Manitowoc SN12/SN20 Model Nugget Ice Machines
Cutter Head Replacement Instructions
1. Disconnect water supply.
2. Remove front panel.
3. Move toggle switch to CLEAN position after the 5 minute delay expires. The evaporator and float
chamber will drain.
4. Disconnect power at electrical disconnect.
WARNING
Disconnect power to the ice machine at the electrical disconnect, moving
the toggle switch to the off position will not disconnect line voltage.
5. Remove top, left and right side panels.
6. Remove ice chute assembly.
NOTE; if the ice wiper can not be hand removed; place the handle end of a screwdriver against the ice
wiper, then tap the screwdriver (counterclockwise) with a hammer to loosen the ice wiper from the
auger.
REMOVE COVER
REMOVE ICE DAMPER
REMOVE STRAINER
REMOVE ICE WIPER
REMOVE ICE CHUTE
LOOSEN HOSE CLAMP AND
DISCONNECT DRAIN LINE
Manitowoc Foodservice
2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879
Web Site - www.manitowocice.com
000004021
Sheet 1 of 2
08/25/08
|