WN604 IG 26July11.fm Page 1 Tuesday, July 26, 2011 6:00 PM
7. Power socket.
c. Connect the Ethernet cable from the access point to the PC.
d. Securely insert the other end of the
cable into the access point Ethernet
port.
8. Power On/Off.
Installation Guide
9. Ethernet ports.
10. Reset factory defaults.
2. Configure LAN and wireless access.
e. Connect the power adapter from the
access point to an AC power outlet.
NETGEAR® Wireless N150 Access Point WN604
a. Configure the access point Ethernet port for LAN access. Connect to the
the address field.
Note: Connect your access point using only
the power adapter provided with the access
point.
Follow these instructions to set up your WN604 access point. You can also click the
documentation links on the Resource CD or the NETGEAR knowledge base at
link on the user interface to access the Installation Guide for instructions on
advanced configuration options.
A login window displays.
Estimated completion time: 20 minutes.
b. When prompted, enter admin for the
user name and password for the
Tip: Before mounting the access point in a high location, first set up
and test the unit to verify wireless network connectivity.
password, both in lower case letters.
c. The NETGEAR® Wireless N150
Access Point WN604 user interface
displays.
Package Contents
The NETGEAR® Wireless N150 Access Point WN604 contains the following:
d. Select Wireless Settings under the Setup menu on the left navigation pane
and configure your wireless interface for wireless access.
7 8
9
10
•
•
•
•
•
•
Wireless access point
Ethernet cable
1 2 3
4
5 6
e. Under Security, select WEP/WPA Settings and configure the level of data
encryption security for your network.
1. Power (green/amber): The green power LED should be lit. If the Power LED
is not lit, check the connections and check to see if the power outlet is controlled
by a wall switch that is turned off. If the LED is blinking, a firmware upgrade is in
process. If the LED is amber, the access point is performing a self-test.
Power adapter
See the online help or the online reference manual for full instructions.
Vertical stand feet (2)
Installation Guide
Resource CD
f. In the left navigation pane under Setup, select Basic Settings,and
configure the IP settings for your network.
2. WPS (green): The WPS LED blinks green when there is WPS activity
Note: If you change the default sub net of the LAN IP address, you will be
disconnected from the ProSafe Wireless N150 Access Point WN604 user
interface. To reconnect, reconfigure your computer with a static IP address within
the new LAN IP sub net.
3. WLAN (blue): The WLAN LED is on steady when the wireless access point is
running. The LED blinks when there is wireless activity. If the LED is off, the
wireless is turned off.
Set Up the Access Point
1. Connect the access point to your computer:
a. Unpack the box and verify the contents.
Tip: Before you deploy your access point, reserve an IP address
(based on the WN604’s MAC address) on the DHCP server. That way,
you can configure the access point with a static IP address that you can
always use to log in to make future configuration changes.
4. LAN (green/amber): A green LAN LED indicates 100 Mbps speed. An amber
LAN LED indicates 10 Mbps speed. Blinking indicates activity.
b. Prepare a computer with Internet access and an Ethernet adapter. If this
computer is already part of your network, record its TCP/IP configuration
settings. Configure the computer with a static IP address of 192.168.0.210
and subnet mask of 255.255.255.0. See the Reference Manual for more
detailed instructions.
5. Wireless On/Off: Turns the wireless radio on or off.
6. WPS button: Push to automatically configure settings.
|