Explorer 100 Series – TX716A – POCKET TRANSMITTER - Quick User Guide
Modulation Level
Indicator
Mic Level Control
Audio Input Socket
6-pin LEMO
Antenna Socket
(7) Adjust LEVEL gain control, while the performer speaks at
correct level so that AF Peak LED comes on all the time, then
set gain back by two notches at which AF Peak LED flashes
occasionally.
Battery Status Indicator
(5) Check TX battery status LED, if
RED replace battery with a new one
(4) Switch on TX
(by connecting microphone
cable to 6-pin LEMO socket)
(2) Fit a PP3 9V battery, check
RX battery status LED
Please watch polarity of
battery.
The battery compartment is opened
by pressing the button on the back
of the unit. There is a slot for the 9V
battery to fit into.
Setting Up Procedure:
(1) Connect provided TX antenna
(Screw-on SMA antenna)
(3) Set your TX frequency same
as RX
please note: to change
frequency turn unit on/off
The battery can easily be
released with the aid of the
thumb.
Battery Life approx. 6
hours
(6) Check RX ‘Active’ Received Signal
Strength Indicators – a LED should be
GREEN
(8) NOW YOUR SYSTEM IS READY TO USE.
|