Oregon Scientific Thermometer EMR201 User Manual

Placement of this product on certain types  
of wood may result in damage to its finish for  
which Oregon Scientific will not be responsible.  
Consult the furniture manufacturer’s care  
instructions for information.  
The contents of this manual may not be  
reproduced without the permission of the  
manufacturer.  
Do not dispose old batteries as unsorted  
municipal waste. Collection of such waste  
separately for special treatment is necessary.  
Please note that some units are equipped with  
a battery safety strip. Remove the strip from the  
battery compartment before first use.  
·
·
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment  
and receiver.  
Connect the equipment into an outlet on a circuit  
different from that to which the receiver is  
connected.  
LOCATION  
Indoor temperature  
area  
Outdoor temperature  
area  
MEANING  
Main unit batteries low  
·
·
Sensor batteries low  
Wireless Indoor and  
Outdoor Thermometer  
with LED Ice Alert  
Consult the dealer or an experienced radio / TV  
technician for help.  
REMOTE SENSOR  
To set up the sensor:  
1. Open the battery compartment (see FIG 3).  
2. Select channel 1 then press RESET.  
3. Close the battery door.  
Model: EMR201  
DECLARATION OF CONFORMITY  
USER MANUAL  
The following information is not to be used as  
contact for support or sales. Please call our  
customer service number (listed on our website at  
for this product) for all inquiries instead.  
4. Place the sensor within 30 m (98 ft) of the main  
unit using the table stand or wall mount.  
OVERVIEW  
NOTE The technical specifications for this product  
and the contents of the user manual are subject to  
change without notice.  
FRONT VIEW  
TIP Ideal placements for the sensor would be in any  
location on the exterior of the home at a height of  
not more than 5 ft and which can shield it from direct  
sunlight or wet conditions for an accurate reading.  
We  
Name:  
Address:  
Oregon Scientific, Inc.  
19861 SW 95th Ave.,Tualatin,  
Oregon 97062 USA  
T
E
M
P
SPECIFICATIONS  
OUT  
1
Telephone No.:  
1-800-853-8883  
2
TYPE  
DESCRIPTION  
declare that the product  
MAIN UNIT  
L x W x H  
Product No.:  
EMR201  
T
E M P  
66 x 27.5 x 87.5 mm  
(2.59 x 1.08 x 3.44 in)  
Product Name:  
Wireless Indoor and Outdoor  
Thermometer with LED Ice  
Alert  
IN  
3
4
Weight  
241 g (8.5 oz) without battery  
Manufacturer:  
Address:  
IDT Technology Limited  
Block C, 9/F, Kaiser Estate,  
Phase 1,41 Man Yue St.,  
Hung Hom, Kowloon,  
Hong Kong  
Temperature range -5°C to 50°C (23°F to 122°F)  
 
Resolution  
0.1°C (0.2°F)  
433 MHz  
Signal frequency  
Humidity range  
25% - 95%  
1. Remote sensor reception indicator  
2. Outdoor temperature  
3. Indoor temperature  
is in conformity with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions:  
1) This device may not cause harmful interference.  
2) This device must accept any interference  
received, including interference that may cause  
undesired operation.  
Humidity resolution 1%  
Power 2 x UM-4 (AAA)  
1.5 V batteries  
REMOTE UNIT (THN132N)  
4. Ice alert LED indicator  
NOTE Use alkaline batteries for longer usage and  
consumer grade lithium batteries in temperatures  
below freezing.  
BACK VIEW  
L x W x H  
96 x 50 x 22 mm  
(3.78 x 1.97 x 0.87 in)  
SENSOR DATA TRANSMISSION  
Weight  
62 g (2.22 ounces)  
To search for a sensor:  
Reset the unit.  
Transmission range 30 m (98 ft) unobstructed  
Temperature range -20°C to 60°C (-4°F to 140°F)  
The sensor reception icon in the remote sensor area  
shows the status:  
Power  
1 x UM-3 (AA) 1.5 V batteries  
ICON  
OUT  
DESCRIPTION  
Main unit is searching  
for sensor(s).  
OUT  
1
2
ABOUT OREGON SCIENTIFIC  
C/  
F
ET  
RES  
A channel has been  
found.  
The sensor cannot be  
found.  
OUT  
OUT  
OUT  
OUT  
learn more about Oregon Scientific products. If  
you’re in the US and would like to contact our  
Customer Care department directly, please visit:  
www2.oregonscientific.com/service/support  
OR  
OUT  
TIP The transmission range may vary depending  
on many factors. You may need to experiment with  
various locations to get the best results.  
Call 1-800-853-8883.  
For international inquiries, please visit:  
www2.oregonscientific.com/about/international  
1. °C / °F: Select temperature unit  
2. RESET: Reset unit to default settings  
ICE WARNING  
If the channel 1 sensor falls between 3°C to -2 °C  
(37°F to 28°F), LED indicator will flash, and will stop  
flashing once the temperature is out of this range.  
FCC STATEMENT  
REMOTE SENSOR  
This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions:  
(1) This device may not cause harmful interference,  
and (2) This device must accept any interference  
received, including interference that may cause  
undesired operation.  
2
RESET  
Press RESET to return to the default settings.  
1
WARNING Changes or modifications not expressly  
approved by the party responsible for compliance  
could void the user’s authority to operate the  
equipment.  
4
5
PRECAUTIONS  
3
Do not subject the unit to excessive force,  
shock, dust, temperature or humidity.  
Do not cover the ventilation holes with any items  
such as newspapers, curtains etc.  
Do not immerse the unit in water. If you spill  
liquid over it, dry it immediately with a soft,  
lint-free cloth.  
NOTE This equipment has been tested and found  
to comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable protection  
1. LED status indicator  
2. Wall mount hole  
3. Battery compartment  
4. RESET hole  
against harmful interference in  
installation.  
a
residential  
Do not clean the unit with abrasive or corrosive  
materials.  
Do not tamper with the unit’s internal  
components. This invalidates the warranty.  
Only use fresh batteries. Do not mix new and  
old batteries.  
Images shown in this manual may differ from  
the actual display.  
When disposing of this product, ensure it is  
collected separately for special treatment.  
5. CHANNEL switch  
This equipment generates, uses and can radiate  
radio frequency energy and, if not installed and  
used in accordance with the instructions, may cause  
harmful interference to radio communications.  
However, there is no guarantee that interference  
will not occur in a particular installation. If this  
equipmentdoescauseharmfulinterferencetoradioor  
television reception, which can be determined  
by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one  
or more of the following measures:  
GETTING STARTED  
INSERT BATTERIES  
1. Remove the battery compartment.  
2. Insert the batteries, matching the polarities (see  
FIG 2).  
3. Press RESET after each battery change.  
© 2007 Oregon Scientific. All rights reserved.  
P/N: 086L005000-011  
 

MTD Lawn Mower 111 200 User Manual
Music Hall Portable Multimedia Player Cruise Control 20 User Manual
National TV Converter Box ADC12V170 User Manual
NEC Server Express5800 340Hb R User Manual
Nesco Oven Electric Roaster Oven User Manual
NETGEAR Network Router WNHDE111 5GHz User Manual
NordicTrack Home Gym NTHK22490 User Manual
Olympus Camcorder LS 20M User Manual
Onkyo Stereo System PA MC5500 User Manual
Panasonic Network Card 2SC4691G User Manual