Metra Electronics Automobile Accessories 99 9223 User Manual

9 9 -9 2 2 3  
VEH IC LE APPLIC ATION S  
Volvo S60 / V70 2001-04  
Housing •  
• DIN Head Unit  
Provision with  
Pocket  
• Phillips screw  
driver  
• T-25 Torx Driver  
Questions?  
Call the Help Line  
(800)253 TECH  
COPYRIGHT© 2002-07 METRA ELECTRONICS CORPORATION  
INST 999223  
rev. 06-18-07  
 
9 9 -9 2 2 3  
9 9 -9 2 2 3  
9 9 -9 2 2 3 Vo lv o S 6 0 / V 7 0  
9 9 -9 2 2 3 Vo lv o S 6 0 / V 7 0  
A
A
1 Disconnect the negative  
battery terminal to  
prevent an accidental  
short circuit.  
A) Strip wire ends back  
1/2"  
B) Twist ends together  
C) Solder  
2 Unsnap gearshift trim  
bezel and slide back.  
D) Tape  
B
See figure A  
3 Remove (2) T-25 Torx  
from climate control  
1
Locate the factory wiring harness in the  
dash. Metra recommends using the  
proper mating adapter and making  
connections as shown. (Isolate and  
individually tape off the ends of any  
unused wires to prevent electrical  
short circuit).  
assembly,  
angle the  
climate control panel  
out, insert fingers  
between the console  
and climate panel  
and pull down at the  
same angle. Remove  
the panel.  
C
See figure A  
2
Re-connect the battery terminal and test  
the unit for proper operation.  
(Some force may be  
required)  
See figure B  
3
Reassemble dash in the reverse order of  
the Dash Disassembly on page 1.  
4 Remove (2) T-25 Torx  
from radio bottom in  
climate control cavity  
to remove radio.  
See figure C  
4
1
 
9 9 -9 2 2 3  
9 9 -9 2 2 3  
9 9 -9 2 2 3 Vo lv o S 6 0 / V 7 0  
1 With a Phillips screwdriver,  
9 9 -9 2 2 3 Vo lv o S 6 0 / V 7 0  
Snap the Radio Housing  
into radio bracket and  
replace rear support  
brackets removed in  
step #1.  
5
A
B
C
E
remove the kit rear support  
bracket.  
See figure A  
See figure E  
Slide the DIN cage into  
the radio opening, secure  
by bending the metal  
locking tabs down.*  
6
After removing radio, with a  
T-25 Torx driver remove (5)  
screws from radio bracket.  
2
F
See figure B  
See figure F  
3
Slide the DIN unit  
(radio) into the cage  
until its secure.  
7
Depress snaps on top and  
bottom of pocket to remove  
from bracket.  
G
See figure C  
See figure G  
4 Slide radio bracket off of  
radio.  
*Note: Also please refer  
to instructions included  
with radio  
D
See figure D  
3
2
 

La Crosse Technology Portable Radio WD 3106UR B User Manual
Lenmar Enterprises Battery Charger R2G02 User Manual
Lenovo Computer Hardware 6393 User Manual
Life Fitness Fitness Electronics Fitness Electronics User Manual
Life Fitness Home Gym SUB User Manual
Link electronic DVR PCR 8200 User Manual
Lochinvar Boiler Electric Hot Water and Steam Boilers User Manual
Maytag Dishwasher MDB8859AWB2 User Manual
Maytag Refrigerator MFI2269VEM User Manual
Mercury Home Security System SR 10K User Manual