® ™
PostScript 3
emulation Kit
Installation Instructions
PostScript 3 emulation Kit Part Number: 70049601
1. Unpack the cards and remove any
7. Check to make sure that both
cards are fully inserted and
installed correctly.
shipping materials. The
PostScript card is marked PS on
the label. The memory card is
marked 16MB on the label.
8. Replace the access panel:
a. Align the panel tabs at bottom.
2. Turn off the printer, and remove
the power cord and interface
cable.
b. Swing the panel up and in place.
c. Tighten the screw.
NOTE: If you have a network card
installed, remove it temporarily before
installing the PostScript option.
b. Position the card into the
connector.
3. Loosen the access panel screw.
9. Verify Installation
Print a Menu Map:
a. Press the Menu button one or
more times until INFO.MENU
appears on the display.
c. Press down on the card until it
snaps into place and the gold
contacts are fully inserted in
the connector.
b. Press SELECT twice. The
MenuMap prints.
4. Remove the access panel and locate
c. PSE Program version and Total
Memory Size 32 MB appears
in the header, and PRINT PSE
FONT in the Information
Menu. If not, check to be sure
that the cards are installed
correctly.
the PostScript connector (1).
6. Install the memory chip:
Insert the card with the notch
towards the front of the printer.
Press down on the card until it
snaps into place and the gold
contacts are fully inserted in the
connector.
Your printer is factory set to AUTO
EMULATION (AUTO appears on
the printer display). In this setting
the printer will sample data and
automatically switch between
PostScript emulation and the other
emulations. If the printer is not set to
AUTO EMULATION, see the
5. Install the PostScript card:
a. Hold the card (make sure PS is
on the label) so that the notch
(2) is on the bottom right
corner.
User’s Guide for instructions to set
it in the printer Menu.
58369502
Oki Data Americas, Inc., Mt. Laurel, NJ 08054
|