8 Troubleshooting 9 Notice
Any changes or modifications made to this
Warning
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support).When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
No power
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
•
•
•
Ensure that the power cord is connected
securely.
Ensure that there is power at the power
supply socket.
Ensure that the batteries are installed
correctly.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
No response from the clock radio
•
Disconnect and reconnect the AC power
plug, then turn on the clock radio again.
Poor radio reception
•
Keep the clock radio away from other
electronic devices to avoid radio
interference.
•
Fully extend and adjust the position of the
FM antenna.
Alarm does not work
Set the clock/alarm correctly.
Your product contains batteries covered by
the European Directive 2006/66/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
•
Clock/alarm setting erased
•
Power has been interrupted or the power
plug has been disconnected.
Reset the clock/alarm.
•
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
EN 12