Nortel Networks Network Card EMC User Manual

209823-A  
Installing the EMC Control Clamp  
The EMC Control Clamp must be placed no further than 3.7 cm. (1-1/2 inches)  
from the connector located on the PCMCIA card. The cable must pass through the  
clamp three times to function properly.  
To attach the EMC Control Clamp to the Ethernet cable, follow these procedures:  
1. Open the clamp by placing your thumb  
nail into the side of the clamp that has  
the edge on it. Pull out and lift the top of  
the clamp.  
2. Place the Ethernet cable through the  
center of the clamp. Adjust the cable to  
make sure you are within 3.7 cm (1-1/2  
inches) of the PC card connector.  
3. Holding the cable in the clamp with your  
thumb, wrap the Ethernet cable around  
and through the center of the clamp two  
more times.  
4. Hold the Ethernet cable together in the  
center of the clamp and close the clamp  
until it snaps shut.  
5. Connect the cable to the port on the  
PCMCIA card.  
June 2000  
 

Multi Tech Systems Scanner FF200 User Manual
Napoleon Grills Gas Grill P405 PEDESTAL User Manual
NewAir Air Conditioner AC12000E User Manual
Newcon Optik Telescope DN483 User Manual
Nokia Conference Phone HF 510 User Manual
Onkyo Stereo System S3200 User Manual
Oregon Scientific Thermometer RMR232PHN User Manual
Orion Car Audio Car Amplifier HCCA D1200 HCCA D2400 HCCA D5000 User Manual
Panasonic Digital Camera DMC FS25 User Manual
Panasonic Digital Camera DMC FX01 User Manual