V I S I O N G L A S S K E T T L E
complies with
INTERNATIONAL
Model:
2 2 4 0 0
IEC60335
1 8 5 0 -
2200W
SAFETY SPECIFICATIONS
PLEASE READ ALL INSTRUCTIONS BEFORE USE
2 y e a r g u a r a n t e e
22400_IM.indd
1
2012/05/24 11:21:06 AM
11. Do not expose the appliance to
rain or moisture and do not operate
the appliance outdoors or with wet
hands.
will reach boiling point after ap-
proximately 5 minutes and will then
switch off automatically.
12. Use only clean cold water.
13. The appliance operates at very high Operation:
temperatures and there is a danger
of scalding from escaping water or
steam. Do not touch any part of the
kettle except the handle (when the
appliance is in use) and ensure that
the lid has been closed properly.
This appliance is designed for heat-
ing up of water only. Never put any
other liquid into the kettle.
(Please refer to Figure 1)
1. Place the cordless base (7) on a firm
and level surface.
2. Pour the desired amount of clean
water into the kettle (4). Do not touch
any part of the kettle except the
handle while the appliance is in use.
Ensure that the lid (1) is properly
closed. The amount of water can be
measured by the level mark on the
outside of the kettle. Always pay at-
tention to the minimum and maxi-
mum levels and ensure that the lid
(1) is properly and firmly closed.
14. The appliance must be positioned
so that the plug is accessible.
15. If the kettle is overfilled, boiling wa-
ter may be ejected.
16. WARNING – Do not open the lid
while the water is boiling.
17. The kettle is only to be used with the 3. Position the kettle in such a way on
base provided.
the sub base (6) so that the under-
side of the kettle fits precisely into
the contact on the base. Insert the
plug into a wall socket.
18. CAUTION – Ensure that the kettle is
switched off before removing it from
its base.
19. This appliance is intended to be
used in households or other similar
environments such as:
• Staff kitchen areas in shops, offices
and other working environments
• By clients in hotels, motels and
other residential type environments
• Farm houses
4. Put the on/off switch (3) to the ‘1’
position to start the boiling process.
The indicator lamp will light up.
5. As soon as the water reaches boiling
point, the on/off switch (3) will return
automatically to the “0” position. The
indicator lamp will go out. The kettle
can also be switched off manually by
putting the on/off switch to the “0”
position.
• Bed and breakfast type environ-
ments
6. The hot water may now be poured
safely through the spout.
Operating guidelines for first use:
7. This kettle is equipped with a safety
cut–out feature to protect the appli-
ance from damage in case of inap-
propriate use. Should the appliance
be accidentally switched on without
water or if all the water has evaporat-
ed, the safety cut out will automati-
1. Prior to initial use, clean the ap-
pliance by going through several
boiling cycles, using clean water
with each cycle and filling the kettle
(4) to its upper marking. The water
22400_IM.indd
3
2012/05/24 11:21:06 AM
cally switch off the heating element.
8. If point (7) occurs remove the plug
from the wall socket immediately
and refill the kettle after an adequate
cooling down period, about 15 to 20
seconds.
use a slightly damp, lint–free cloth.
4. It is advisable to remove lime depos-
its from the kettle at regular intervals.
Specifications:
Supply voltage: 220-240V~ 50Hz
Power consumption: 1850-2200W
Volume: 1.7L
Warning:
1. DO NOT SUBMERSE IN WATER.
2. Only use the base provided with this
kettle.
3. If the supply cord is damaged it must
be replaced by the manufacturer
or its service agent or a similarly
qualified person in order to avoid a
hazard.
Descaling:
1. Should the appliance switch off
before reaching boiling point this is a
sign that descaling is necessary.
2. A regular descaling agent may be
used. Ensure that the instructions for
use are adhered to. In order to avoid
spillage do not fill the kettle up to
the max mark as the descaling agent
may cause the water to foam.
3. To clean the kettle thoroughly of any
decalcification residues, boil the
kettle several times using clean wa-
ter with each cycle. Rinse the kettle
with clean water afterwards.
Cleaning and care:
1. Before cleaning the appliance, en-
sure that it is disconnected from the
power supply and has cooled down
completely.
2. Do not use abrasives or harsh clean-
ing solutions.
3. Do not immerse the base or the ket-
tle in any liquid. To clean the exterior
22400_IM.indd
4
2012/05/24 11:21:06 AM
22400_IM.indd
5
2012/05/24 11:21:06 AM
|