Phase Technology Speaker HP590i User Manual

Open Ceiling Speaker  
HP590i  
Preliminary Technical Information for System Engineers  
Key Features  
• High-power output (108.5 dB) for longer  
throw and higher SPL requirements.  
• One 133 mm (5.25 in) polypropylene  
woofer and one 25 mm (1.0 in) horn-  
loaded convex aluminum dome tweeter  
mounted to a proprietary cast-alumi-  
num HP5TM baffle & heat sink.  
Mounting hardware included  
Specifications: HP590i  
System Type  
5.25” Coax, open-ceiling, ported (33 Watt transformer for  
25/70.7/100 Volt or voice coil / 8 Ohm direct)  
74 Hz - 22 kHz  
64 Hz - 20 kHz  
160 Watts  
80 Watts  
108.5 dB  
• 89.5 dB Average sensitivity offers  
high output capabilities and reduced  
amplification costs.  
Frequency Response (- 3 dB)1  
Low Frequnecy (-10 dB)1  
Max. Program Power  
• Weatherized components for indoor/out-  
door applications.  
Max. Continuous Power2  
Max. SPL dB @ 1 M  
Sensitivity dB @ 1W/1M3  
Impedance (nominal)  
Coverage Angle (-6 dB @ 500 Hz)  
Coverage Angle (-6 dB @ 4 kHz)  
Directivity Factor (Q)  
89.5 dB  
8 Ohm (nominal value)  
360º (average)  
96º (average)  
6.56 (Averaged 100 Hz - 10 kHz); 9.31 @ 2 kHz  
6.01 dB (Averaged 100 Hz - 10 kHz); 9.69 dB @ 2 kHz  
6-Position rotary switch with voice coil direct (8 Ohm)  
• Includes hanging hardware with  
aircraft cables and integrated Speed-  
ClampTM self-locking wire grip for fast,  
easy & secure installation. Also includes  
Euroblock connector & terminal weather  
boot.  
Directivity Index (DI)  
Tap Selector  
• Easy access 6-position selectable tap  
switch for 25, 70.7 & 100 Volt applica-  
tions with voice coil/8 Ohm direct sim-  
plifies ordering and inventory tracking.  
Transformer Taps  
70.7 V Output  
33 W 104.5 dB  
17 W 102 dB  
9 W 99 dB  
6 W 97.5 dB  
3 W 94.5 dB  
100 V Output  
33 W 104.5 dB  
17 W 102 dB  
9 W 99 dB  
25 V Output  
5 W 96.5 dB  
2.5 W 93.5 dB  
1.3 W 90.5 dB  
0.63 W 87.5 dB  
• High quality black or white paint finish.  
6 W 97.5 dB  
Description  
Transducers  
The HP590i is a high-powered 5.25”  
2-way horn-loaded loudspeaker in a  
ported open-ceiling enclosure design.  
The HP590i incorporates a low-profile  
grille, proprietary HP5TM motor-board  
and 6-position tap switch with voice  
coil/8 Ohm direct. Hanging hardware  
is included and features a fast- action  
SpeedClampTM for easy and secure  
installation.  
Low Frequency Driver  
High Frequency Driver  
Low Frequency Voice Coil  
Crossover Frequency  
1 x 133 mm (5.25 in) Polypropylene cone, butyl rubber surround  
25 mm (1.0 in) Convex aluminum horn-loaded tweeter  
25 mm (1.0 in)  
3 kHz  
Network Type  
Low Pass  
High Pass  
Enclosure Material  
Motor Board  
Grille  
N/A  
12 dB per octave, 2nd order  
Drawn aluminum backcan with ABS baffle  
Cast aluminum  
Iridite-plated steel with powder-coat finish  
4 Pin, 5 mm Euroblock for individual or daisy chain connection  
Black or white  
Inputs  
Colors  
Applications  
Height  
Width (including bracket)  
Weight  
298.3 mm / 11.74 in  
245.9 mm / 9.68 in  
4.3 kG / 9.5 lbs  
10 kG / 22.0 lbs (2 per box)  
Engineered for high-SPL and effective  
low-end response (64 Hz @ - 10 dB), the  
HP590i delivers consistent foreground  
music, sound reinforcement and PA for  
applications requiring longer throw  
or higher volume. For indoor/outdoor  
applications, the HP590i incorporates  
a powder-coated, iridite-plated steel  
grille, polypropylene driver and durable  
enclosure design. The HP590i is ideal for  
open-ceiling music & paging applications  
with high ambient noise levels including  
casinos, warehouses, airports, transporta-  
tion & shipping centers, schools, gyms,  
arenas and stadiums. For additional bass,  
SoundTube’s RS801i subwoofer offers bass  
response to 40 Hz.  
Shipping Weight  
Accessories  
Included  
Hanging hardware, Euroblock connector & terminal  
weather boot  
N/A  
Optional  
Packaging  
2 Per box, can ship as single  
1
2
3
Frequency response is measured in full space and includes a low-frequency peak > + 3 dB.  
Continuous power rating, EIA-426-B test.  
2.83 Volts at a distance of 1 meter.  
SoundTube continually develops new product innovations and improvements. Updates to existing  
products without prior notice are an example of SoundTube’s drive for constant improvement.  
© 2006 SoundTube Entertainment. All rights reserved. PN TS-HP590 REV 03.03.06  
 
Open Ceiling Speaker  
HP590i  
Preliminary Technical Information for System Engineers  
Center (TMC) are analyzed using a vari-  
ety of standard measurement techniques,  
including Measured Length Sequence  
(MLS) and Time Delay Spectrometry  
(TDS). Performance, development and  
data acquisition tools include: Gold Line  
TEF 20, CLIO, LMS, LEAP, and propri-  
etary modeling software. EASE™ data  
are acquired through an automated TEF  
20/Outline/EASE™ interface.  
from 10 – 22 gauge wire. The system shall  
be for indoor & outdoor applications and  
have a weather-resistant terminal booth  
covering all wire connectors.  
Volt input, 1 meter) shall be at least 89.5  
dB. The speaker shall have a nominal  
impedance of 8 Ohms and shall be avail-  
able for 25/70.7/100 Volt modes with  
voice coil/8 Ohm direct. The frequency-  
dividing network shall have a crossover  
frequency of 3 kHz with a slope of 12 dB  
per octave (second order) for the high-  
pass filter. Rated power capacity shall  
be at least 80 Watts continuous power  
(RMS), and conforms to EIA-426-B test-  
ing. Maximum continuous output at 1  
meter shall be 108.5 dB.  
The enclosure shall be constructed of  
injection-molded glass-reinforced ABS.  
The grille shall be constructed of iridite-  
plated, powder-coated steel for lasting  
performance in the elements. Overall  
cabinet dimensions shall be no more than  
298.3 mm (11.74 in) in height by 245.9 mm  
(9.68 in) in diameter. The HP590i shall  
include hanging hardware, Euroblock  
connector and terminal weather boot.  
EASE™ Data – 3-D polar plots.  
SoundTubeSPEC™ – Proprietary  
SoundTube speaker placement software.  
The low-frequency transducer shall  
have a polypropylene cone with butyl  
rubber surround. The high-frequency  
transducer shall be constructed of alu-  
minum material and incorporate a high-  
SPL 90º horn.  
Architectural Specifications  
The system shall be the SoundTube  
HP590i with hanging hardware for both  
low & high impedance applications.  
The loudspeaker shall consist of a  
133 mm (5.25 in) low-frequency trans-  
ducer and a 25 mm (1 in) high-frequency  
transducer with a frequency-dividing net-  
work installed in a ported enclosure. The  
low-frequency voice coil diameter shall be  
25 mm (1 in).  
SoundTube Entertainment  
Installation for the HP590i shall be  
by aircraft cable affixed to the speaker  
chassis via a hook. For seismic & safety  
redundancy, a secondary aircraft cable  
shall be included and shall attach to  
the speaker chassis via a #10 bolt. The  
external wiring input connector shall  
be a 4-pin, 5 mm Euroblock for 8 Ohm  
or distributed systems and shall accept  
6430 North Business Park Loop  
Park City, Utah 84098  
Phone 435.647.9555  
Fax  
435.647.9666  
Performance specifications of a typi-  
cal production unit shall be as follows:  
Useable frequency response shall extend  
from 64 Hz – 22 kHz (-10 dB, no external  
equalization). Measured sensitivity (2.83  
Toll Free 800.647.TUBE  
Polar Plots  
250 Hz  
500 Hz  
1,000 Hz  
125 Hz  
4,000 Hz  
8,000 Hz  
10,000 Hz  
2,000 Hz  
Technical data, EASE plots, SoundTubeSPEC software & product downloads available at www.soundtube.com  
 
Open Ceiling Speaker  
HP590i  
Preliminary Technical Information for System Engineers  
Mechanical Drawings  
298.3 mm  
(11.74 in)  
245.9 mm (9.68 in)  
Included Accessories  
Hanging Hardware: Main & Safety  
Cables w/ SpeedClamp™  
SoundTube’s hanging cable kit incorpo-  
rates hanging & safety cables & Speed-  
Clamp™ self-locking cable clamps for  
an integrated and easy-to-install system.  
Hanging & safety cables are infinitely  
adjustable to 2.74 M (9.0 ft).  
SoundTube Entertainment manufactures a complete line of speakers for:  
Open-Ceiling • In-Ceiling • Surface-Mount • Outdoor • Sound-Focusing  
All SoundTube products are designed and engineered in the USA.  
 

Peavey Music Mixer MMA 8150T User Manual
Philips Clock Radio AJ 3720 00 User Manual
Philips Cordless Telephone Kala 200 User Manual
Philips Network Card SWV3459W 17 User Manual
Philips TV DVD Combo 32MD357B User Manual
Philips Universal Remote SRU 5120 87 User Manual
Phoenix Gold Speaker AudioSource User Manual
Polaris Offroad Vehicle 4X4 International User Manual
Poulan Snow Blower 188047 User Manual
Profile Car Stereo System MP6600 User Manual