Metra Electronics Ventilation Hood 95 7868B User Manual

INSTALLATION INSTRUCTIONS FOR PART 95-7868B  
APPLICATIONS  
ACURA  
CL 2001-2003  
TL 1999-2003  
95-7868B  
KIT FEATURES  
• Double DIN Radio Provision  
• Stacked ISO Mount Units Provision  
KIT COMPONENTS  
• A) Double DIN Radio Housing • B) Double DIN Brackets • C) Double DIN Trim Plate  
• D) (2) Phillips Screws  
D
B
A
C
TOOLS REQUIRED:  
• Phillips Screwdriver • Socket Set  
1-800-221-0932  
© COPYRIGHT 2009 METRA ELECTRONICS CORPORATION  
 
95-7868B DASH DISASSEMBLY  
ACURA CL 2001-2003 / TL 1999-2003  
A
Disconnect the negative battery ter-  
minal to prevent an accidental short  
circuit.  
1
2
Unclip and remove wood trim from  
both sides of center console.  
(Figure A)  
3
4
5
Open armrest and remove (2) Phillips  
screws inside and (2) Phillips at front  
edge of rear of console and pull  
rearward. (Figure B)  
Open fuse access and remove (1)  
Phillips screw then unclip and remove  
panel below steering column.  
B
(Figure C)  
Remove (3) Phillips screws per center  
console side panel and unclip and  
remove panels (driver’s side and  
passenger side). (Figure D)  
Continued on page 2.  
C
D
1
 
95-7868B DASH DISASSEMBLY  
ACURA CL 2001-2003 / TL 1999-2003  
E
Unclip and remove seat heater switch  
trim panel to access (2) Phillips  
6
7
8
9
screws and remove screws. (Figure E)  
Unclip bottom of A/C control trim  
panel and pull away (no need to  
completely remove). (Figure F)  
Remove (3) Phillips screws and (1)  
push pin per side of radio to remove  
radio. (Figure G)  
Remove (2) Phillips screws from  
storage pocket assembly above radio  
to separate. (The storage pocket  
F
assembly will have to be attached to  
the radio housing in the kit assembly  
next)  
Continue to kit assembly.  
G
2
 
95-7868B KIT ASSEMBLY  
DOUBLE DIN RADIO PROVISION/  
STACKED ISO MOUNT RADIO PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
1
2
Snap the Double DIN brackets to the  
inside edge of the Double DIN radio  
housing. (Figure A)  
A
Slide the Double DIN head unit or  
stacked ISO head units into the  
bracket/radio housing assembly and  
secure the Double DIN head unit or  
stacked ISO head units to the  
assembly using the screws supplied  
with the radio. (Figure B)  
3
4
Align holes in top of radio housing  
with the guide pins on the bottom of  
the storage pocket assembly and  
secure the pocket assembly to the  
legs with the (2) screws provided.  
(Figure C)  
B
Attach the double DIN trimplate to the  
double DIN radio housing/bracket  
assembly. (Figure C)  
Continue to final assembly.  
C
3
 
95-7868B FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
4
 
95-7868B  
NOTES  
5
 
95-7868B INSTRUCTIONS  
1-800-221-0932  
REV. 03/02/09 © COPYRIGHT 2009 METRA ELECTRONICS CORPORATION INST95-7868B  
 

Krell Industries Stereo Amplifier KAV 250a User Manual
Kyocera Cell Phone S2410 User Manual
Land Pride Brush Cutter RCR1660 User Manual
Land Pride Lawn Mower Z52 User Manual
Lenovo Staple Gun P N 39T5991 User Manual
Leupold Binoculars FX 3 User Manual
Lightolier Indoor Furnishings WES SERIES 2X4 User Manual
Lochinvar Water Heater CF 0401 User Manual
Magnadyne Home Security System M7a User Manual
Martin Audio Portable Speaker AQ15 User Manual