KIT FEATURES
4
Shaft and
DIN unit
provisions
Fig. A
99-7407
INSTALLATION
INSTRUCTIONS
Equalizer
provisions
KIT COMPONENTS
Fig. B
Radio Housing
APPLICATIONS
IF AN EQUALIZER WILL BE INCLUDED: Slide the aftermarket equalizer into the back of the
Radio Housing. Using the hardware included with the equalizer, mount the unit to the kit.
(see Fig. A)
CAR
NISSAN
PAGE
240SX 1989-94........................................................... 1
Maxima 1989-94.........................................................1
Stanza 1987-89...........................................................2
IF AN EQUALIZER WILL NOT BE INCLUDED: Snap the Equalizer Dummy Plate into the
Radio Housing. (see Fig. B)
Faceplate
#1
5
6
A
B
Faceplate
#2
C
D
Equalizer
Dummy Plate
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
TOOLS REQUIRED
D) Tape
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) screws
previouslyremovedinstep#1.
Phillips screwdriver
Cutting tool
Wrench
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 100103
3
|