Metra Electronics Car Stereo System 99 8223S User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-8223  
APPLICATIONS  
Toyota Corolla  
2009-10  
99-8223/  
99-8223S  
KIT FEATURES  
• DIN Radio With Pocket Provision  
• ISO Mount Radio with Pocket Provision  
• Painted To Match Factory Dash  
99-8223= BLACK  
99-8223S= SILVER  
KIT COMPONENTS  
• A) Radio Housing • B) Radio Housing Trim Plate • C) Radio Housing Brackets  
•D) ISO Brackets • E) ISO Trim Plate  
A
B
C
Harness & Antenna Connections (sold separately)  
• 70-1761 Toyota Harness 87-up  
E
D
• TYTO-01 Toyota Amp Interface 03-up  
TOOLS REQUIRED:  
Small Flat Blade Screwdriver/ Panel Removal Tool  
• Phillips Screwdriver  
1-800-221-0932  
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION  
 
99-8223 DASH DISASSEMBLY  
Toyota Corolla 2009-10  
A
1
2
Disconnect the negative battery ter-  
minal to prevent an accidental short  
circuit.  
Unclip and remove the (4) side trim  
panels from the right and left side of  
the radio and a/c controls. (Figure A)  
3
4
5
Unclip and remove the a/c vent panel  
above the factory radio.(Figure B)  
Remove (4) 10 MM bolts securing the  
radio. (Figure C)  
B
Remove (4) plastic clips from the  
back of the factory radio. (Retain the  
clips for re-use during kit assembly.)  
Continue to kit assembly.  
C
1
 
99-8223 KIT ASSEMBLY  
DIN RADIO WITH POCKET PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Attach the clips removed from the fac-  
tory radio to the back of the radio  
housing trim plate. (Figure A)  
Slide the Radio Housing Brackets onto  
the sides of the Radio Housing until the  
side clips engage. NOTE: Tabs are  
marked Left and Right. (Figure B)  
3
4
Slide the DIN cage into the Radio  
Housing and secure by bending the  
metal locking tabs outward. (Figure C)  
B
Slide the aftermarket radio into the  
cage until it snaps into place. (Figure D)  
Continue to final assembly.  
D
C
2
 
99-8223 KIT ASSEMBLY  
ISO MOUNT RADIO WITH POCKET PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Attach the clips removed from the fac-  
tory radio to the back of the radio  
housing trim plate. (Figure A)  
Slide the Radio Housing Brackets onto  
the sides of the Radio Housing until the  
side clips engage. NOTE: Tabs are  
marked Left and Right. (Figure B)  
3
Mount the ISO Brackets to the radio  
using the screws supplied with the  
radio. (Figure C)  
4
5
Slide the radio into the radio housing  
until it snaps into place. (Figure D)  
B
Snap the Trim plate onto the front of  
the Radio Housing. (Figure D)  
Continue to final assembly.  
D
C
3
 
99-8223 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble in reverse order of disassembly using the 99-8223 Radio Housing  
Trim Plate in place of the factory radio trim panel.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
4
 
99-8223  
NOTES  
5
 
99-8223 INSTRUCTIONS  
1-800-221-0932  
REV. 04/29/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-8223  
 

La Crosse Technology Weather Radio WS 7014U IT User Manual
Lasko Patio Heater 5775 User Manual
Lenmar Enterprises Digital Camera Camcorder Digital Camera User Manual
Lenovo Server RS210 User Manual
Lifescan Treadmill Pro Series User Manual
Lindy Stereo Receiver 32563 User Manual
Magnadyne Automobile Alarm M6A User Manual
Makita Impact Driver 6932 User Manual
Makita Power Hammer BHR240 User Manual
McCulloch Lawn Mower M7053D User Manual