Panasonic Headphones KX TGA520C User Manual

5.8 GHz Optional Cordless Handset  
Model No. KX-TGA520C  
Installation Manual  
PLEASE READ BEFORE USE AND SAVE.  
This handset is an accessory cordless handset, for use with Panasonic base units  
KX-TG5200C/KX-TG5202C/KX-TG5230C/KX-TG5240C/KX-FPG391C. This installation  
manual only describes the steps necessary to start up the handset. Please read the base  
unit operating instructions for further details.  
Accessories (included)  
ACharger Unit . . . . . . . . . . . . . . . . . .one ABattery . . . . . . . . . . . . . . . . . . . . . . .one  
AHandset Cover. . . . . . . . . . . . . . . . .one ABelt Clip . . . . . . . . . . . . . . . . . . . . . .one  
Contents  
Installation . . . . . . . . . . . . . . . . . . . . . . . 1 Optional Headset. . . . . . . . . . . . . . . . . 5  
Registration . . . . . . . . . . . . . . . . . . . . . . 3 Important Information/  
Belt Clip . . . . . . . . . . . . . . . . . . . . . . . . . 4  
Safety Instructions . . . . . . . . . . . . . . 6  
Wall Mounting . . . . . . . . . . . . . . . . . . . . 4 Warranty . . . . . . . . . . . . . . . . . . . . . . . 8  
Installation  
Connecting the Charger unit  
Power Outlet  
(AC 120 V, 60 Hz)  
AC Adaptor  
USE ONLY WITH Panasonic AC ADAPTOR KX-TCA1.  
The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel  
warm during use.)  
PQQX14110ZA S0404-0  
– 1 –  
 
Registration  
This cordless handset must be registered to a KX-TG5200C/KX-TG5202C/KX-TG5230C/  
KX-TG5240C/KX-FPG391C base unit. The handset will be assigned the extension number  
at registration. Only one handset can be registered at a time. Charge the battery fully.  
Make sure the base unit and the other handsets are not being used. Have both the  
handset and base unit nearby during registration.  
[-]  
1
PressLOCATOR  
on base unit  
for 3 sec.  
*LOCATOR Button  
Then press OK  
L
BACK  
OK  
To operate “  
”,  
OK  
press the right soft key.  
CHARGE Indicator  
Base unit model shown here is KX-TG5240C.  
* The location of the LOCATOR button varies by base unit model.  
KX-TG5200C/KX-TG5202C: LOCATOR [ ], [ ], [ ], [ ] or [  
]
KX-TG5230C/KX-TG5240C/KX-FPG391C: [LOCATOR/INTERCOM/TRANSFER]  
The handset display shows the instructions as shown on the  
right.  
Press LOCATOR  
on base unit  
for 3 sec.  
Then press OKL  
FRANÇ.  
BACK  
O K  
1 Base unit: Press and hold the *LOCATOR button for 3 seconds.  
The CHARGE indicator flashes. After the CHARGE indicator starts flashing, the rest of  
the procedure must be completed within 1 minute.  
On the KX-FPG391C, “HS REGISTRATION” is displayed.  
2 Handset:  
[-  
]
IN USE  
I
1
HandSsPetPRIVACY  
(1) Press the soft key (  
).  
OK  
Registering  
(2) Wait until a long beep sounds and the display  
shows the new extension number.  
e.g. Extension number 2  
[2  
1
]
IN USE  
I
HandSsPetPR[IV2AC]Y  
Registration is complete.  
Registered  
The registered number “[1]” to “[4]” is shown on the top right of the display.  
You can stop registration by pressing [OFF] on the handset and pressing the *LOCATOR  
button on the base unit.  
If you try to register this handset to the KX-TG6500C base unit, “Wrong handset  
Refer to manual” is displayed. The base units for this handset are mentioned above.  
To cancel the handset registration, please see your base unit Operating Instructions.  
– 3 –  
 
Selecting the display language  
You can select either “English” or “Français” (French) as the display language. The factory  
preset is “English”.  
Press [MENU] N [d] or [B] to select “Initial settingN Soft key (  
) N  
SELECT  
N [d] or [B] to select “Change languageN Soft key (  
) N Soft key (  
)
FRANÇ.  
SELECT  
to select “Français”, or soft key ( ENGLISH ) to select “EnglishN Soft key ( SAUV. ) for  
French, or soft key (  
) for English  
N
[OFF]  
SAVE  
Belt Clip  
You can hang the handset on your belt or pocket using the included belt clip.  
To attach the belt clip  
To remove the belt clip  
While pressing the top of the clip (1),  
pull the right edge in the direction of the  
arrow (2).  
B
A
Wall Mounting  
The charger can be wall mounted. Connect the AC adaptor. Install screws using the wall  
template (see below). Mount the charger (  
A
). Slide it down (  
B), then slide down to the  
right (C  
) until it is secured.  
2.45 cm  
31  
(
")  
32  
A
B
C
Screws  
(not included)  
To Power  
Outlet  
2.45cm  
Wall Template  
(3132")  
– 4 –  
 
Optional Headset  
Connecting an optional headset to the handset allows hands-free phone conversation.  
Please only use a Panasonic KX-TCA86, KX-TCA91 or KX-TCA92 headset.  
Connecting an optional headset  
Open the headset jack cover and insert the headset plug into the headset jack as shown  
below.  
Headset Jack  
Headset sold separately. Model shown here is KX-TCA86.  
– 5 –  
 
Important Information/Safety Instructions  
NOTICE:  
Operation is subject to the following two conditions: (1) this device may not cause  
interference, and (2) this device must accept any interference, including interference that  
may cause undesired operation of the device.  
Privacy of communications may not be ensured when using this telephone.  
Operating near 5.8 GHz electrical appliances may cause interference. Move away from the  
electrical appliances.  
The term IC:before the radio certification number only signifies that Industry Canada  
radio technical specifications were met.  
Take special care to follow the safety suggestions listed below.  
Safety  
1) The unit should be connected to a power supply only of the type described in the  
operating instructions or as marked on the unit.  
2) When left unused for a long period of time, the unit should be unplugged from the  
household AC outlet.  
Installations  
Environment  
1) Do not use this unit near water — for example, near a bathtub, washbowl, sink, etc.  
Damp basements should also be avoided.  
2) The unit should be kept away from heat sources such as radiators, kitchen ranges, etc. It  
also should not be placed in rooms where the temperature is less than 5°C (41°F) or  
greater than 40°C (104°F).  
3) The AC adaptor is used as the main power source. Ensure that the AC outlet is located/  
installed near the unit and is easily accessible.  
Placement  
1) Do not place heavy objects on top of this unit.  
2) Care should be taken so that objects do not fall onto, and liquids are not spilled into, the  
unit. Do not subject this unit to excessive smoke, dust, mechanical vibration or shock.  
3) Place the unit on a flat surface.  
For best performance  
1) If noise prevents the conversation from being understood on the handset, approach the  
base unit to lessen the noise.  
2) The handset should be used at the HIGH volume setting when the reception is poor.  
3) The handset should be fully recharged on the charger when “Recharge battery” is  
displayed and/or “3” flashes on the display.  
4) The handset antenna should not be touched during use because of its high sensitivity.  
5) The maximum calling distance may be shortened when the unit is used in the following  
places: Near obstacles such as hills, tunnels, underground, near metal objects such as  
wire fences, etc.  
– 6 –  
 
Medical  
Consult the manufacturer of any personal medical devices, such as pacemakers or hearing  
aids, to determine if they are adequately shielded from external RF (radio frequency)  
energy. (The unit operates in the frequency range of 5760 MHz to 5840 MHz, and the  
power output level can range from 0.25 watts to 0.5 watts.) Do not use the unit in health  
care facilities if any regulations posted in the area instruct you not to do so. Hospitals or  
health care facilities may be using equipment that could be sensitive to external RF (radio  
frequency) energy.  
A nickel metal hydride battery that is recyclable powers the product you  
have purchased. Please call 1-800-8-BATTERY for information on how to  
recycle this battery.  
WARNING:  
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT  
TO RAIN OR ANY TYPE OF MOISTURE.  
If there is any trouble, disconnect the unit from the telephone line and connect a known  
working phone. If the known working phone operates properly, have your unit repaired by  
one of the specified authorized Panasonic Factory Servicentres. If the known working  
phone does not operate properly, consult your telephone company.  
– 7 –  
 
Panasonic Canada Inc.  
5770 Ambler Drive, Mississauga, Ontario L4W 2T3  
PANASONIC PRODUCT—LIMITED WARRANTY  
Panasonic Canada Inc. warrants this product to be free from defects in material and  
workmanship and agrees to remedy any such defect for a period as stated below from the  
date of original purchase.  
Telephone Accessory/Product  
FRS (Family Radio Service) Product  
—One (1) year, parts and labour  
—One (1) year, parts and labour  
LIMITATIONS AND EXCLUSIONS  
This warranty does not apply to products purchased outside Canada or to any product which  
has been improperly installed, subjected to usage for which the product was not designed,  
misused or abused, damaged during shipping, or which has been altered or repaired in any  
way that affects the reliability or detracts from the performance, nor does it cover any product  
which is used commercially. Dry cell batteries are also excluded from coverage under this  
warranty. Rechargeable batteries are warranted for ninety (90) days from date of original  
purchase.  
This warranty is extended to the original end user purchaser only. A purchase receipt or other  
proof of date of original purchase is required before warranty service is performed.  
THIS EXPRESS, LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,  
EXPRESS OR IMPLIED, EXCLUDING ANY IMPLIED WARRANTIES OF  
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.  
IN NO EVENT WILL PANASONIC CANADA INC. BE LIABLE FOR ANY SPECIAL,  
INDIRECT OR CONSEQUENTIAL DAMAGES.  
In certain instances, some jurisdictions do not allow the exclusion or limitation of incidental or  
consequential damages, or the exclusion of implied warranties, so the above limitations and  
exclusions may not be applicable.  
WARRANTY SERVICE  
For product operation and information assistance, please contact your Dealer or our  
Customer Care Centre at:  
Telephone #: (905) 624-5505 Fax #: (905) 238-2360 Web: www.panasonic.ca  
For product repairs, please contact one of the following:  
Your Dealer who will inform you of an authorized Servicentre nearest you.  
• A Panasonic Factory Servicentre listed below:  
Richmond, British Columbia  
Panasonic Canada Inc.  
12111 Riverside Way  
Richmond, BC V6W 1K8  
Tel: (604) 278-4211  
Calgary, Alberta  
Panasonic Canada Inc.  
6835-8th St. N. E.  
Calgary, AB T2E 7H7  
Tel: (403) 295-3955  
Fax: (403) 274-5493  
Fax: (604) 278-5627  
Mississauga, Ontario  
Panasonic Canada Inc.  
5770 Ambler Dr.  
Mississauga, ON L4W 2T3  
Tel: (905) 624-8447  
Fax: (905) 238-2418  
Lachine, Québec  
Panasonic Canada Inc.  
3075, rue Louis A. Amos  
Lachine, QC H8T 1C4  
Tel: (514) 633-8684  
Fax: (514) 633-8020  
IF YOU SHIP THE PRODUCT TO A SERVICENTRE  
Carefully pack and send prepaid, adequately insured and preferably in the original carton.  
Include details of the defect claimed, and proof of date of original purchase.  
Panasonic Canada Inc.  
5770 Ambler Drive, Mississauga, Ontario L4W 2T3  
© 2004 Panasonic Communications Co., Ltd. All Rights Reserved.  
– 8 –  
 

Miele Clothes Dryer 4580690 User Manual
Miele Washer W931iWPS User Manual
NETGEAR Switch FS 517TS User Manual
NETGEAR Video Gaming Accessories NMS200 User Manual
Oki Home Security System OK NIP10 A420 User Manual
Omron Healthcare Scale HBF 516 User Manual
Panasonic Battery Charger EY0005 User Manual
Panasonic DVD Player CQ D5501U User Manual
Panasonic Universal Remote EUR511156 User Manual
Paradyne Network Card 8355 User Manual