when unused for long periods
of time.
•
•
Set your volume control at a low setting.
Slowly increase the sound until you can
hear it comfortably and clearly, without
distortion.
•
Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
Listen for reasonable periods of time:
•
Prolonged exposure to sound, even
at normally 'safe' levels, can also cause
hearing loss.
•
Be sure to use your equipment reasonably
and take appropriate breaks.
Be sure to observe the following guidelines
when using your headphones.
•
•
Apparatus shall not be exposed to
dripping or splashing.
Do not place any sources of danger on the
apparatus (e.g. liquid filled objects, lighted
candles).
•
•
•
•
Listen at reasonable volumes for
reasonable periods of time.
Be careful not to adjust the volume as your
hearing adapts.
Do not turn up the volume so high that
you can't hear what's around you.
You should use caution or temporarily
discontinue use in potentially hazardous
situations.
•
Where the plug of the Direct Plug-in
Adaptor is used as the disconnect device,
the disconnect device shall remain readily
operable.
3
EN
Warning
2 Your Docking
Speaker
• Never remove the casing of this apparatus.
• Never lubricate any part of this apparatus.
• Never place this apparatus on other electrical
equipment.
• Keep this apparatus away from direct sunlight, naked
flames or heat.
Congratulations on your purchase, and
welcome to Philips!To fully benefit from the
support that Philips offers, register your product
• Ensure that you always have easy access to the power
cord, plug or adaptor to disconnect the apparatus from
the power.
If you contact Philips, you will be asked for the
model and serial number of this product.The
model number and serial number are on the
bottom of the product.Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Introduction
With this docking speaker, you can
•
enjoy audio from the iPod/iPhone, other
external audio devices, and play audio from
your computer;
•
synchronize the iPod/iPhone with your
computer through USB socket.
Note
• The speaker supports Dock Studio software.
What's in the box
Check and identify the contents of your
package:
•
•
•
•
•
Main unit
1 x AC power adaptor
1 x USB cable
1 x MP3 link cable
Quick start guide
EN
4
3 Get started
Overview of the speaker
Always follow the instructions in this chapter in
sequence.
abcd
Connect AC power
Caution
• Risk of product damage! Make sure that the power
supply voltage matches the voltage printed on the
bottom of the unit.
e
f g
• Risk of electric shock! When you unplug the AC
adaptor, always pull the plug from the socket. Never
pull the cord.
a DC IN
•
Connect AC power.
b
Connect the AC power adaptor to:
•
Headphone jack.
•
the DC IN power socket at the back of
the docking speaker.
c USB
•
Sync with a computer through USB
•
the wall socket.
cable.
•
Play music from your computer.
d MP3-LINK
•
•
Connect an external audio device.
e
Turn the docking speaker on or switch
to standby mode.
f DOCK
•
Dock for iPod/iPhone.
g VOLUME + / -
•
Adjust volume.
Turn on
Press to turn the docking speaker on.
Switch to standby mode
When you press again, or the system is idle
for 15 minutes, the docking speaker switches to
standby mode.
5
EN
3
For first-time use, you will be asked to
install DockStudio app on your iPod/
iPhone.
4 Play
4 Tap [Yes] (yes) to accept the installation
request.
Play from iPod/iPhone
5 Follow the on-screen instructions to
complete the installation.
You can enjoy audio from your iPod/iPhone
through this docking speaker.
Compatible iPod/iPhone
The docking speaker supports the following
iPod,iPhone models:
Made for.
•
iPod touch (1st, 2nd, 3rd, and 4th
generation)
iPod classic
iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th
generation)
iPhone 4S
iPhone 4
6 Launch the app after the installation.
•
•
7 Play audio on your iPod/iPhone.
» Audio comes out through this docking
speaker.
•
•
•
•
•
iPhone 3GS
iPhone 3G
iPhone
Listen to the iPod/iPhone
Philips DockStudio app brings a suite of new
features to your docking speaker.To enjoy more
features, you are recommended to install the
free DockStudio app.
1 Press to turn the docking speaker on.
» The LED indicators light up.
2 Insert the iPod/iPhone into the dock.
Tip
• With the DockStudio app, you can enjoy music, set
clock and alarm, adjust sound settings, and update
firmware if necessary.
EN
6
Charge the iPod/iPhone
When the docking speaker is connected to
AC power, the docked iPod/iPhone begins to
charge.
Play audio from your PC
With this docking speaker, you can enjoy audio
from your PC.
Sync iPod/iPhone with PC
1 Connect the speaker with your computer
Note
with the supplied USB cable.
2 Play audio from your PC.
• Make sure that iTunes has been configured properly in
your PC.
• Due to different materials and product techniques,
some USB cables may not work with this device.
Note
• Make sure that the speaker is correctly connected with
your computer through USB cable.
• Make sure that no iPod/iPhone is docked in the speaker.
1 Insert the iPod/iPhone in the dock.
2 Press to switch to standby mode.
» The LED indicators light off.
3 Connect your docking speaker and PC
with a USB cable.
Play from an external device
4 Launch iTunes to synchronize your docking
speaker with PC.
With this docking speaker, you can also enjoy
audio from an external device such as an MP3
player.
» The docked iPod/iPhone is
synchronized with PC successfully
through the iTunes.
Note
• Make sure that no iPod/iPhone is docked in the speaker.
7
EN
1 Press to turn the docking speaker on.
5 Specifications
2 Connect the MP3 link cable to:
•
•
the MP3-LINK socket at the back of
the docking speaker.
the headphone socket on an external
device.
Amplifier
Rated Output Power 2 X 10 W RMS
» The docking speaker switches to MP3
link mode automatically.
3 Play audio on the device.
General information
AC power supply
Model:AS300-120-
AD250(Philips);
MP3 Link
Input: 100-240V ~,
50/60Hz, 1.1A;
Output: 12.0V 2 5 A
Operation Power
Consumption
Standby Power
Consumption
Max.Load for iPod/
iPhone
15 W
<0.5 W
5V 1 A
Dimensions
- Main Unit
(W x H x D)
528 x 78 x 93mm
Weight
- Main Unit
Listen through headphone
1.1 kg
1.9 kg
- With Packing
Plug a headphone into the socket on the
speaker.
Note
• When iPod/iPhone is docked in the speaker, the
headphone function is not available.
Adjust volume
•
•
Press +/- on your docking speaker ; or
Adjust the volume control of your iPod/
iPhone or external device.
EN
8
6 Troubleshooting 7 Notice
Any changes or modifications made to this
Warning
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site
(www.philips.com/support).When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
This product complies with the radio
interference requirements of the European
Community.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
No power
•
Make sure that the AC power adaptor of
the device is connected properly.
Make sure that there is power at the AC
outlet.
•
No sound or poor sound
•
•
Adjust the volume of your docking speaker.
Adjust the volume of your iPod/iPhone or
external audio device.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC.
No response from the unit
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
•
Disconnect and reconnect the AC power
plug, and then switch on the device again.
Cannot sync with PC
•
Switch the docking speaker to standby
mode.
Try another USB cable.
Install iTunes in PC properly.
•
•
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by a
9
EN
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, and old equipment.
“Made for iPod” and “Made for iPhone”
mean that an electronic accessory has been
designed to connect specifically to iPod or
iPhone respectively, and has been certified by
the developer to meet Apple performance
standards.Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note that
the use of this accessory with iPod or iPhone
may affect wireless performance.
iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.
Note
• The type plate is located on the bottom of the
apparatus.
EN 10
Specifications are subject to change without notice
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
DS6100_10_UM_V1.0
|