NETGEAR Switch 724TP User Manual

Next, ConnectYourSmartSwitchintheCorrect  
Order  
Now, Configure the Switch with the  
Smartwizard  
)NSTALLATION 'UIDE  
GS700TP (724TP, 748TP) Series Gigabit PoE Smart Switch  
These instructions assume you are using DHCP in your network. If you are using static IP  
addressing in your network, configure the switch IP address before connecting it to your  
network. In the absence of a DHCP server, the switch defaults to 192.168.0.239 for its IP  
address.  
1. Click Start > Programs and run Smartwizard.  
Start Here  
Follow these instructions to set up your smart switch. Before proceeding with the smart  
switch installation, familiarize yourself with the contents of the Resource CD, especially  
the reference manuals on your Resource CD.  
To configure the switch before connecting it to your network:  
1. Set up the PC with an IP address in the 192.168.0.x subnet, and connect the PC to the  
switch. Then, use the Smartwizard Discovery utility to configure the switch.  
2. Connect each PC to an RJ-45 network port on the Switch front panel.  
First, Verify Package Contents  
Use category 5 (Cat5) unshielded twisted-pair (UTP) cable terminated with an RJ-45  
connector to connect.  
NETGEAR Smart Switch  
Rubber footpads for tabletop installation  
Power cord  
Figure 2  
Rack-mount kit for installing the switch in a 19-inch rack  
Installation Guide  
2. Click Discover to find your switch in the network.  
Smart Switch Resource CD with Smartwizard Discovery and Hardware Installation  
Guide. (A link to the online Software User's Manual is on the Resource CD.)  
Warranty/Support Information Card  
Then, Prepare to Install Your Smart Switch  
Prepare a PC with an Ethernet adapter and a CD ROM drive.  
Figure 1  
Next, Install the Smartwizard Discovery  
Utility on a PC  
3. Connect the Smart Switch to your network.  
Figure 3  
4. Power on the switch.  
5. Verify that the PC with the Smartwizard Discovery utility is on the same subnet as the  
The Smartwizard Discovery utility finds the switch and displays its MAC Address, IP  
Address, and model number. If you cannot configure your switch, verify that the  
cable connections are secure, that the IP address configuration of the PC is in the  
same subnet as the switch.  
1. Insert the resource CD into your CD drive.  
switch.  
2. Run the Setup program to install the Smartwizard Discovery. The Installation Wizard  
will guide you through.  
 

Miglia Technology DVR AlchemyTV User Manual
Murray Lawn Mower 309007x8B User Manual
NEC Projector VT460 User Manual
Night Owl Optics Home Security System BJPRO 86 1TB User Manual
Omega TV Converter Box IP710 SERIES User Manual
Omnimount TV Mount CP 4 User Manual
Onkyo Stereo System TA RW255 User Manual
Panasonic All in One Printer KX FLB803HK User Manual
Panasonic Camera Flash DMW FL500 User Manual
ParaBody Home Gym 888101 User Manual