®
Model: HW-302
Art. No.: 745-175
purposes.
20. To protect against fire, do not operate in the presence of explosive and/ or flammable
fumes.
21. A kettle should not be left connected to a wall socket when the room temperature is
likely to fall to outdoor winter temperatures. At sub-zero temperatures the automatic
control thermostat may reset to boil energize the element.
22. Do not use the kettle for any purpose other than heating water. Other liquids or food
will contaminate the interior.
23. This product has not been designed for any other uses than those specified in this
booklet.
PRODUCT DESCRIPTION:
A
C
D
A. Spout
B. Lid
C. Control lamp
D. On/Off button
E. Contact
F. Base with cord rewind
C
F
E
Download from Www.Somanuals.co3m. All Manuals Search And Download.
INSTRUCTIONS FOR USE:
1. Before first use, fill the kettle with clean water to maximum capacity and boil. Discard
the water and repeat.
2. The kettle should always be unplugged when filling or adding water.
3. Fill the kettle with water to the desired level. Do not overfill or there will be a risk of
spillage or spitting. The water level indicator will assist you to measure correct
amount. You can fill the kettle via the spout or after opening the lid. Do not forget to
close the lid after filling otherwise the kettle will not automatically switch off after use.
4. Do not fill with less that 0,35 litre of water.
5. Do not fill with more than 1,7 litres of water.
6. An automatic safety cut-out has been fitted for protection against overheating. It will
operate if the kettle is switched on when containing insufficient water.
7. If the automatic safety cut-out has operated, switch the kettle off, disconnect from
the power outlet and allow the kettle to cool down for 5- 10 minutes. Then refill with
water and switch on - the kettle wills then boil and cut off as in normal operation.
8. The kettle may be switched off at any time by either pushing the switch of the kettle
to the "up" position or by switching the power off at the power outlet.
9. To pour water, lift the kettle from the power base and pour.
CORDLESS KETTLE:
1. Place the power base on a dry, flat surface.
2. Place the kettle on the power base. The electrical connections will be made
automatically as the kettle slides onto the power base.
3. Plug the cord into an earthed power socket and switch on by depressing the switch
of the kettle to the "down" position.
4. When the water has boiled, the kettle will switch off automatically. After allowing the
kettle to cool down for 15-20 seconds, the water can be brought back to the boil by
pushing the switch back to the "down" position. During the cooling down time do not
force the on/off switch into the "down" ("I") position as this can damage the operating
mechanism.
5. Do not remove the kettle from the power-base without first switching off.
6. Remember, if you do not wish to re-boil the kettle, turn it off at power point.
7. The kettle may be switched off at any time by either pushing the switch of the kettle
to the "0" position or by switching the power off at the power outlet.
8. To pour water, lift the kettle from the power base and pour.
Download from Www.Somanuals.co4m. All Manuals Search And Download.
HOW TO CARE FOR YOUR KETTLE:
Wipe the exterior of the kettle with a soft, damp cloth or sponge. Remove stubborn spots
with a cloth moistened with mild liquid detergent. Do not use abrasive scouring pads or
powders. Never immerse the kettle in water or other liquids.
Since this kettle has concealed heating element, is it important to keep the bottom clean,
between the decalcification you may use a washing-up brush or sponge.
From time to time, dependent on the nature of your water supply, a limescale deposit is
naturally formed and can be found mostly adhered to the heating element and reduce the
heating capacity.
The amount of limescale deposited (and subsequently the need to clean or descale)
largely depends on the water hardness in your area and the frequency with which the
kettle is used.
Limescale is not harmful to your health. But if poured into your beverage it can give a
powdery taste to your drink. Therefore, the kettle should be descale periodically as
indicated below:
DESCALING:
Descale the kettle regularly. With normal use: at least twice a year.
1. Fill the kettle up to the "MAX" with a mixture of one part acetic acid and two parts
water. Switch on and wait for the appliance to switch off automatically.
2. Let the mixture remain inside the kettle overnight.
3. Throw the mixture away the next morning.
4. Fill the kettle with clean water up to "MAX" and boil again.
5. Throw away this boiled water to remove any remaining scale and vinegar.
6. Rinse the inside of the kettle with clean water.
ENVIRONMENTAL TIP
An electronic appliance should, when it is no longer capable of functioning be disposed
with least possible environmental damage. The appliance should be disposed according
to the local regulations in your municipality, in most cases you can discharge the appliance
at your local recycling center.
Download from Www.Somanuals.co5m. All Manuals Search And Download.
THE WARRENTY DO NOT COVER
-
-
If the above points have not been observed.
If the appliance has not been properly maintained, if force has been used against it or
if it has been damaged in any other way.
-
-
Errors of faults owing to defects in the distribution system.
If the appliance has been repaired or modified or changed in any way or by any
person not properly authorised.
Owing to our constant development of our products on both functionality and design we
reserve the right to change the product without preceding notice.
IMPORTER
Elof Hansson A/S
Download from Www.Somanuals.co6m. All Manuals Search And Download.
|