INSTALLATION INSTRUCTIONS FOR PART 99-8208
Applications
TOYOTA Sienna
2004-2010
99-8208
KIT FEATURES
• DIN Head Unit Provisions with Pocket
• ISO DIN Head Unit Provision with Pocket
KIT COMPONENTS
A) Radio Housing
•
B) ISO Brackets
•
C) Trim Plate
B
C
A
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• 70-1761 - Toyota harness 1987-up
• TYTO-01 - Toyota amp interface harness 2003-up
Antenna Adapter:
• Not required
TOOLS REQUIRED:
Small Flat Blade Screwdriver • Socket Wrench
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
99-8208
2004-2010 TOYOTA SIENNA
Disconnect the negative battery terminal
to prevent an accidental short circuit.
1
A
Unclip and remove panels from left and
right side of radio. Figure A
2
3
4
Unclip and remove panel or speaker cover
above radio. Figure B
B
Remove (4) 10MM bolts from radio to
remove. Figure C
C
1
99-8208
DIN Head Unit Provision with Pocket
Slide the DIN cage into the Radio
Housing and secure by bending
the metal locking tabs down.
1
Slide the after-market head unit
into the cage until secure.
2
2
99-8208
ISO DIN HEAD UNIT PROVISIONS
Mount the ISO Brackets to the head
unit with the screw supplied with
the unit.
1
Slide the head unit into the radio
opening until the side clips engage.
2
3
Snap the trim plate into the radio Housing.
3
99-8208
A
B
A)
B)
C)
D)
Strip wire ends back 1/2"
Twist ends together
Solder
C
D
Tape
Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter and making the connections as
shown. (Isolate and individually tape off the
ends of any unused wires to prevent electrical
short circuit)
1
2
3
Re-connect the negative battery terminal and test
the unit for proper operation.
Reassemble in reverse order of disassembly.
4
99-8208
5
INST99-8208
1-800-221-0932
REV. 04-27-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
INST99-8208
|