Step 3:
Step 2:
Step 1:
Installation Guide
Plug in, then turn on your modem.
Connect one end of the yellow
Unplug the power
to turn off your modem.
Ethernet cable ( ) to your modem,
and the other end to the Internet port
on your router.
Wait approximately 2 minutes
until your modem turns on.
N900 Wireless Dual Band Gigabit Router
R4500
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
DSL
or Cable
Package Contents
modem to power.
Internet
(not included)
Power On/Off
Ethernet cable
Power On/Off
Modem
Laptop or Desktop
Computer
N900 Wireless Router
Step 5:
Step 6:
Connect your computer
to the router ( ).
Open a browser.
Step 4:
Power adapter
Power cord
If the web page does not
display, close and re-open
the browser, then enter
in the address bar, or
check the “Troubleshooting”
section on the back of
this installation guide.
Connect the power adapter to the
router, then plug it into an outlet.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
N900 Wireless Router
(with stand attached)
2.4
GHz
Wait for the 2.4 GHz LED (
to turn on.
)
Optionally, connect wirelessly by using
the preset wireless security settings
located on the bottom label.
If none of the LEDs turn on, make sure the
Power On/Off button is in the ON position
(pushed in).
|