WEATHER RESISTANT
IN-CEILING LOUDSPEAKER
SYSTEM
1 Mitek Plaza
Winslow, IL 61089
815-367-3000
MUSICA612WRM
OWNER’S MANUAL
800-225-5689
21A7334
THE MUSICA612WRM WEATHER RESISTANT LOUDSPEAKER
OTHER PRODUCTS FROM MUSICA
The MUSICA612WRM is specifically designed for use in areas where moisture
is present, such as bath, sauna, hot tub area, patio, pool side and other exterior
applications. If you are planning an installation of this type, we strongly recom-
mend the MUSICA612WRM Weather Resistant Loudspeaker.
In-Wall Loudspeakers
Home Loudspeakers
MUSICA502W
MUSICA6S
5-1/4” Two-Way In Wall Speaker
6-1/2” Two-Way Home Loudspeaker
Tweeter: 3/4” Dome
Tweeter: 1/2” Polycarbonate
Balanced Dome
Impedance: 8 ohms nominal
LOUDSPEAKER PLACEMENT
Impedance: 8 ohms nominal
Sensitivity: 89dB
MUSICA In-Ceiling Speakers are designed to work within any interior decorating
scheme. They can be installed in virtually any location where flush mounting
is possible. To maximize their sound performance however certain guidelines
should be followed. For the best stereo reproduction the two loudspeakers
should be placed an equal distance from your listening position and separated
so that the angle between them, at the listening position, is between 40 and 60
degrees.
Sensitivity: 84dB
Power Handling: 100W RMS/
200W Peak Music
Frequency Response: 55Hz-20kHz
Power Handling: 45W RMS/
90W Peak Music
Frequency Response: 53Hz-20kHz
Dim’s: 12 3/4”H x 7 1/2”W x 8 1/2”D
Dim’s: 11”H x 7-1/2”W x 2-7/8”D
Mounting Depth: 2-1/2” (63.5mm)
MUSICA6C
6-1/2” Center Channel Loudspeaker
Tweeter: 3/4” Dome
MUSICA602W
6-1/2” Two-Way In Wall Speaker
Impedance: 8 ohms nominal
Sensitivity: 92dB
Tweeter: 1/2” Polycarbonate
Balanced Dome
Impedance: 8 ohms nominal
Power Handling: 100W RMS/
200W Peak Music
Frequency Response: 60Hz-20kHz
Sensitivity: 85dB
Power Handling: 50W RMS/
100W Peak Music
Dim’s: 7 1/2”H x 17 5/8”W x 8”D
Frequency Response: 43Hz-20kHz
Dim’s: 12-1/16”H x 8-5/8”W x 3-3/8”D
Mounting Depth: 3” (76.2mm)
Speaker Selector
MUSICASS6
MUSICA625W
Accommodates up to 6 pair of speak-
ers
6-1/2” Two-Way In Wall Speaker
Tweeter: 1” Soft Dome Swivel
Impedance: 8 ohms nominal
Accessories
Sensitivity: 85dB
Power Handling: 55W RMS/
110W Peak Music
MUSICAVC-50Z
Frequency Response: 43Hz-20kHz
Decora-Style Volume Control
12 Step 50 Watts per channel (RMS)
150 Watts Peak
Dim’s: 12”H x 8-9/16”W x 3-1/4”D
Mounting Depth: 2-7/8” (73.0mm)
TECHNICAL ASSISTANCE
For additional technical assistance you can visit our website at
www.MusicaAtHome.com. Otherwise, our technical service representatives can be
reached by phone: 1-800-225-5689 or by E-mail: [email protected].
STEP 4
Attach loudspeaker wires to speaker terminals, observing correct polarity, and
position speaker frame up into cutout. Be careful not to pinch wires in the pro-
cess.
STEP 1
Using a stud finder (available at low cost at most hardware stores) or other accu-
rate method, locate center point between two joists and mark. Using template
provided, trace hole pattern on surface of ceiling
STEP 5
Carefully tighten the four mounting screws. This will cause the mounting wings to
rotate out behind the mounting surface and secure the speaker in place.
STEP 2
Using a sabre saw, keyhole saw or very sharp utility knife, cut hole in wall, fol-
lowing traced pattern.
STEP 6
After the speaker panel is secured tightly, test for sound. When you are
satisfied the speaker is operational, affix grill. As the grill is designed for
a snug fit, you’ll need to position one edge into slot first, and press or
squeeze around perimeter of grill, while pushing leading edges into grill slot.
STEP 3
Run loudspeaker wires to sound source location. There are several methods you
can use to accomplish wiring, depending on the construction characteristics of the
room or house. You can add a professional touch to your installation by using a
speaker terminal plate at the source location. Leave sufficient amount of wire at
speaker location (8 to 10 inches) to complete connection.
|